Utku Burgun
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Utku Burgun has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Alper Sarıoğlan
Department of Chemical Engineering, Istanbul Technical University, İstanbul, Türkiye
4 shared publications - Gamze Gumuslu Gur
ITU Synthetic Fuels and Chemicals Technology Center, ITU-SENTEK, Istanbul, Turkey
3 shared publications - Duygu Yeşiltepe-Özçelik
Department of Metallurgical and Materials Engineering, Istanbul Technical University, Istanbul, Turkey
2 shared publications - Emircan Uysal
Department of Chemical Engineering, KTH Royal Institute of Technology, Stockholm, Sweden
2 shared publications - Sebahattin Gürmen
Istanbul Teknik Üniversitesi
2 shared publications - Yasemin Fatih Aghdaei2 shared publications
Latest Publications
- Open Access
- 24 February 2026
- Published by Springer Nature in Mining, Metallurgy & Exploration
- Vol. 43 (2) , 1847-1862
Ni-based Catalysts Supported on SCS–Derived MgAl2O4 for CO2 Methanation: Effect of Bimetallic Promoters
In this study, Ni-based catalysts (Ni, NiFe, and NiCo) were synthesized via wet impregnation method using MgAl 2 O 4 spinel supports calcined at 700, 800, and 900 °C. These supports, previously synthesized and optimized by the solution combustion method, enabled investigation of thermal treatment and bimetallic promotion affect catalytic performance in CO 2 methanation. Structural, morphological, and redox properties were characterized using XRD, BET, FT-IR, SEM-EDS, TEM, H 2 -TPR, CO 2 -TPD, and TGA analyses. Catalytic activity tests under atmospheric pressure revealed that the NiCo catalyst supported on MgAl 2 O 4 calcined at 800 °C exhibited the highest CO 2 conversion and CH 4 selectivity. This enhancement was attributed to improved metal dispersion, stronger metal–support interaction, and synergistic effects between Ni and Co species. These results demonstrate dual impact of support calcination temperature and bimetallic design on methanation efficiency. This work offers valuable insight into the rational design of thermally stable and highly active Ni-based catalysts for efficient CO 2 utilization in methane production. Graphical Abstract
- 24 February 2026
- Published by Springer Nature in Mining, Metallurgy & Exploration
- Vol. 43 (2) , 1847-1862
Open AccessNi-based Catalysts Supported on SCS–Derived MgAl2O4 for CO2 Methanation: Effect of Bimetallic Promoters
In this study, Ni-based catalysts (Ni, NiFe, and NiCo) were synthesized via wet impregnation method using MgAl 2 O 4 spinel supports calcined at 700, 800, and 900 °C. These supports, previously synthesized and optimized by the solution combustion method, enabled investigation of thermal treatment and bimetallic promotion affect catalytic performance in CO 2 methanation. Structural, morphological, and redox properties were characterized using XRD, BET, FT-IR, SEM-EDS, TEM, H 2 -TPR, CO 2 -TPD, and TGA analyses. Catalytic activity tests under atmospheric pressure revealed that the NiCo catalyst supported on MgAl 2 O 4 calcined at 800 °C exhibited the highest CO 2 conversion and CH 4 selectivity. This enhancement was attributed to improved metal dispersion, stronger metal–support interaction, and synergistic effects between Ni and Co species. These results demonstrate dual impact of support calcination temperature and bimetallic design on methanation efficiency. This work offers valuable insight into the rational design of thermally stable and highly active Ni-based catalysts for efficient CO 2 utilization in methane production. Graphical Abstract
- Open Access
- 23 May 2025
- Published by Springer Nature in Journal of Sol-Gel Science and Technology
- p. 1-22
Synthesis of MgAl2O4 by sol-gel method and investigation of catalytic performances in CO2 methanation
CO2 levels in the atmosphere are increasing as a result of human activities such as industrial activities, fossil fuel usage, and deforestation. The CO2 methanation reaction, which converts CO2 into methane, may play a crucial role in addressing this issue. Like most commercial syntheses, the CO2 methanation process requires a catalyst. Spinel catalysts, particularly magnesium aluminate (MgAl2O4), have gained attention for their potential in CO2 methanation. In this study, MgAl2O4 nanoparticles were synthesized using a sol–gel method with a molar ratio of Mg:Al = 1:2, and calcined at temperatures ranging from 700 to 900 °C. The structural properties of the nanoparticles were characterized using differential scanning calorimetry, thermogravimetric analysis, Fourier transform infrared spectroscopy, Brunauer-Emmett-Teller analysis, X-ray diffraction, field emission scanning electron microscopy, energy dispersive X-ray spectroscopy, and transmission electron microscopy. The results showed that the particles had nearly spherical morphology, with agglomeration occurring at higher temperatures. The surface area decreased with increasing calcination temperature, from 188 m²/g at 700 °C to 94 m²/g at 900 °C. NiCo-MgAl2O4 catalysts were prepared by impregnation and characterized by CO2 temperature-programmed desorption and hydrogen temperature-programmed reduction. Catalytic performance tests revealed that the NiCo-MgAl2O4 catalyst calcined at 800 °C achieved the highest CO2 conversion (~85%) and methane selectivity. Spent catalyst analysis showed that carbon deposition negatively affected catalyst performance over time. This study emphasizes the role of strong basic sites in CO2 activation and methane formation, suggesting future improvements in catalyst stability. Graphical Abstract
- 23 May 2025
- Published by Springer Nature in Journal of Sol-Gel Science and Technology
- p. 1-22
Open AccessSynthesis of MgAl2O4 by sol-gel method and investigation of catalytic performances in CO2 methanation
CO2 levels in the atmosphere are increasing as a result of human activities such as industrial activities, fossil fuel usage, and deforestation. The CO2 methanation reaction, which converts CO2 into methane, may play a crucial role in addressing this issue. Like most commercial syntheses, the CO2 methanation process requires a catalyst. Spinel catalysts, particularly magnesium aluminate (MgAl2O4), have gained attention for their potential in CO2 methanation. In this study, MgAl2O4 nanoparticles were synthesized using a sol–gel method with a molar ratio of Mg:Al = 1:2, and calcined at temperatures ranging from 700 to 900 °C. The structural properties of the nanoparticles were characterized using differential scanning calorimetry, thermogravimetric analysis, Fourier transform infrared spectroscopy, Brunauer-Emmett-Teller analysis, X-ray diffraction, field emission scanning electron microscopy, energy dispersive X-ray spectroscopy, and transmission electron microscopy. The results showed that the particles had nearly spherical morphology, with agglomeration occurring at higher temperatures. The surface area decreased with increasing calcination temperature, from 188 m²/g at 700 °C to 94 m²/g at 900 °C. NiCo-MgAl2O4 catalysts were prepared by impregnation and characterized by CO2 temperature-programmed desorption and hydrogen temperature-programmed reduction. Catalytic performance tests revealed that the NiCo-MgAl2O4 catalyst calcined at 800 °C achieved the highest CO2 conversion (~85%) and methane selectivity. Spent catalyst analysis showed that carbon deposition negatively affected catalyst performance over time. This study emphasizes the role of strong basic sites in CO2 activation and methane formation, suggesting future improvements in catalyst stability. Graphical Abstract
- 19 May 2025
- Published by Elsevier in Molecular Catalysis
- Vol. 583
ZIF‐67 based nano sized-cobalt oxides via pyrolysis and cold plasma treatments for Fischer–Tropsch synthesis
- 19 May 2025
- Published by Elsevier in Molecular Catalysis
- Vol. 583
ZIF‐67 based nano sized-cobalt oxides via pyrolysis and cold plasma treatments for Fischer–Tropsch synthesis
- 20 December 2022
- Published by Elsevier in Molecular Catalysis
- Vol. 535
Effect of sodium incorporation into Fe-Zn catalyst for Fischer- Tropsch synthesis to light olefins
- 20 December 2022
- Published by Elsevier in Molecular Catalysis
- Vol. 535
Effect of sodium incorporation into Fe-Zn catalyst for Fischer- Tropsch synthesis to light olefins