Beatriz Zapico-Blanco
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Beatriz Zapico-Blanco has a total of 56 co-authors. Here are the top co-authors by number of shared publications:
- José Daniel Rodríguez-Mariscal
Universidad de Sevilla
5 shared publications - Mario Solís
Universidad de Sevilla
5 shared publications - Antonio Morales-Esteban
University of Seville
4 shared publications - Maria-Victoria Requena-Garcia-Cruz
University of Seville
4 shared publications - Francisco Javier Molina
European Commission Joint Research Centre Ispra, Ispra, Lombardy, Italy
3 shared publications - Marta García Diéguez
Universidad de Oviedo
3 shared publications
Latest Publications
- 13 October 2026
- Published by Springer Nature
- p. 337-346
Applicability of the DBV-Masonry Seismic Method to Mid-20th-Century Spanish Social Housing
- 13 October 2026
- Published by Springer Nature
- p. 337-346
Applicability of the DBV-Masonry Seismic Method to Mid-20th-Century Spanish Social Housing
- 15 March 2026
- Published by Springer Nature
- p. 680-693
In-Situ Characterisation of the Gran Portico of Medina Azahara
- 15 March 2026
- Published by Springer Nature
- p. 680-693
In-Situ Characterisation of the Gran Portico of Medina Azahara
- 2 January 2026
- Published by Springer Nature
- p. 509-518
Seismic Vulnerability of a ‘60 s Representative Social Housing Type in Málaga, Spain
- 2 January 2026
- Published by Springer Nature
- p. 509-518
Seismic Vulnerability of a ‘60 s Representative Social Housing Type in Málaga, Spain
- Open Access
Ultrasonic Evaluation of Mechanical Properties in Heritage Buildings Constructed with Córdoba Freestone
This study characterises the natural stone used in the Great Mosque of Córdoba (Spain) and establishes correlations to enable non-destructive, in situ assessment of the mechanical strength of the material. Quarry ashlars of the same biocalcarenite were tested to determine bulk density, ultrasonic wave propagation velocity (UWPV), and mechanical properties from uniaxial compression, splitting tension, and three-point bending tests (over 100 specimens). The stone showed no significant anisotropy or specimen size effects within the investigated ranges. Reference mechanical values were obtained, with a mean uniaxial compressive strength of about 6 MPa. A strong linear correlation was found between UWPV and compressive strength (R2 ≈ 0.86), supporting the use of ultrasonic testing to estimate compressive strength on site. In addition, flexural strength can be also estimated since it correlated strongly with compressive strength (R2 ≈ 0.95); in contrast, the correlation with tensile strength was moderate (R2 ≈ 0.31). The results provide validated relationships for Córdoba freestone that improve the reliability of ultrasonic tests for providing valuable information for structural analysis, maintenance, and conservation strategies for heritage buildings constructed with this kind of stone. The proposed approach offers a practical pathway for damage-free evaluation of mechanical performance in historical masonry.
Open AccessUltrasonic Evaluation of Mechanical Properties in Heritage Buildings Constructed with Córdoba Freestone
This study characterises the natural stone used in the Great Mosque of Córdoba (Spain) and establishes correlations to enable non-destructive, in situ assessment of the mechanical strength of the material. Quarry ashlars of the same biocalcarenite were tested to determine bulk density, ultrasonic wave propagation velocity (UWPV), and mechanical properties from uniaxial compression, splitting tension, and three-point bending tests (over 100 specimens). The stone showed no significant anisotropy or specimen size effects within the investigated ranges. Reference mechanical values were obtained, with a mean uniaxial compressive strength of about 6 MPa. A strong linear correlation was found between UWPV and compressive strength (R2 ≈ 0.86), supporting the use of ultrasonic testing to estimate compressive strength on site. In addition, flexural strength can be also estimated since it correlated strongly with compressive strength (R2 ≈ 0.95); in contrast, the correlation with tensile strength was moderate (R2 ≈ 0.31). The results provide validated relationships for Córdoba freestone that improve the reliability of ultrasonic tests for providing valuable information for structural analysis, maintenance, and conservation strategies for heritage buildings constructed with this kind of stone. The proposed approach offers a practical pathway for damage-free evaluation of mechanical performance in historical masonry.
- 1 October 2025
- Published by Springer Nature
- p. 35-45
Experimental Calibrated Model of a Walking Human on the UniOvi Footbridge
- 1 October 2025
- Published by Springer Nature
- p. 35-45
Experimental Calibrated Model of a Walking Human on the UniOvi Footbridge
- Open Access
- 8 September 2025
- Published by MDPI AG in Preprints.org
Ultrasonic Evaluation of Mechanical Properties in Heritage Buildings Constructed with Cordoba Freestone
A fundamental physical and mechanical characterization was performed on the natural stone utilized in the Mosque of Cordoba, Spain, using samples from the designated restoration quarry. The experimental investigation encompassed density measurements, Ultrasonic Wave Propagation Velocity (UWPV), uniaxial compression, indirect tension (splitting), and three-point bending tests on over 100 specimens. The study confirmed the stone’s isotropic nature and lack of significant sample size effect within the tested range. Key quantitative results include a mean uniaxial compressive strength of approximately 6 MPa and the establishment of predictive relationships. A strong linear correlation (R2=0.86) between UWPV and compressive strength was identified, supporting the use of Ultrasonic Test for in-situ evaluation. Compressive strength was also strongly correlated with flexural strength (R2=0.95), whereas its correlation with tensile strength was moderate (R2=0.31). This research delivers crucial reference values and validated correlations for the stone, directly informing structural analysis and conservation strategies for this UNESCO World Heritage site.
- 8 September 2025
- Published by MDPI AG in Preprints.org
Open AccessUltrasonic Evaluation of Mechanical Properties in Heritage Buildings Constructed with Cordoba Freestone
A fundamental physical and mechanical characterization was performed on the natural stone utilized in the Mosque of Cordoba, Spain, using samples from the designated restoration quarry. The experimental investigation encompassed density measurements, Ultrasonic Wave Propagation Velocity (UWPV), uniaxial compression, indirect tension (splitting), and three-point bending tests on over 100 specimens. The study confirmed the stone’s isotropic nature and lack of significant sample size effect within the tested range. Key quantitative results include a mean uniaxial compressive strength of approximately 6 MPa and the establishment of predictive relationships. A strong linear correlation (R2=0.86) between UWPV and compressive strength was identified, supporting the use of Ultrasonic Test for in-situ evaluation. Compressive strength was also strongly correlated with flexural strength (R2=0.95), whereas its correlation with tensile strength was moderate (R2=0.31). This research delivers crucial reference values and validated correlations for the stone, directly informing structural analysis and conservation strategies for this UNESCO World Heritage site.
- Open Access
- 30 July 2025
- Published by Springer Nature in Bulletin of Earthquake Engineering
- Vol. 23 (13) , 5429-5467
Enhanced macroseismic method for the vulnerability assessment of representative ’50–70s social housing units
This study proposes an enhanced macroseismic method, based on RISK-UE LM1 Vulnerability Index model, for assessing the vulnerability of social housing buildings constructed between 1950 and 1975, which typically lack seismic provisions, feature repetitive architectural designs, and have either exceeded or are about to exceed their design working life. Initially, a comprehensive review of existing literature was conducted to identify relevant vulnerability parameters for calculating the Vulnerability Index. Huelva, located in southern Spain, was chosen as a pilot city due to the representativeness of its buildings and the availability of original project documents. Analysing these documents, along with microzonation studies and on-site visual inspections, facilitated an understanding of the structural types (primarily reinforced concrete moment-resistant frames or unreinforced masonry walls) and the further analysis of the selected vulnerability parameters. The new method improves upon the original by incorporating several enhancements, like integrating the number of floors into the Type of Soil Modifier, creating a Combined Modifier that amalgamates parameters based on the construction year, defining the Vertical Irregularity Modifier based on the building’s compactness ratio, and introducing a Slope of the Ground Modifier. Additionally, it considers pounding effects solely for staggered floor slabs and features adapted modifier weights for the specific building types. To address potential overestimation caused by summing multiple modifiers, the method employs a modified square root of the sum of squares (SRSS) approach, which provides a more robust estimation of their combined impact. The method was applied to buildings in Huelva using deterministic (recurrence of the 1755 Lisbon earthquake) and probabilistic (code, intensity VII) scenarios. Results reveal expected damage levels contradicting the damage control philosophy, indicating the need for preventing interventions and further research on similar structures.
- 30 July 2025
- Published by Springer Nature in Bulletin of Earthquake Engineering
- Vol. 23 (13) , 5429-5467
Open AccessEnhanced macroseismic method for the vulnerability assessment of representative ’50–70s social housing units
This study proposes an enhanced macroseismic method, based on RISK-UE LM1 Vulnerability Index model, for assessing the vulnerability of social housing buildings constructed between 1950 and 1975, which typically lack seismic provisions, feature repetitive architectural designs, and have either exceeded or are about to exceed their design working life. Initially, a comprehensive review of existing literature was conducted to identify relevant vulnerability parameters for calculating the Vulnerability Index. Huelva, located in southern Spain, was chosen as a pilot city due to the representativeness of its buildings and the availability of original project documents. Analysing these documents, along with microzonation studies and on-site visual inspections, facilitated an understanding of the structural types (primarily reinforced concrete moment-resistant frames or unreinforced masonry walls) and the further analysis of the selected vulnerability parameters. The new method improves upon the original by incorporating several enhancements, like integrating the number of floors into the Type of Soil Modifier, creating a Combined Modifier that amalgamates parameters based on the construction year, defining the Vertical Irregularity Modifier based on the building’s compactness ratio, and introducing a Slope of the Ground Modifier. Additionally, it considers pounding effects solely for staggered floor slabs and features adapted modifier weights for the specific building types. To address potential overestimation caused by summing multiple modifiers, the method employs a modified square root of the sum of squares (SRSS) approach, which provides a more robust estimation of their combined impact. The method was applied to buildings in Huelva using deterministic (recurrence of the 1755 Lisbon earthquake) and probabilistic (code, intensity VII) scenarios. Results reveal expected damage levels contradicting the damage control philosophy, indicating the need for preventing interventions and further research on similar structures.
- 7 February 2025
- Published by Taylor & Francis in Journal of Earthquake Engineering
- Vol. 29 (5) , 1145-1164
Improvement of the Pseudo-Dynamic Testing Method for Buildings that are Seismically Protected by Means of Dissipative Devices
- 7 February 2025
- Published by Taylor & Francis in Journal of Earthquake Engineering
- Vol. 29 (5) , 1145-1164
Improvement of the Pseudo-Dynamic Testing Method for Buildings that are Seismically Protected by Means of Dissipative Devices
- Open Access
- 1 January 2025
- Published by American Society of Civil Engineers (ASCE) in Journal of Bridge Engineering
- Vol. 30 (1) , 04024102
Bespoke Footbridge for Studying Pedestrian–Structure Interaction with Vertical Vibration
Progress in quantifying and codifying pedestrian–structure interaction with a vertical structural vibration and the effects on both human beings and structures has been slow, primarily owin...
- 1 January 2025
- Published by American Society of Civil Engineers (ASCE) in Journal of Bridge Engineering
- Vol. 30 (1) , 04024102
Open AccessBespoke Footbridge for Studying Pedestrian–Structure Interaction with Vertical Vibration
Progress in quantifying and codifying pedestrian–structure interaction with a vertical structural vibration and the effects on both human beings and structures has been slow, primarily owin...