MKMykola Stepanovych Kukurudziak

Mykola Stepanovych Kukurudziak

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Mykola Stepanovych Kukurudziak has a total of 21 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    EVOLUTION OF Si-SiO2 INTERFACE TRAP STATES AND CARRIER TRANSPORT MECHANISMS IN GUARD-RING ISOLATED p-i-n PHOTODIODES UNDER THERMO-OPTO-ELECTRICAL STRESS

    by Mykola Kukurudziak, Viktor Danchuk, Dmytro Koziarskyi, Denys Novikov, Ivan Koziarskyi, Eduard Maistruk

    This article presents a study of the evolution of charge and traps states in Si-based MOS-structures under thermo-opto-electrical stress. It also investigates the effect of stress on the evolution of current-carrying mechanisms in photodiodes with n+-, p+-, or no guard ring. It has been established that the effective oxide charge increases with the aging test time due to the generation of a significant number of border and surface traps, as well as an increase in the density of positive Na+ and K+ ions, which constitute the mobile charge. In fact, the density of mobile charge in the system does not increase, since positive ions occupy potential wells from which the energy of thermoelectric excitation is insufficient to escape; therefore, these ions behave predominantly as fixed charge. It was also found that as the duration of the thermo-opto-electrical stress, surface generation predominates in all types of photodiodes, which causes an increase in surface dark leakage currents. This correlates well with an increase in the density of surface states and a decrease in the insulation resistance between the active elements of the photodiodes due to the formation of parasitic surface inversion channels. A photodiode with an n+-guard ring exhibits the smallest increase in dark current during testing as a result of effective suppression of surface generation and the smallest area through which space-charge region charge escapes to the crystal surface.

  • Single-Element Silicon p-i-n Photodiode with a Guard Ring, Isotype with the Substrate Material

    by Mykola S. Kukurudziak, Denys O. Novikov, Andriy O. Voronko, Dmytro P. Koziarskyi, Ivan P. Koziarskyi

  • Four-quadrant silicon p-i-n photodiode with increased inter-quadrant resistance

    by Mykola Kukurudziak, Denys Novikov, Viktor Danchuk, Roman Yatskiv, Andrew Voronko

  • Open Access

    Four-quadrant silicon p-i-n photodiode with increased inter-quadrant resistance

    by Mykola Kukurudziak, Denys Novikov, Viktor Danchuk, Roman Yatskiv, Andrew Voronko

    One of the main challenges of four-quadrant photodiodes is ensuring interquadrant resistance and minimizing the photoelectric coupling coefficient between the elements. Errors in these parameters can lead to false alarms and incorrect determination of object coordinates, since a multi-element photodetector can then behave as a single element. In this paper, we propose to increase the insulation resistance between the active elements of four-quadrant p-type silicon p-i-n photodiodes by forming p+- regions between the responsive quadrants by boron diffusion. It was found that the best option is to simultaneously front alloy with the diffusion of boron to the back side of the substrate, since this does not introduce additional thermal operations into the technological route. The proposed method enables the fabrication of photodiodes with an interquadrant resistance of the order of 170-550 MΩ and a photoelectric coupling coefficient of less than 2 %.

  • Open Access

    Electrical, Optical, and Structural Properties of Silicon n+-p Structures

    by Mykola S. Kukurudziak, Dmytro P. Koziarskyi, Ivan P. Koziarskyi, Eduard V. Maistruk, Maria I. Ilashchuck, Dmytro V. Kysil

    The article investigates the structural, optical, and electrical properties of silicon n+-p structures. The experimental samples were made from high-resistance single-crystal silicon using two-stage phosphorus diffusion from solid-state planar sources. It was found that the introduction of phosphorus impurities with a concentration of 1.2∙1020 cm-3 provokes the formation of dislocations with a surface density of 2∙103-3∙103 cm-2 due to the formation and relaxation of mechanical stresses. The formation of a lightening oxide film on the silicon surface reduces the reflection coefficient by 25%. However, the formation of an n+-layer reduces the transmittance coefficient of the structure. It was established from the voltage-current characteristics of the n+-p structure under forward and reverse voltage bias, that in the temperature range T = 295–346 K, these structures have rectifying properties. At room temperature, the height of the potential barrier is 0.6 eV and decreases with temperature and its height at 0 K is 1.32 еV. At low forward biases, the dominant mechanism of current transport in the structure is superbarrier emission. With an increase in forward voltage from 0.1 V to 0.6 V, the generation-recombination mechanism prevails, and with an increase in temperature, an increase in the contribution of tunnel current is observed. At low reverse voltages, the I-V characteristics of diodes are well described by the formula for the generation current. The depth of occurrence of donor energy levels, from which thermal generation of charge carriers occurs is 0.15 eV.

  • Open Access

    Photodetectors for X- and γ-Ray Scintillators

    by Mykola S. Kukurudziak, Ivan P. Koziarskyi, Mykola S. Solodkyi, Eduard V. Maistruk, Vasylyna V. Kopach, Yurii O. Semeniuk, Mykola M. Pavliuk

    The article analyzes X- and γ-ray detectors based on the ionizing and scintillation principles of operation. The effectiveness of using silicon p-i-n and p-n photodiodes in scintillation sensors for detecting visible photoluminescent radiation is investigated. The p-i-n detector was fabricated on the basis of p-type single crystal silicon with orientation [111] and resistivity 8-10 kΩ∙cm. The p-n photodiode was fabricated on the basis of n-type single crystalline silicon with orientation [111] and resistivity 200-300 Ω∙cm. It was found that p-n photodiodes have a much lower dark current than p-i-n photodiodes (although somewhat inferior in sensitivity), which provides their advantage in detectivity. However, if it is necessary to register short pulses of luminescent radiation, p-i-n photodiodes should be used, since they have a higher response speed. The increase in response speed is due to the fact that the process of diffusion of charge carriers in a p-n structure of a photodiode is replaced in the p-i-n structure by the drift of charge carriers through the i-region in a strong electric field.

  • Open Access

    Silicon p-i-n photodiode with reduced crystallographic defect density and structured surface

    by M S Kukurudziak, E V Maistruk, R Yatskiv, I P Koziarskyi, D P Koziarskyi

    This paper reports new methods for reducing the density of structural defects on the surfaces of silicon p-i-n photodiodes (PDs). We experimentally proved that removing the silicon layer with packing defects, which are formed during oxidation, significantly contributes to reducing the density of the dislocations generated after phosphorus diffusion. Compared with the classical diffusion-planar technology for the preparation of silicon-based p-i-n PDs, our methods improve the parameters of PDs, especially dark current, sensitivity, noise equivalent power etc. Removal of the silicon layer is realized by carrying out chemical-dynamic polishing of the wafers after thermal oxidation in the areas of responsive elements. Although the optimum thickness of the etched silicon layer is about 2 μm, which corresponds to an etching time of 30 s, even taking into account the fact that the detector properties will deteriorate with increasing etching time, the change in the ‘maximum spectral response’ is positive. It is demonstrated that the chemical-dynamic polishing is a powerful tool to modify spectral characteristics of PD sensitivity. The maximum of the spectral response can be accurately tailored in a wide spectral range from by changing the chemical-dynamic polishing parameters.


  • Open Access

    Methods of Correction of Spectral Characteristics of Silicon Photodetectors

    by Mykola S. Kukurudziak, Vyacheslav V. Ryukhtin

    The paper investigates methods for shifting the spectral characteristics of silicon photodiodes toward longer wavelengths. It is established that with increasing the reverse bias voltage of the photodiode, the maximum spectral characteristic shifts towards longer wavelengths due to an increase in the collection coefficient of minority charge carriers, which determines the appearance of the spectral characteristic. With an increase in the lifetime of minor charge carriers and the resistivity of the photodiode base material, the maximum of its spectral characteristic also shifts towards longer wavelengths. Increasing the n+-junction depth of the photodiode reduces the effect of background short-wave radiation on the useful signal of the photodiode. Silicon cut-off adsorption light filters have been proposed that eliminate the influence of background radiation with a wavelength of less than 800 nm on the photodiode signal and have a transmittance of about 75% at a wavelength of 1064 nm.

  • Open Access

    Influence of Boron Diffusion on Photovoltaic Parameters of n+-p-p+ Silicone Structures and Based Photodetectors

    by Mykola S. Kukurudziak, Eduard V. Maistruk, Ivan P. Koziarskyi

    The paper investigates the photovoltaic properties of the silicon n+-p-p+-structures and photodiodes made on their basis. It was found that boron diffusion to the reverse side of the substrate, in addition to creating an ohmic contact, generates generation-recombination centers, which allows to reduce the dark current of photodiodes and increase their responsivity. It was also found that chemical dynamic polishing of the back side of the substrates before boron diffusion allows to eliminate a significant number of defects and improve the final parameters of the products. In samples without a p+-layer and samples not polished from the back side, a breakdown of the p-n junction is observed on the back side, which is caused by the expansion of the space charge region to the entire thickness of the substrate and the achievement of a defective back side of the crystal.


  • Open Access

    Silicon p-i-n Mesa-Photodiode Technology

    by Mykola S. Kukurudziak, Volodymyr M. Lipka, Vyacheslav V. Ryukhtin

    The paper proposes the technology of silicon p-i-n mesa-photodiodes, which allows to exclude one high-temperature operation from the technological route. Reducing the number of thermal operations reduces the degree of degradation of the electro-physical characteristics of silicon during heat treatment, which also contributes to reducing the density of surface states at the SiSiO2 interface. It is proposed to etch the mesa-profile by the method of chemical-dynamic polishing using a gold masking coating. The obtained photodiodes are cheaper than serial samples made by diffusion-planar technology and have higher sensitivity.