KKKyumin Kwon

Kyumin Kwon

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Kyumin Kwon has a total of 7 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • PLL Fractional Spur’s Impact on FSK Spectrum and a Synthesizable ADPLL for a Bluetooth Transmitter

    by Kyumin Kwon, Omar A. B. Abdelatty, David D. Wentzloff

    In this work, we present an open-source fully-synthesizable fractional-N all-digital phase-locked loop (ADPLL) designed for a Bluetooth low-energy (BLE) transmitter (TX) along with a semi-analytical model of the PLL fractional spur’s impact on the BLE output spectrum. Based on the model and the BLE specification for spur emission, a requirement for the PLL fractional spurs is derived. To meet the derived spectral mask by reducing the fractional spurs, a novel synthesizable two-step time to digital converter (TSTDC) that employs embedded TDC (EMBTDC) as coarse and Vernier delay-line TDC (DLTDC) as fine TDC is proposed. We also present a digital calibration scheme to compensate for the nonlinearity induced by the place-and-route (P&R) tool. The PLL is fabricated in 12-nm FinFET and demonstrated in a BLE-TX. The measured BLE transmissions satisfy the standard requirements thanks to the reduced fractional spurs. In a standalone PLL mode, the proposed TSTDC and calibration scheme reduced the fractional spurs by 14.3 dB compared to only using an EMBTDC in near-integer $N$ operation. The PLL supports a frequency range of 1.8–2.7 GHz and consumes 3.91 mW at 2.4006 GHz achieving figure of merit (FoM) of $-$ 220.7 dB in fractional-N mode with a 40 MHz reference, occupying an area of 0.063 mm $^{2}$ . A highly automated design flow is used for the PLL to lower the barrier for new developers and reduce the porting cost.


  • An 81.6 dB SNDR 15.625 MHz BW Third-Order CT SDM With a True Time-Interleaving Noise-Shaping Quantizer

    by Seungjong Lee, Taewook Kang, Seungheun Song, Kyumin Kwon, Michael P. Flynn

    This work introduces a time-interleaved architecture to tackle the speed-resolution bottleneck of the noise-shaping (NS) successive approximation register (SAR) quantizer in a continuous-time (CT) sigma-delta modulator (SDM). A critical insight is that introducing a delay in the NS quantizer feedback loop enables complete parallelization of the NS quantizer operations. The extra time from parallelization greatly relaxes loop filtering and residue integration and enables a high quantizer resolution. Furthermore, the extra time in the feedback loop allows data weighted averaging (DWA), which eliminates the need for calibration. The prototype comprises a second-order CT front-end and a fully interleaved first-order NS quantizer. The prototype is fabricated in a 28 nm process, occupies 0.072 mm2 and consumes 6.4 mW. The peak signal-to-noise ratio (SNR), signal-to-noise-distortion ratio (SNDR), and dynamic range (DR) are 83.9, 81.6, and 84.8 dB, respectively, in a 15.625 MHz bandwidth. The corresponding Schreier SNDR figure of merit (FoM) is 175.5 dB.


  • Open-Source Fully-Synthesizable ADPLL for a Bluetooth Low-Energy Transmitter in 12nm FinFET Technology

    by Kyumin Kwon, Omar Abdelatty, David Wentzloff

    In this work, we present an open-source fully-synthesizable fractional-N ADPLL designed for a Bluetooth Low-Energy (BLE) transmitter (TX). A highly automated design flow is used to lower the barrier for new developers and to reduce porting cost. In the PLL, a novel two-step TDC (TSTDC) is proposed, which is amenable to P&R, and uses an embedded TDC (EMBTDC) and vernier delay-line TDC (DLTDC) as coarse and fine TDCs, respectively. This combination reduces the required DLTDC input time range by 5x and is used to measure and compensate the P&R induced non-linearity of the EMBTDC. The PLL is fabricated in 12-nm FinFET and demonstrated in a BLE-TX. BLE transmissions satisfy the standard requirements thanks to the reduced fractional spurs by abovementioned techniques. In a standalone PLL mode, the TSTDC reduced fractional spurs by 6.8 dB compared to an EMBTDC alone, and the proposed LUT-based calibration further reduced spurs by 7.5 dB in near-integer operation. The PLL supports frequency range of 1.8-2.7GHz and consumes 3.91mW at 2.4006 GHz, with a 40MHz reference, occupying area of 0.063mm 2 .