Shuang Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Shuang Li has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Chong Ren
China Academy of Launch Vehicle Technology, Beijing, CHINA
2 shared publications - Guobing Zeng
School of Electronic and Information Engineering, Beihang University, Beijing, China
2 shared publications - Huaping Xu
School of Electronic and Information Engineering, Beihang University, Beijing, China
2 shared publications - Yuan Wang
School of Electronic and Information Engineering, Beihang University, Beijing, China
2 shared publications - Bin Zhang
Beijing Institute of Radio Measurement, Beijing 100854, China
1 shared publication - Chunsheng Li
School of Electronic and Information Engineering, Beihang University, Beijing, China
1 shared publication
Latest Publications
- 2 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 24 (20) , 32684-32693
A Modified Minimum Cost Flow Phase Unwrapping Method Based on Reliable Pixel Detection
Phase unwrapping has been one of the most focused and challenging topics in Interferometric Synthetic Aperture Radar (InSAR). It imposes direct impact on the InSAR products, e.g., Digital Elevation Model (DEM) and earth surface deformation. In fact, except for a few deep-learning based algorithms, the task of most single-baseline phase unwrapping algorithms is to appropriately locate discontinuities. However, for most of current methods, misplacement of discontinuities on reliable pixels that don’t contain discontinuities often happens, especially when dealing with interferograms that are distributed with dense noise and layover, which will lead to phase unwrapping errors in a large area. To mitigate this problem, a modified Minimum Cost Flow (MCF) phase unwrapping method based on reliable pixel detection is presented. By introducing a phase quality index, reliable pixels are detected. Then, a modified MCF algorithm is applied to locate discontinuities outside of the detected reliable pixels. Finally, an integration guided by quality index and the discontinuities location is employed to retrieve the unwrapped phase. Experiments conducted both on simulated data and realistic data have confirmed the effectiveness of the proposed method.
- 2 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 24 (20) , 32684-32693
A Modified Minimum Cost Flow Phase Unwrapping Method Based on Reliable Pixel Detection
Phase unwrapping has been one of the most focused and challenging topics in Interferometric Synthetic Aperture Radar (InSAR). It imposes direct impact on the InSAR products, e.g., Digital Elevation Model (DEM) and earth surface deformation. In fact, except for a few deep-learning based algorithms, the task of most single-baseline phase unwrapping algorithms is to appropriately locate discontinuities. However, for most of current methods, misplacement of discontinuities on reliable pixels that don’t contain discontinuities often happens, especially when dealing with interferograms that are distributed with dense noise and layover, which will lead to phase unwrapping errors in a large area. To mitigate this problem, a modified Minimum Cost Flow (MCF) phase unwrapping method based on reliable pixel detection is presented. By introducing a phase quality index, reliable pixels are detected. Then, a modified MCF algorithm is applied to locate discontinuities outside of the detected reliable pixels. Finally, an integration guided by quality index and the discontinuities location is employed to retrieve the unwrapped phase. Experiments conducted both on simulated data and realistic data have confirmed the effectiveness of the proposed method.
- 1 September 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Chinese Journal of Electronics
- Vol. 32 (5) , 1089-1105
A Novel Adaptive InSAR Phase Filtering Method Based on Complexity Factors
Phase filtering is an essential step in interferometric synthetic aperture radar (InSAR) imaging. For interferograms of complicated and changeable terrain, the increasing resolution of InSAR images makes it even more difficult. In this paper, a novel adaptive InSAR phase filtering method based on complexity factors is proposed. Firstly, three complexity factors based on the noise distribution and terrain slope information of the interferogram are selected. The complexity indicator composed of three complexity factors is used to guide the adaptive selection of the most suitable and effective filtering strategies for different areas. Then, the complexity scalar is calculated, which can guide the adaptive local fringe frequency estimation and adaptive parameters calculation in different filter methods. Finally, validations are performed on the simulated and real data. The performance comparison between the other three representative phase filtering method and the proposed method have validated the effectiveness and superiority of the proposed method.
- 1 September 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Chinese Journal of Electronics
- Vol. 32 (5) , 1089-1105
A Novel Adaptive InSAR Phase Filtering Method Based on Complexity Factors
Phase filtering is an essential step in interferometric synthetic aperture radar (InSAR) imaging. For interferograms of complicated and changeable terrain, the increasing resolution of InSAR images makes it even more difficult. In this paper, a novel adaptive InSAR phase filtering method based on complexity factors is proposed. Firstly, three complexity factors based on the noise distribution and terrain slope information of the interferogram are selected. The complexity indicator composed of three complexity factors is used to guide the adaptive selection of the most suitable and effective filtering strategies for different areas. Then, the complexity scalar is calculated, which can guide the adaptive local fringe frequency estimation and adaptive parameters calculation in different filter methods. Finally, validations are performed on the simulated and real data. The performance comparison between the other three representative phase filtering method and the proposed method have validated the effectiveness and superiority of the proposed method.
- Open Access
- 9 December 2022
- Published by MDPI AG in Applied Sciences
- Vol. 12 (24) , 12658
Airborne Single-Pass Multi-Baseline InSAR Layover Separation Method Based on Multi-Look Compressive Sensing
Due to the small number of baselines (2–3), the traditional L1 norm compressive sensing method for layover solution in InSAR has poor separation ability and height estimation stability and a long operation time. This paper, based on the idea of multi-look, adopts a multi-look compressive sensing method and a multi-look compressive sensing method based on separable approximate sparse reconstruction. The layover separation method based on multi-look compressive sensing adopts the surrounding pixels around the current point as independent observations together with this point to increase the observation vector in compressive sensing, and uses the singular value decomposition method to obtain the noise value, which is used to improve the dimensions of measured data in compressive sensing, reduces the noise level, and improves the stability of noise estimation. Meanwhile, the results of the multi-look L1 norm solution method are closer to those of the L0 norm solution, and the sparse reconstruction ability of compressive sensing is improved. Thus, the separation ability of the scatterers in the layover areas and the stability of height estimation are stronger. In addition, the multi-look compressive sensing method based on separable approximate sparse reconstruction constructs differential operation and soft functions, transforms the L1–L2 norm optimization into an iterative soft threshold shrinkage processing mode, and improves the processing speed by means of the threshold iteration method, which can effectively reduce the operation time while maintaining the resolution ability of scatterers in layover areas and the height direction estimation accuracy and provides the possibility for large-scale data processing. These two methods are effectively verified by means of simulation and measured data. The simulation experiments of the two methods are based on the airborne MEMPHIS system with four antennas, and the height values of the layover scatterers solved by the two methods are more reliable, stable, and closer to the real value than those solved by the traditional compressive sensing method. The operation time of the separable approximate sparse reconstruction method is comparable to the processing time of the traditional compressive sensing method and nearly one-quarter that of the multi-look compressive sensing method. The real data experiments of the two methods are based on the airborne Millimeter-wave InSAR system with three antennas. The two methods both have certain height resolutions in the height direction estimation of layover areas and fine elevation continuity, while traditional compressive sensing method cannot satisfy the condition of sparsity and has poor scatterer separation and elevation continuity. Nevertheless, the multi-look compressive sensing method is a little more stable than the separable approximate sparse reconstruction method, and the operation time of the separable approximate sparse reconstruction method is comparable to the traditional compressive sensing method and nearly one-fifth that of the multi-look compressive sensing method.
- 9 December 2022
- Published by MDPI AG in Applied Sciences
- Vol. 12 (24) , 12658
Open AccessAirborne Single-Pass Multi-Baseline InSAR Layover Separation Method Based on Multi-Look Compressive Sensing
Due to the small number of baselines (2–3), the traditional L1 norm compressive sensing method for layover solution in InSAR has poor separation ability and height estimation stability and a long operation time. This paper, based on the idea of multi-look, adopts a multi-look compressive sensing method and a multi-look compressive sensing method based on separable approximate sparse reconstruction. The layover separation method based on multi-look compressive sensing adopts the surrounding pixels around the current point as independent observations together with this point to increase the observation vector in compressive sensing, and uses the singular value decomposition method to obtain the noise value, which is used to improve the dimensions of measured data in compressive sensing, reduces the noise level, and improves the stability of noise estimation. Meanwhile, the results of the multi-look L1 norm solution method are closer to those of the L0 norm solution, and the sparse reconstruction ability of compressive sensing is improved. Thus, the separation ability of the scatterers in the layover areas and the stability of height estimation are stronger. In addition, the multi-look compressive sensing method based on separable approximate sparse reconstruction constructs differential operation and soft functions, transforms the L1–L2 norm optimization into an iterative soft threshold shrinkage processing mode, and improves the processing speed by means of the threshold iteration method, which can effectively reduce the operation time while maintaining the resolution ability of scatterers in layover areas and the height direction estimation accuracy and provides the possibility for large-scale data processing. These two methods are effectively verified by means of simulation and measured data. The simulation experiments of the two methods are based on the airborne MEMPHIS system with four antennas, and the height values of the layover scatterers solved by the two methods are more reliable, stable, and closer to the real value than those solved by the traditional compressive sensing method. The operation time of the separable approximate sparse reconstruction method is comparable to the processing time of the traditional compressive sensing method and nearly one-quarter that of the multi-look compressive sensing method. The real data experiments of the two methods are based on the airborne Millimeter-wave InSAR system with three antennas. The two methods both have certain height resolutions in the height direction estimation of layover areas and fine elevation continuity, while traditional compressive sensing method cannot satisfy the condition of sparsity and has poor scatterer separation and elevation continuity. Nevertheless, the multi-look compressive sensing method is a little more stable than the separable approximate sparse reconstruction method, and the operation time of the separable approximate sparse reconstruction method is comparable to the traditional compressive sensing method and nearly one-fifth that of the multi-look compressive sensing method.