JEJacob Ewing

Jacob Ewing

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Jacob Ewing has a total of 40 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Properties of V-defect injectors in long wavelength GaN LEDs studied by near-field electro- and photoluminescence

    by Rinat Yapparov, Tanay Tak, Jacob Ewing, Shuji Nakamura, Steven P. DenBaars, James S. Speck, Saulius Marcinkevičius

    The efficiency of multiple quantum well (QW) light emitting diodes (LEDs) to a large degree depends on uniformity of hole distribution between the QWs. Typically, transport between the QWs takes place via carrier capture into and thermionic emission out of the QWs. In InGaN/GaN QWs, the thermionic hole transport is hindered by the high quantum confinement and polarization barriers. To overcome this drawback, hole injection through semipolar QWs located at sidewalls of V-defects had been proposed. However, in the case of the V-defect injection, strong lateral emission variations take place. In this work, we explore the nature of these variations and the impact of the V-defects on the emission spectra and carrier dynamics. The study was performed by mapping electroluminescence (EL) and photoluminescence (PL) with a scanning near-field optical microscope in LEDs that contain a deeper well that can only be populated by holes through the V-defects. Applying different excitation schemes (electrical injection and optical excitation in the far- and near-field), we have shown that the EL intensity variations are caused by the lateral nonuniformity of the hole injection. We have also found that, in biased structures, the PL intensity and decay time in the V-defect regions are only moderately lower that in the V-defect-free regions thus showing no evidence of an efficient Shockley-–Read–Hall recombination. In the V-defect regions, the emission spectra experience a red shift and increased broadening, which suggests an increase of the In content and well width in the polar QWs close to the V-defects.


  • Open Access

    Advances in InGaN-based RGB micro-light-emitting diodes for AR applications: Status and perspective

    by Panpan Li, Jacob Ewing, Matthew S. Wong, Yifan Yao, Hongjian Li, Srinivas Gandrothula, Jordan M. Smith, Mike Iza, Shuji Nakamura, Steven P. DenBaars

    Micro-light-emitting diodes (µLEDs) are gathering significant interest as a technology for emerging micro-displays. However, µLEDs encounter numerous obstacles, including size-dependent efficiency loss, poor efficiency of red µLEDs, and challenges associated with the mass transfer and integration of full-color µLEDs. These issues become more acute in ultra-small µLEDs (<5 µm), which were required by the augmented reality (AR) displays. Here, we discuss the principal challenges faced by µLEDs and explore the possible solutions. We highlight recent advances in InGaN-based RGB µLEDs tailored for AR displays. In particular, we discuss the advancements in ultra-small InGaN µLEDs scaled down to 1 µm, the developments in InGaN red µLEDs, and the implementation of tunnel junction-based cascaded InGaN µLEDs for monolithic integration.


  • Dislocation half-loop control for optimal V-defect density in GaN-based light emitting diodes

    by Alejandro Quevedo, Feng Wu, Tsung-Yin Tsai, Jacob J. Ewing, Tanay Tak, Srinivas Gandrothula, Stephen Gee, Xianqing Li, Shuji Nakamura, Steven P. DenBaars, et al.

    V-defects are morphological defects that typically form on threading dislocations during epitaxial growth of (0001)-oriented GaN layers. A V-defect is a hexagonal pyramid-shaped depression with six {101¯1}-oriented sidewalls. These semipolar sidewalls have a lower polarization barrier than the polarization barriers present between the polar c-plane quantum wells and quantum barriers and can laterally inject carriers directly into quantum wells in GaN-based light emitting diodes (LEDs). This is especially important, as the high polarization field in c-plane GaN is a significant factor in the high forward voltage of GaN LEDs. The optimal V-defect density for efficient lateral carrier injection in a GaN LED (∼109 cm−2) is typically an order of magnitude higher than the threading dislocation density of GaN grown on patterned sapphire substrates (∼108 cm−2). Pure-edge dislocation loops have been known to exist in GaN, and their formation into large V-defects via low-temperature growth with high Si-doping has recently been studied. Here, we develop a method for pure-edge threading dislocation half-loop formation and density control via disilane flow, growth temperature, and thickness of the half-loop generation layer. We also develop a method of forming the threading dislocation half-loops into V-defects of comparable size to those originating from substrate threading dislocations.


  • Open Access

    Carrier diffusion in long wavelength InGaN quantum well LEDs after injection through V-defects

    by Rinat Yapparov, Tanay Tak, Jacob Ewing, Feng Wu, Shuji Nakamura, Steven P. DenBaars, James S. Speck, Saulius Marcinkevičius

    The efficiency of operation of GaN-based light emitting diodes (LEDs) to a large degree relies on realization of a uniform hole distribution between multiple quantum wells (QWs) of the active region. Since the direct thermionic transport between the QWs is inefficient, the hole injection through semipolar 101¯1 QWs that form on the facets of V-defects has been suggested as an alternative approach. However, for an efficient LED operation, the carrier distribution should be uniform not only vertically, between the QWs but also laterally, within individual QWs. In this work, the lateral carrier distribution in long wavelength InGaN/GaN QW LEDs is studied by the scanning near-field optical microscopy. The measurements have shown that emission is concentrated around the V-defect injectors. At high currents, the diffusion length of holes in polar QWs was found to be ∼0.6–1 μm and the hole diffusion coefficient ∼0.6 cm2/s. The obtained data should aid design of the V-defect injectors for a laterally uniform carrier distribution in the active region QWs.


  • Open Access

    Erratum: “Planarization of p-GaN surfaces on MOCVD grown V-defect engineered GaN-based LEDs” [Appl. Phys. Lett. 124, 172102 (2024)]

    by Tanay Tak, Alejandro Quevedo, Feng Wu, Srinivas Gandrothula, Jacob J. Ewing, Stephen Gee, Shuji Nakamura, Steven P. DenBaars, James S. Speck

    The original article's Fig. 5(e)1 did not display the dashed lines as intended, and there were a few typographical errors in the caption of Fig. 5. The original article's Fig. 5(e)1 did not display the dashed lines as intended, and there were a few typographical errors in the caption of Fig. 5.

  • Planarization of p-GaN surfaces on MOCVD grown V-defect engineered GaN-based LEDs

    by Tanay Tak, Alejandro Quevedo, Feng Wu, Srinivas Gandrothula, Jacob J. Ewing, Stephen Gee, Shuji Nakamura, Steven P. DenBaars, James S. Speck

    The large polarization barriers between the quantum wells and quantum barriers in long-wavelength GaN-based light-emitting diodes (LEDs) inhibit their performance by requiring excess driving voltages to reach standard operating current densities. Lateral injection of carriers directly into quantum wells is required to circumvent this issue. V-defects are naturally occurring inverted hexagonal defects with semipolar 101¯1-plane sidewalls generated on surface depressions from threading dislocations. LEDs engineered to intentionally generate V-defects below the active region of the LED can achieve lateral carrier injection through the V-defect sidewalls and have already been able to demonstrate world record wall-plug efficiencies for LEDs in the green-red wavelengths. V-defects can be enlarged during kinetically limited growth where the growth rate of the c-plane GaN is faster than that of their sidewalls, leaving them unfilled. We report on the metal organic chemical vapor deposition growth conditions required to fill in V-defects with p-GaN during epitaxial growth of the LED post the active region. Circular transmission length measurements of Pd/Au contacts processed on p-GaN surfaces with various amounts of unfilled V-defects showed no significant difference in their sheet resistance and specific contact resistance. J–V measurements of LEDs grown with varying unfilled V-defect densities showed no significant difference in the forward bias regime. However, in the reverse bias regime, catastrophic breakdown occurred at markedly lower voltages for samples with larger unfilled V-defect densities. This suggests that unfilled V-defects may act as hotspots for device failure, and planarizing LED surfaces may help prevent early degradation of LED devices.


  • High external quantum efficiency (6.5%) InGaN V-defect LEDs at 600 nm on patterned sapphire substrates

    by Jacob J. Ewing, Cheyenne Lynsky, Matthew S. Wong, Feng Wu, Yi Chao Chow, Pavel Shapturenka, Michael Iza, Shuji Nakamura, Steven P. Denbaars, James S. Speck

    Highly efficient long-wavelength InGaN LEDs have been a research focus in nitride LEDs for their potential applications in displays and solid-state lighting. A key breakthrough has been the use of laterally injected quantum wells via naturally occurring V-defects which promote hole injection through semipolar sidewalls and help to overcome the barriers to carrier injection that plague long wavelength nitride LEDs. In this article, we study V-defect engineered LEDs on (0001) patterned sapphire substrates (PSS) and GaN on (111) Si. V-defects were formed using a 40-period InGaN/GaN superlattice and we report a packaged external quantum efficiency (EQE) of 6.5% for standard 0.1 mm2. LEDs on PSS at 600 nm. We attribute the high EQE in these LEDs to lateral injection via V-defects.


  • Open Access

    Experimental evidence of hole injection through V-defects in long wavelength GaN-based LEDs

    by Saulius Marcinkevičius, Jacob Ewing, Rinat Yapparov, Feng Wu, Shuji Nakamura, James S. Speck

    Hole injection through V-defect sidewalls into all quantum wells (QWs) of long wavelength GaN light emitting diodes had previously been proposed as means to increase efficiency of these devices. In this work, we directly tested the viability of this injection mechanism by electroluminescence and time-resolved photoluminescence measurements on a device in which QW furthest away from the p-side of the structure was deeper, thus serving as an optical detector for presence of injected electron–hole pairs. Emission from the detector well confirmed that, indeed, the holes were injected into this QW, which could only take place through the 101¯1 V-defect sidewalls. Unlike direct interwell transport by thermionic emission, this transport mechanism allows populating all QWs of a multiple QW structure despite the high potential barriers in the long wavelength InGaN/GaN QWs.


  • Open Access

    Origins of the high-energy electroluminescence peaks in long-wavelength (∼495–685 nm) InGaN light-emitting diodes

    by Yi Chao Chow, Tanay Tak, Feng Wu, Jacob Ewing, Shuji Nakamura, Steven P. DenBaars, Yuh-Renn Wu, Claude Weisbuch, James S. Speck

    We investigate the unexpected high-energy electroluminescence (EL) peaks observed in long-wavelength InGaN light-emitting diodes (LEDs) with ground state emission peaks between ∼495 and 685 nm by studying the EL spectra of LEDs with varying quantum well (QW) thicknesses and indium compositions. In addition to the ground state emission, two high-energy emission peaks were observed in the LEDs with thick QWs and high indium compositions. The less energetic high-energy emission peak (2.4–2.6 eV) is attributed to the optical transitions involving excited states. Factors influencing the excited state transitions, such as the QW thickness and indium compositions, were also examined by simulations to better understand the occurrence of these transitions. The more energetic high-energy emission peak (2.8–3.1 eV) originates from V-defect sidewalls and was verified through micro-photoluminescence measurements. Identification of the high-energy emission peaks is essential as it enables targeted epitaxial or growth optimizations to minimize or eliminate these undesirable emission peaks. This work demonstrates the importance of using thin QWs to suppress the unwanted high-energy emissions due to excited state transitions and V-defect sidewalls for long-wavelength InGaN LEDs.


  • Open Access

    Structure of V-defects in long wavelength GaN-based light emitting diodes

    by Feng Wu, Jacob Ewing, Cheyenne Lynsky, Michael Iza, Shuji Nakamura, Steven P. DenBaars, James S. Speck

    The V-defect is a naturally occurring inverted hexagonal pyramid structure that has been studied in GaN and InGaN growth since the 1990s. Strategic use of V-defects in pre-quantum well superlattices or equivalent preparation layers has enabled record breaking efficiencies for green, yellow, and red InGaN light emitting diodes (LEDs) utilizing lateral injection of holes through the semi-polar sidewalls of the V-defects. In this article, we use advanced characterization techniques such as scattering contrast transmission electron microscopy, high angle annular dark field scanning transmission electron microscopy, x-ray fluorescence maps, and atom probe tomography to study the active region compositions, V-defect formation, and V-defect structure in green and red LEDs grown on (0001) patterned sapphire and (111) Si substrates. We identify two distinct types of V-defects. The “large” V-defects are those that form in the pre-well superlattice and promote hole injection, usually nucleating on mixed (Burgers vector b=±a±c) character threading dislocations. In addition, “small” V-defects often form in the multi-quantum well region and are believed to be deleterious to high-efficiency LEDs by providing non-radiative pathways. The small V-defects are often associated with basal plane stacking faults or stacking fault boxes. Furthermore, we show through scattering contrast transmission electron microscopy that during V-defect filling, the threading dislocation, which runs up the center of the V-defect, will “bend” onto one of the six {101¯1} semi-polar planes. This result is essential to understanding non-radiative recombination in V-defect engineered LEDs.