Weijie Zheng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Weijie Zheng has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Ariya Zibibula
Engineering and Technology Research Institute, Xinjiang Oilfield Company, CNPC, Karamay 834000, China
1 shared publication - Bin Wang
Oil Production Technology Research Institute, PetroChina Xinjiang Oilfield Company, Karamay 834000, China
1 shared publication - Binfei Li
School of Petroleum Engineering, China University of Petroleum (East China), Qingdao 266580, China
1 shared publication - Feipeng Han
Engineering and Technology Research Institute, Xinjiang Oilfield Company, CNPC, Karamay 834000, China
1 shared publication - Kaixin Liu
Oil Production Technology Research Institute, PetroChina Xinjiang Oilfield Company, Karamay 834000, China
1 shared publication - Lei Wang
School of Petroleum Engineering, Yangtze University, Wuhan 430100, China
1 shared publication
Latest Publications
- Open Access
Experimental Study on Stress Sensitivity in Fractured Tight Conglomerate Reservoirs
Tight conglomerate reservoirs are characterized by dense lithology, significant compositional contrasts between cement and gravel, strong stress gravel content, strong heterogeneity, and uneven spatial distribution, which collectively result in low porosity, complex pore–throat structures, and low permeability. After hydraulic fracturing, the stress sensitivity of tight conglomerate reservoirs is jointly governed by the rock matrix and induced fractures. In this study, the Mahu tight conglomerate reservoir in the Xinjiang Oilfield was selected as the research target. Stress sensitivity experiments were conducted on conglomerate matrix cores and on cores with varying fracture conditions. After stress loading, the degrees of permeability damage of the matrix, through-fracture, double short-fracture, and microfracture cores were 41%, 69%, 93%, and 97%, respectively. The matrix exhibited moderate-to-weak stress sensitivity, the through-fracture cores showed moderate-to-strong stress sensitivity, while the double short-fracture and microfracture cores exhibited strong stress sensitivity. Experimental results indicate that when fractures are present, the stress sensitivity of the core is primarily controlled by fracture closure and matrix compression. As fracture development increases, core permeability is significantly enhanced; however, stress sensitivity also increases accordingly. Under net stress, gravel protrusions embed into fracture surfaces, reducing surface roughness, while irreversible alteration of fracture geometry becomes the dominant factor driving stress sensitivity in fractured cores. These findings provide a scientific basis for predicting stress-sensitivity-induced damage in tight conglomerate reservoirs.
Open AccessExperimental Study on Stress Sensitivity in Fractured Tight Conglomerate Reservoirs
Tight conglomerate reservoirs are characterized by dense lithology, significant compositional contrasts between cement and gravel, strong stress gravel content, strong heterogeneity, and uneven spatial distribution, which collectively result in low porosity, complex pore–throat structures, and low permeability. After hydraulic fracturing, the stress sensitivity of tight conglomerate reservoirs is jointly governed by the rock matrix and induced fractures. In this study, the Mahu tight conglomerate reservoir in the Xinjiang Oilfield was selected as the research target. Stress sensitivity experiments were conducted on conglomerate matrix cores and on cores with varying fracture conditions. After stress loading, the degrees of permeability damage of the matrix, through-fracture, double short-fracture, and microfracture cores were 41%, 69%, 93%, and 97%, respectively. The matrix exhibited moderate-to-weak stress sensitivity, the through-fracture cores showed moderate-to-strong stress sensitivity, while the double short-fracture and microfracture cores exhibited strong stress sensitivity. Experimental results indicate that when fractures are present, the stress sensitivity of the core is primarily controlled by fracture closure and matrix compression. As fracture development increases, core permeability is significantly enhanced; however, stress sensitivity also increases accordingly. Under net stress, gravel protrusions embed into fracture surfaces, reducing surface roughness, while irreversible alteration of fracture geometry becomes the dominant factor driving stress sensitivity in fractured cores. These findings provide a scientific basis for predicting stress-sensitivity-induced damage in tight conglomerate reservoirs.
- Open Access
Study on Salt Dissolution Law of High Salinity Reservoir and Its Influence on Fracturing
For the high-salt reservoir of the Fengcheng Formation in the Mahu area, the production decreases rapidly due to the conductivity decrease after fracturing. The analysis shows that this has a great relationship with the special salt dissolution characteristics of the High salinity reservoir. In order to study the problem of salt dissolution pattern, the effect of different temperatures, the salt concentration of fracturing fluid, the viscosity of fracturing fluid, and injection rate on the rate of salt dissolution was evaluated by using the dynamic experimental evaluation method of salt dissolution. Through the grey correlation analysis of salt rock dissolution rate, it can be found that the degree of influence is from large to small which the influence of temperature is greater than fracturing fluid velocity, followed by fracturing fluid viscosity and, finally, fracturing fluid salt concentration. The results of compressive strength tests on salt-bearing rocks after dissolution show that the compressive strength is greatly reduced after salt dissolution by more than 60%. At the same time, the test results of proppant-free conductivity showed that the conductivity increased first and then decreased sharply after salt dissolution. This shows that in the early stage of salt dissolution, the flow channel will increase through dissolution. The rock strength decreases greatly with the increase of salt dissolution. As a result, collapse leads to a sharp reduction in the facture conductivity. Therefore, it is necessary to choose saturated brine fracturing fluid. In the proppant conductivity experiments, by optimizing the use of saturated brine fracturing fluid with 30/50 mesh or 20/40 mesh ceramic proppant with a sand concentration of 5 Kg/m2, a high facture conductivity can be achieved under high closure pressure conditions. Based on the above study, directions and countermeasures for improving high saline reservoirs are proposed, which point the way to improve the fracturing conductivity.
Open AccessStudy on Salt Dissolution Law of High Salinity Reservoir and Its Influence on Fracturing
For the high-salt reservoir of the Fengcheng Formation in the Mahu area, the production decreases rapidly due to the conductivity decrease after fracturing. The analysis shows that this has a great relationship with the special salt dissolution characteristics of the High salinity reservoir. In order to study the problem of salt dissolution pattern, the effect of different temperatures, the salt concentration of fracturing fluid, the viscosity of fracturing fluid, and injection rate on the rate of salt dissolution was evaluated by using the dynamic experimental evaluation method of salt dissolution. Through the grey correlation analysis of salt rock dissolution rate, it can be found that the degree of influence is from large to small which the influence of temperature is greater than fracturing fluid velocity, followed by fracturing fluid viscosity and, finally, fracturing fluid salt concentration. The results of compressive strength tests on salt-bearing rocks after dissolution show that the compressive strength is greatly reduced after salt dissolution by more than 60%. At the same time, the test results of proppant-free conductivity showed that the conductivity increased first and then decreased sharply after salt dissolution. This shows that in the early stage of salt dissolution, the flow channel will increase through dissolution. The rock strength decreases greatly with the increase of salt dissolution. As a result, collapse leads to a sharp reduction in the facture conductivity. Therefore, it is necessary to choose saturated brine fracturing fluid. In the proppant conductivity experiments, by optimizing the use of saturated brine fracturing fluid with 30/50 mesh or 20/40 mesh ceramic proppant with a sand concentration of 5 Kg/m2, a high facture conductivity can be achieved under high closure pressure conditions. Based on the above study, directions and countermeasures for improving high saline reservoirs are proposed, which point the way to improve the fracturing conductivity.