Quang-Thai Nguyen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Quang-Thai Nguyen has a total of 32 co-authors. Here are the top co-authors by number of shared publications:
- Van-Tu Nguyen
School of Mechanical Engineering, Pusan National University, Busan 46241, Republic of Korea
4 shared publications - Warn-Gyu Park
School of Mechanical Engineering, Pusan National University, Busan, Korea
3 shared publications - Ould el Moctar
Chair of Autonomous and Energy Efficient Maritime Technologies, Technische Universität Berlin, Berlin, Germany
2 shared publications Seong-Ho Park
2 shared publicationsThanh-Hoang Phan
2 shared publications- Thanh-Hoang Phan
School of Mechanical Engineering, Pusan National University, Busan 609-735, South Korea
2 shared publications
Latest Publications
- Open Access
- 2 October 2026
- Published by Road and Bridge Research Institute in Roads and Bridges – Drogi i Mosty
- Vol. 25 (3) , 225-246
Hydraulic response and Turbulence-Model Sensitivity of a Circular Culvert under Discharge Escalation: A CFD and HY-8 Comparative Study
The article presents a systematic analysis of the hydraulic response of a circular culvert under discharge escalation scenarios using three-dimensional computational fluid dynamics (CFD) modeling and comparison with conventional HY-8 design-level predictions. Three discharge conditions were considered: the design flow Q₁ = 6.70 m³/s and escalated flows Q₂ = 10.05 m³/s = 1.5Q₁ and Q₃ = 13.40 m³/s = 2.0Q₁. Turbulence-model sensitivity (SST k–ω, Realizable k–ε, and RNG k–ε) was examined to quantify model-induced uncertainty in outlet-velocity prediction. Results indicate that outlet velocity increases approximately linearly with discharge, reaching 7.42-7.51 m/s under the highest flow condition, while deviations among the turbulence models remain below approximately 1.5%. Headwater depth increased from 1.94 m at Q₁ to 3.68 m at Q₃. CFD and HY-8 headwater depths agreed closely across all three scenarios: 1.94 versus 1.93 m at Q₁, 2.68 versus 2.67 m at Q₂, and 3.68 versus 3.69 m at Q₃, corresponding to relative CFD-HY-8 differences of +0.52%, +0.37%, and −0.27%, respectively. HY-8 is therefore used here as a design-level benchmark rather than as independent validation of local CFD fields. Non-dimensional analysis based on HW/D, a diameter-based velocity scaling parameter V / √gD, and Reynolds number indicates that discharge escalation primarily amplifies upstream headwater submergence. Although conveyance capacity remains hydraulically adequate, elevated outlet velocities substantially increase downstream scour potential. The findings support hydraulic safety assessment and outlet-protection design under intensified discharge conditions.
- 2 October 2026
- Published by Road and Bridge Research Institute in Roads and Bridges – Drogi i Mosty
- Vol. 25 (3) , 225-246
Open AccessHydraulic response and Turbulence-Model Sensitivity of a Circular Culvert under Discharge Escalation: A CFD and HY-8 Comparative Study
The article presents a systematic analysis of the hydraulic response of a circular culvert under discharge escalation scenarios using three-dimensional computational fluid dynamics (CFD) modeling and comparison with conventional HY-8 design-level predictions. Three discharge conditions were considered: the design flow Q₁ = 6.70 m³/s and escalated flows Q₂ = 10.05 m³/s = 1.5Q₁ and Q₃ = 13.40 m³/s = 2.0Q₁. Turbulence-model sensitivity (SST k–ω, Realizable k–ε, and RNG k–ε) was examined to quantify model-induced uncertainty in outlet-velocity prediction. Results indicate that outlet velocity increases approximately linearly with discharge, reaching 7.42-7.51 m/s under the highest flow condition, while deviations among the turbulence models remain below approximately 1.5%. Headwater depth increased from 1.94 m at Q₁ to 3.68 m at Q₃. CFD and HY-8 headwater depths agreed closely across all three scenarios: 1.94 versus 1.93 m at Q₁, 2.68 versus 2.67 m at Q₂, and 3.68 versus 3.69 m at Q₃, corresponding to relative CFD-HY-8 differences of +0.52%, +0.37%, and −0.27%, respectively. HY-8 is therefore used here as a design-level benchmark rather than as independent validation of local CFD fields. Non-dimensional analysis based on HW/D, a diameter-based velocity scaling parameter V / √gD, and Reynolds number indicates that discharge escalation primarily amplifies upstream headwater submergence. Although conveyance capacity remains hydraulically adequate, elevated outlet velocities substantially increase downstream scour potential. The findings support hydraulic safety assessment and outlet-protection design under intensified discharge conditions.
- 6 January 2025
- Published by Elsevier in Ocean Engineering
- Vol. 319
Effects of free surface on dynamics of a laser-induced cavitation bubble near horizontal rigid wall
- 6 January 2025
- Published by Elsevier in Ocean Engineering
- Vol. 319
Effects of free surface on dynamics of a laser-induced cavitation bubble near horizontal rigid wall
- 1 January 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (1)
Effects of oscillating curved wall on behavior of a collapsing cavitation bubble
The behaviors of a collapsing cavitation bubble were investigated using numerical simulations, focusing on the effects of a controlled oscillating wall with a spherically curved geometry. Different wall-controlled oscillation conditions were modeled. The collapse of the laser-induced cavitation bubble near the curved wall was observed experimentally to validate the numerical model at the same fixed standoff condition S = 1.2. A good agreement was observed between experimental and numerical results. A compressible model for the two-phase flow, based on a geometric volume of the fluid technique, was employed for numerical simulation. High-speed camera experiments captured the behaviors of the laser-induced cavitation bubbles. Both in-phase and out-of-phase oscillating motion of a rigid with spherical surface was modeled by using a sinusoidal function within a curvilinear moving grid framework. The study explored the effects of oscillating walls through numerical comparisons between the fixed and oscillating conditions, considering different initial phase conditions as φ0=−90°, 0°, φ0=+90°, and +180°. The upward jet flow forms at φ0=−90°, 0°, and +90°, while the downward jet flow forms at φ0=+180°. Numerical analyses reveal significant effects of motion conditions at in-phase (φ0=−90°, 0°) and out-of-phase (φ0=+90°, +180°) conditions, which vary with the scaled amplitude parameter, As=A/R0, defined by the ratio of the oscillating amplitude, A, and the maximum bubble radius, R0. Various features were analyzed, including oscillation and deformation of bubble shape, the formation of jet flow, and pressure peaks on the wall. Critical values of As = 0.1, 0.2, and 0.3 were identified, influencing bubble collapse time, jet flow speed, and peaks of pressure under both in-phase and out-oscillation motion.
- 1 January 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (1)
Effects of oscillating curved wall on behavior of a collapsing cavitation bubble
The behaviors of a collapsing cavitation bubble were investigated using numerical simulations, focusing on the effects of a controlled oscillating wall with a spherically curved geometry. Different wall-controlled oscillation conditions were modeled. The collapse of the laser-induced cavitation bubble near the curved wall was observed experimentally to validate the numerical model at the same fixed standoff condition S = 1.2. A good agreement was observed between experimental and numerical results. A compressible model for the two-phase flow, based on a geometric volume of the fluid technique, was employed for numerical simulation. High-speed camera experiments captured the behaviors of the laser-induced cavitation bubbles. Both in-phase and out-of-phase oscillating motion of a rigid with spherical surface was modeled by using a sinusoidal function within a curvilinear moving grid framework. The study explored the effects of oscillating walls through numerical comparisons between the fixed and oscillating conditions, considering different initial phase conditions as φ0=−90°, 0°, φ0=+90°, and +180°. The upward jet flow forms at φ0=−90°, 0°, and +90°, while the downward jet flow forms at φ0=+180°. Numerical analyses reveal significant effects of motion conditions at in-phase (φ0=−90°, 0°) and out-of-phase (φ0=+90°, +180°) conditions, which vary with the scaled amplitude parameter, As=A/R0, defined by the ratio of the oscillating amplitude, A, and the maximum bubble radius, R0. Various features were analyzed, including oscillation and deformation of bubble shape, the formation of jet flow, and pressure peaks on the wall. Critical values of As = 0.1, 0.2, and 0.3 were identified, influencing bubble collapse time, jet flow speed, and peaks of pressure under both in-phase and out-oscillation motion.
- 11 July 2023
- Published by Elsevier in Ocean Engineering
- Vol. 285
Numerical study of bubble dynamics near a solid wall with a gas-entrapping hole
- 11 July 2023
- Published by Elsevier in Ocean Engineering
- Vol. 285
Numerical study of bubble dynamics near a solid wall with a gas-entrapping hole
- 1 January 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (1)
Numerical study of dynamics of cavitation bubble collapse near oscillating walls
This paper presents a numerical study of the dynamics of an initially spherical bubble collapse near an oscillating rigid wall with a large amplitude; the wall oscillating amplitude is greater than 1% of the initial maximum bubble radius. Numerical simulations were conducted using a compressible two-phase flow model and the volume of fluid (VOF) interphase-sharpening technique on a general curvilinear moving grid. The numerical results for bubbles in the free field and near a wall were computed and compared with published experimental data. To study the effects of the oscillating wall on bubble collapse, a sinusoidal function was used for wall oscillation. The initial bubble conditions were set as a Rayleigh bubble located above the rigid wall at a dimensionless bubble-boundary distance with initial phases of 0{degree sign} and 180{degree sign}. During bubble collapse, the interface deformation, jetting behavior, bubble collapse time, and bubble migration were determined. Violent collapse of the bubble, jetting behavior, and shock propagation from the significant effects of the oscillating wall were observed in simulation cases with different wall motions. The effects of the non-dimensional amplitude scale and non-dimensional period timescale were considered with the initial phases in the problem. The trend lines of typical characteristics and critical points of bubble collapse were determined.
- 1 January 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (1)
Numerical study of dynamics of cavitation bubble collapse near oscillating walls
This paper presents a numerical study of the dynamics of an initially spherical bubble collapse near an oscillating rigid wall with a large amplitude; the wall oscillating amplitude is greater than 1% of the initial maximum bubble radius. Numerical simulations were conducted using a compressible two-phase flow model and the volume of fluid (VOF) interphase-sharpening technique on a general curvilinear moving grid. The numerical results for bubbles in the free field and near a wall were computed and compared with published experimental data. To study the effects of the oscillating wall on bubble collapse, a sinusoidal function was used for wall oscillation. The initial bubble conditions were set as a Rayleigh bubble located above the rigid wall at a dimensionless bubble-boundary distance with initial phases of 0{degree sign} and 180{degree sign}. During bubble collapse, the interface deformation, jetting behavior, bubble collapse time, and bubble migration were determined. Violent collapse of the bubble, jetting behavior, and shock propagation from the significant effects of the oscillating wall were observed in simulation cases with different wall motions. The effects of the non-dimensional amplitude scale and non-dimensional period timescale were considered with the initial phases in the problem. The trend lines of typical characteristics and critical points of bubble collapse were determined.
- 18 June 2020
- Published by Sciencedomain International
Current Strategies in Economics and Management Vol. 2
- 18 June 2020
- Published by Sciencedomain International
Current Strategies in Economics and Management Vol. 2