ZYZ. M. Yang
Z. M. Yang
*This is an algorithmically generated author record based on publicly available information.
Z. M. Yang has a total of 1 co-authors. Here are the top co-authors by number of shared publications:
- Seng-Tjhen Lie
School of Civil and Environmental Engineering, Nanyang Technological University, 50 Nanyang Avenue, Singapore 639798, Singapore
2 shared publications
Latest Publications
- 6 December 2010
- Published by ASME International in Journal of Offshore Mechanics and Arctic Engineering
- Vol. 133 (2) , 021601
Plastic Collapse Loads of Cracked Square Hollow Section T-, Y-, and K-joints
This paper concerns on the development of numerical models for cracked square hollow sections (SHSs) T-, Y-, and K-joints. Based on these numerical models, the plastic collapse loads are calculated using nonlinear finite element method and through twice-elastic compliance criterion. It is found that the numerical plastic collapse loads are slightly conservative compared with the ones calculated using formulae proposed by BS7910 [British Standards, 2005, “Guide on Methods for Assessing the Acceptability of Flaws in Metallic Structures,” BS 7910-Amendment 1] and are in close agreement with the experimental tests data. Therefore, the proposed numerical model is robust and it can be used to calculate the plastic collapse loads of the cracked (SHS) T-, Y-, and K-joints.- 6 December 2010
- Published by ASME International in Journal of Offshore Mechanics and Arctic Engineering
- Vol. 133 (2) , 021601
Plastic Collapse Loads of Cracked Square Hollow Section T-, Y-, and K-joints
This paper concerns on the development of numerical models for cracked square hollow sections (SHSs) T-, Y-, and K-joints. Based on these numerical models, the plastic collapse loads are calculated using nonlinear finite element method and through twice-elastic compliance criterion. It is found that the numerical plastic collapse loads are slightly conservative compared with the ones calculated using formulae proposed by BS7910 [British Standards, 2005, “Guide on Methods for Assessing the Acceptability of Flaws in Metallic Structures,” BS 7910-Amendment 1] and are in close agreement with the experimental tests data. Therefore, the proposed numerical model is robust and it can be used to calculate the plastic collapse loads of the cracked (SHS) T-, Y-, and K-joints.- 30 June 2009
- Published by Elsevier in Engineering Fracture Mechanics
- Vol. 76 (9) , 1303-1319
Fracture assessment of damaged square hollow section (SHS) K-joint using BS7910:2005
- 30 June 2009
- Published by Elsevier in Engineering Fracture Mechanics
- Vol. 76 (9) , 1303-1319
Fracture assessment of damaged square hollow section (SHS) K-joint using BS7910:2005