Xavier Maynard
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Xavier Maynard has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Sebastien Carcouet
CEA, LETI, Université Grenoble Alpes, F-38000 Grenoble, France
2 shared publications - Yves Lembeye
G2Elab, Grenoble INP, CNRS, University Grenoble Alpes, F-38000 Grenoble, France
2 shared publications - David Frey
G2Elab, Grenoble INP, Université de Grenoble Alpes, CNRS, 38000 Grenoble, France
1 shared publication - David Frey
Universite Grenoble Alpes, 27015 Saint-Martin-d'Heres, Rhone-Alpes France
1 shared publication - Ghislain Despesse
CEA-LETI, Grenoble, France
1 shared publication - Jia Zhuang
Department of Electrical Engineering, Stanford University, Stanford, CA, USA
1 shared publication
Latest Publications
- Open Access
Modeling and Control of a Hybrid-Fed Triple-Active Bridge Converter
In general, the structures of Multi-Active Bridge (MAB) converters that can be found in the literature are usually based on voltage converters. However, in some cases, it could be interesting to have a current-fed input due to load characteristics or operation constraints. This leads to a hybrid MAB structure mixing both current-fed and voltage-fed bridges. In this paper, a new hybrid-fed, fully coupled Triple-Active Bridge (TAB) converter topology with two voltage-fed ports and one current-fed port is studied, modelled and controlled. In the first place, a generalized average model (GAM) is developed for this system. After that, a reduced-order model is elaborated in order to simplify the behavioral study and control of this coupled system. A control strategy was also proposed in this paper, based on the developed mathematical model. Simulation results using Matlab/Simulink are presented to validate this study.
Open AccessModeling and Control of a Hybrid-Fed Triple-Active Bridge Converter
In general, the structures of Multi-Active Bridge (MAB) converters that can be found in the literature are usually based on voltage converters. However, in some cases, it could be interesting to have a current-fed input due to load characteristics or operation constraints. This leads to a hybrid MAB structure mixing both current-fed and voltage-fed bridges. In this paper, a new hybrid-fed, fully coupled Triple-Active Bridge (TAB) converter topology with two voltage-fed ports and one current-fed port is studied, modelled and controlled. In the first place, a generalized average model (GAM) is developed for this system. After that, a reduced-order model is elaborated in order to simplify the behavioral study and control of this coupled system. A control strategy was also proposed in this paper, based on the developed mathematical model. Simulation results using Matlab/Simulink are presented to validate this study.
- Open Access
- 1 December 2022
- Published by MDPI AG in Electronics
- Vol. 11 (23) , 3983
Comparison between Piezoelectric Filter and Passive LC Filter in a Class L−Piezo Inverter
This paper presents a comparison between piezoelectric filtering and passive LC filtering integrated into an HF class L−Piezo inverter. This L−Piezo inverter is a variant of class φ2 where the filtering of the second harmonic is carried out by a piezoelectric resonator. Piezoelectric filters are well known in the signal domain (RF filtering), but their use in the field of power electronics, as a temporary energy storage element, is rather recent. In power electronics, piezoelectricity has mainly been used as a transformer, in particular, to greatly increase voltages (backlight applications). A class L−Piezo inverter with Lithium Niobate (LNO) piezoelectric resonator is designed for a switching frequency of 10.4 MHz, an input voltage of 30 V, and an output power of 15 W. To compare these two filtering methods, two prototypes are built, one with piezoelectric filtering and one with passive LC filtering. Measurements show a reduction of 60% of the losses in the filter, while the volume of the filter is reduced by a factor of 50.
- 1 December 2022
- Published by MDPI AG in Electronics
- Vol. 11 (23) , 3983
Open AccessComparison between Piezoelectric Filter and Passive LC Filter in a Class L−Piezo Inverter
This paper presents a comparison between piezoelectric filtering and passive LC filtering integrated into an HF class L−Piezo inverter. This L−Piezo inverter is a variant of class φ2 where the filtering of the second harmonic is carried out by a piezoelectric resonator. Piezoelectric filters are well known in the signal domain (RF filtering), but their use in the field of power electronics, as a temporary energy storage element, is rather recent. In power electronics, piezoelectricity has mainly been used as a transformer, in particular, to greatly increase voltages (backlight applications). A class L−Piezo inverter with Lithium Niobate (LNO) piezoelectric resonator is designed for a switching frequency of 10.4 MHz, an input voltage of 30 V, and an output power of 15 W. To compare these two filtering methods, two prototypes are built, one with piezoelectric filtering and one with passive LC filtering. Measurements show a reduction of 60% of the losses in the filter, while the volume of the filter is reduced by a factor of 50.
- 13 March 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 34 (9) , 8289-8292
A Very High Frequency Self-Oscillating Inverter Based on a Novel Free-Running Oscillator
This paper introduces a self oscillating very high frequency (VHF) class $\phi 2$ inverter based on a free-running oscillator. The class $\phi 2$ is a low voltage semiconductor stress, fast transient, single transistor inverter topology suitable for very high frequency applications. With new advancements in GaN technology, the tendency to increase the switching frequency in power converters is on the rise. Switching at very high frequency (VHF: 30MHz-300MHz) allows for smaller passive components and more compact power converters. However, although GaN components are able to switch at 100 MHz and beyond, gate drivers available in the market struggle to provide the adequate switching signal at very high frequency. Hence, there is a need for an alternative to VHF converters using those gate drivers : self-oscillating topologies. To that end, a self-oscillating class $\phi 2$ inverter switching at 30 MHz is presented and a design methodology is provided. A 30MHz prototype with 30V input voltage using a GaN Systems GS61004B is also built and tested, showing good matching between the simulation and experimental results.- 13 March 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 34 (9) , 8289-8292
A Very High Frequency Self-Oscillating Inverter Based on a Novel Free-Running Oscillator
This paper introduces a self oscillating very high frequency (VHF) class $\phi 2$ inverter based on a free-running oscillator. The class $\phi 2$ is a low voltage semiconductor stress, fast transient, single transistor inverter topology suitable for very high frequency applications. With new advancements in GaN technology, the tendency to increase the switching frequency in power converters is on the rise. Switching at very high frequency (VHF: 30MHz-300MHz) allows for smaller passive components and more compact power converters. However, although GaN components are able to switch at 100 MHz and beyond, gate drivers available in the market struggle to provide the adequate switching signal at very high frequency. Hence, there is a need for an alternative to VHF converters using those gate drivers : self-oscillating topologies. To that end, a self-oscillating class $\phi 2$ inverter switching at 30 MHz is presented and a design methodology is provided. A 30MHz prototype with 30V input voltage using a GaN Systems GS61004B is also built and tested, showing good matching between the simulation and experimental results.