Yefei Li
Yefei Li has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Cheng Liu
National Space Science Center, Beijing 100190, China
1 shared publication - Fei Wei
National Space Science Center, Chinese Academy of Sciences, Beijing 100190, China
1 shared publication - Guojun Du
Beijing Institute of Space Mechanics & Electricity, Beijing 100194, China
1 shared publication - Hao Zhang
National Space Science Center, Beijing 100190, China
1 shared publication - Jian Xu
National Space Science Center Chinese Academy of Sciences Beijing China
1 shared publication - Jinduo Wang
National Key Laboratory of Scattering and Radiation, Beijing 100854, China
1 shared publication
Latest Publications
- Open Access
- 7 May 2026
- Published by MDPI AG in Remote Sensing
- Vol. 18 (10) , 1456
Pre-Launch Calibration and Performance Evaluation of OMS-N Onboard the FY-3F Satellite
The Ozone Monitor Suite-Nadir (OMS-N) onboard the FY-3F satellite is a key payload for global atmospheric ozone and trace gas detection. The data quality depends on the accuracy of ground calibration. This study presents a systematic ground calibration of OMS-N. The instrument operates over 250–500 nm, with a spatial resolution of 7 × 7 km2 and a spectral resolution of 0.5–1 nm. Radiometric calibration was performed using an integrating sphere, spectral calibration using a tunable laser, and geometric calibration using a precision turntable. All tests were conducted under controlled environmental conditions (20 ± 3 °C and 50% ± 10% humidity). The absolute radiometric calibration uncertainty was below 2.33% for UV1/UV2 and 1.69% for VIS, with relative uncertainties ≤1.84%. The spectral wavelength error was ≤0.01 nm for the VIS channel and ≤0.03 nm for the UV1/UV2 channels, and the geometric positioning uncertainty was better than 0.1 pixels. All performance indicators met or exceeded the design requirements. These results provide technical support for the quantitative application of OMS-N data in atmospheric monitoring and establish a reference framework for the ground calibration of similar ultraviolet hyperspectral instruments.
- 7 May 2026
- Published by MDPI AG in Remote Sensing
- Vol. 18 (10) , 1456
Open AccessPre-Launch Calibration and Performance Evaluation of OMS-N Onboard the FY-3F Satellite
The Ozone Monitor Suite-Nadir (OMS-N) onboard the FY-3F satellite is a key payload for global atmospheric ozone and trace gas detection. The data quality depends on the accuracy of ground calibration. This study presents a systematic ground calibration of OMS-N. The instrument operates over 250–500 nm, with a spatial resolution of 7 × 7 km2 and a spectral resolution of 0.5–1 nm. Radiometric calibration was performed using an integrating sphere, spectral calibration using a tunable laser, and geometric calibration using a precision turntable. All tests were conducted under controlled environmental conditions (20 ± 3 °C and 50% ± 10% humidity). The absolute radiometric calibration uncertainty was below 2.33% for UV1/UV2 and 1.69% for VIS, with relative uncertainties ≤1.84%. The spectral wavelength error was ≤0.01 nm for the VIS channel and ≤0.03 nm for the UV1/UV2 channels, and the geometric positioning uncertainty was better than 0.1 pixels. All performance indicators met or exceeded the design requirements. These results provide technical support for the quantitative application of OMS-N data in atmospheric monitoring and establish a reference framework for the ground calibration of similar ultraviolet hyperspectral instruments.
- Open Access
- 2 January 2023
- Published by MDPI AG in Electronics
- Vol. 12 (1) , 224
A Low Phase Noise Frequency Synthesizer with a Fourth-Order RLC Loop Filter
The current work employs the HMC830 phase-locked loop chip to design a frequency synthesizer operating in the L-band. The frequency synthesizer can provide a local oscillation signal for the RF receiver front end. This article employs the phase-locked synthesis technique to describe the design scheme. Due to the advantages of the passive loop filters, such as simplicity, low cost, and low phase noise, a passive fourth-order RLC loop filter is proposed to improve the output signal quality and reduce phase noise. The performance of this loop filter is compared with the passive fourth-order RC loop filter. The effects of these two loop filters on phase noise, loop capture time, and spur suppression are analyzed. Subsequently, the design scheme, simulation analysis, and test results of the frequency synthesizer are presented under these two loop filters. The test results indicate that the passive fourth-order RLC loop filter outperforms the passive fourth-order RC loop filter; its output signal phase noise is higher than −100 dBc/Hz@1 kHz, loop capture time is less than 100 us, and spur suppression is better than 60 dBc. This frequency synthesizer can provide high-performance local oscillation signals for wireless communication equipment such as transmitters and receivers. It meets the application requirements of many radio communication circuit structures and has good application prospects.
- 2 January 2023
- Published by MDPI AG in Electronics
- Vol. 12 (1) , 224
Open AccessA Low Phase Noise Frequency Synthesizer with a Fourth-Order RLC Loop Filter
The current work employs the HMC830 phase-locked loop chip to design a frequency synthesizer operating in the L-band. The frequency synthesizer can provide a local oscillation signal for the RF receiver front end. This article employs the phase-locked synthesis technique to describe the design scheme. Due to the advantages of the passive loop filters, such as simplicity, low cost, and low phase noise, a passive fourth-order RLC loop filter is proposed to improve the output signal quality and reduce phase noise. The performance of this loop filter is compared with the passive fourth-order RC loop filter. The effects of these two loop filters on phase noise, loop capture time, and spur suppression are analyzed. Subsequently, the design scheme, simulation analysis, and test results of the frequency synthesizer are presented under these two loop filters. The test results indicate that the passive fourth-order RLC loop filter outperforms the passive fourth-order RC loop filter; its output signal phase noise is higher than −100 dBc/Hz@1 kHz, loop capture time is less than 100 us, and spur suppression is better than 60 dBc. This frequency synthesizer can provide high-performance local oscillation signals for wireless communication equipment such as transmitters and receivers. It meets the application requirements of many radio communication circuit structures and has good application prospects.