Sk Rafidul
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Sk Rafidul has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Debatosh Guha
Institute of Radio Physics and Electronics, University of Calcutta, Kolkata, India
7 shared publications - Chandrakanta Kumar
Communication Systems Group, U R Rao Satellite Centre, Department of Space, Government of India, Bangalore, India
5 shared publications - Bo Liu
James Watt School of Engineering, University of Glasgow, Glasgow, U.K.
1 shared publication - Chandreyee Sarkar
Institute of Radio Physics and Electronics, University of Calcutta, 92, A. P. C. Road, Kolkata-700009, India
1 shared publication - Debashis Das
National Institute of Technology of Arunachal Pradesh, Jote, India
1 shared publication - Debi Dutta
Department of Information Engineering, University of Pisa, Pisa, Italy
1 shared publication
Latest Publications
- 20 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 24 (7) , 1675-1678
An Alternate Technique Explored to Realize Half-Wave Electric Dipole Using Dielectric Resonators
This work, for the first time, reports the realization of a half-wave electric dipole-like radiator using dielectric resonators. The design challenges have been systematically addressed and a C-band prototype has been realized from Al2O3 material (ϵr = 9.8, loss tangent = 0.0001) as a proof of concept. It consists of a pair of back-to-back rectangular dielectric resonators (DR) on grounded substrates. Both elements are coupled through ground-apertures and excited by a single stripline to resonate with TEδ11 mode. Strategic engineering with the ground plane (GP) has been envisaged and established as a robust technique. A standard electric dipole-like radiations have been experimentally tested revealing 3.32 dBi to 3.98 dBi gain across the matching bandwidth. Importantly, it offers about 1.2 dB-1.8 dB improvement in the gain value compared to a standard dipole. The utility of such a device would be best understood at mm-wave domain where the physical dimension of a traditional half-wave electric dipole may go below 5-6 mm. The proposed approach may offer a doable solution in such cases and an evidence has been discussed.
- 20 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 24 (7) , 1675-1678
An Alternate Technique Explored to Realize Half-Wave Electric Dipole Using Dielectric Resonators
This work, for the first time, reports the realization of a half-wave electric dipole-like radiator using dielectric resonators. The design challenges have been systematically addressed and a C-band prototype has been realized from Al2O3 material (ϵr = 9.8, loss tangent = 0.0001) as a proof of concept. It consists of a pair of back-to-back rectangular dielectric resonators (DR) on grounded substrates. Both elements are coupled through ground-apertures and excited by a single stripline to resonate with TEδ11 mode. Strategic engineering with the ground plane (GP) has been envisaged and established as a robust technique. A standard electric dipole-like radiations have been experimentally tested revealing 3.32 dBi to 3.98 dBi gain across the matching bandwidth. Importantly, it offers about 1.2 dB-1.8 dB improvement in the gain value compared to a standard dipole. The utility of such a device would be best understood at mm-wave domain where the physical dimension of a traditional half-wave electric dipole may go below 5-6 mm. The proposed approach may offer a doable solution in such cases and an evidence has been discussed.
- 31 December 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 24 (4) , 1008-1012
Machine Learning-Assisted Microstrip Antenna Design Featuring Extraordinary Polarization Purity
A high degree of polarization purity for microstrip antennas has been successfully explored. This, to the best of our knowledge, is the first of its kind and claims a two-fold novelty: (i) a stepwise development of complex multi-unit defected ground geometry (DGG) based on a thorough scientific analysis, and (ii) use of a machine learning-assisted global antenna optimization method, particularly, the parallel surrogate model-assisted hybrid differential evolution for antenna synthesis (PSADEA) algorithm, which is often more than 10 times faster than popular global optimization techniques, while obtaining superior results. They result in highly optimal solutions considering multiple performances, i.e., reduction in cross-pol (XP) radiations simultaneously over orthogonal (H-) and diagonal (D-) planes maintaining the primary gain unaffected. The proposed DGG has been satisfactorily tested with different patches and arrays fabricated in C-band. Typically, 7.5-8.0 dBi peak gain has been ensured along with 13-18 dB improvement in XP level over entire radiation planes. A 4-element array on an identical DGG promises over 40 dB co-to-XP isolation over the entire azimuth planes.
- 31 December 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 24 (4) , 1008-1012
Machine Learning-Assisted Microstrip Antenna Design Featuring Extraordinary Polarization Purity
A high degree of polarization purity for microstrip antennas has been successfully explored. This, to the best of our knowledge, is the first of its kind and claims a two-fold novelty: (i) a stepwise development of complex multi-unit defected ground geometry (DGG) based on a thorough scientific analysis, and (ii) use of a machine learning-assisted global antenna optimization method, particularly, the parallel surrogate model-assisted hybrid differential evolution for antenna synthesis (PSADEA) algorithm, which is often more than 10 times faster than popular global optimization techniques, while obtaining superior results. They result in highly optimal solutions considering multiple performances, i.e., reduction in cross-pol (XP) radiations simultaneously over orthogonal (H-) and diagonal (D-) planes maintaining the primary gain unaffected. The proposed DGG has been satisfactorily tested with different patches and arrays fabricated in C-band. Typically, 7.5-8.0 dBi peak gain has been ensured along with 13-18 dB improvement in XP level over entire radiation planes. A 4-element array on an identical DGG promises over 40 dB co-to-XP isolation over the entire azimuth planes.
- Open Access
- 16 February 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Antennas and Propagation
- Vol. 5 (2) , 516-524
A Way to Address Inherent Weakness in Conceiving the Ground Plane Geometry for a Microstrip Antenna
This work presents an insight into the nature of ground plane (GP) current of a microstrip patch which is truly adverse in terms of generating cross-polar (XP) fields and minimally contributing to the primary radiation. This study also uses a theoretical basis in exploring a simple solution to mitigate the high XP values, specifically over the diagonal planes (D-planes). This actually turns out to be an engineered GP by clipping off its four corners. This has been thoroughly studied for a set of representative patch geometries and experimentally verified. A consistent XP reduction by 12-13 dB over D-planes has been ensured without affecting the impedance matching or antenna gains. This eventually results in cross-polar discrimination (XPD) of the order of 25-31 dB uniformly over the full range of operating bandwidth. In addition, the design is advantageous in terms of reduction in antenna size or the deployment area. Such a simple low-cost design appears as truly improved alternative to a typical standalone microstrip radiator for practical applications.
- 16 February 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Antennas and Propagation
- Vol. 5 (2) , 516-524
Open AccessA Way to Address Inherent Weakness in Conceiving the Ground Plane Geometry for a Microstrip Antenna
This work presents an insight into the nature of ground plane (GP) current of a microstrip patch which is truly adverse in terms of generating cross-polar (XP) fields and minimally contributing to the primary radiation. This study also uses a theoretical basis in exploring a simple solution to mitigate the high XP values, specifically over the diagonal planes (D-planes). This actually turns out to be an engineered GP by clipping off its four corners. This has been thoroughly studied for a set of representative patch geometries and experimentally verified. A consistent XP reduction by 12-13 dB over D-planes has been ensured without affecting the impedance matching or antenna gains. This eventually results in cross-polar discrimination (XPD) of the order of 25-31 dB uniformly over the full range of operating bandwidth. In addition, the design is advantageous in terms of reduction in antenna size or the deployment area. Such a simple low-cost design appears as truly improved alternative to a typical standalone microstrip radiator for practical applications.
- Open Access
- 14 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Antennas and Propagation
- Vol. 4, 754-763
A Technique to Realize Aperture Coupled Microstrip Patch as a Truly Low Cross-Polar Antenna by Mitigating the Major Issues Over its Skewed Radiation Planes
Aperture-fed microstrip patch is typically known for its low cross-polarized (XP) radiations, however it stands true only over its orthogonal plane. The same, over the diagonal planes are as high as that for any other common feeds. This specific issue has been addressed and successfully resolved by proposing a technique for the first time. This introduces a pair of additional printed loops adjacent to the radiating patch. Detailed investigations leading to the design insight have been presented. A C-band rectangular patch promises as much as 7 dB suppression in the diagonal plane XP level keeping the overall performance across the principal radiation planes unchanged. This is an important step in keeping the XP levels for an aperture-fed antenna truly low thus maintaining more than 22 dB of co-to cross-polar isolation over the entire azimuth.
- 14 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Antennas and Propagation
- Vol. 4, 754-763
Open AccessA Technique to Realize Aperture Coupled Microstrip Patch as a Truly Low Cross-Polar Antenna by Mitigating the Major Issues Over its Skewed Radiation Planes
Aperture-fed microstrip patch is typically known for its low cross-polarized (XP) radiations, however it stands true only over its orthogonal plane. The same, over the diagonal planes are as high as that for any other common feeds. This specific issue has been addressed and successfully resolved by proposing a technique for the first time. This introduces a pair of additional printed loops adjacent to the radiating patch. Detailed investigations leading to the design insight have been presented. A C-band rectangular patch promises as much as 7 dB suppression in the diagonal plane XP level keeping the overall performance across the principal radiation planes unchanged. This is an important step in keeping the XP levels for an aperture-fed antenna truly low thus maintaining more than 22 dB of co-to cross-polar isolation over the entire azimuth.
- 31 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 71 (3) , 2820-2825
Uniformly Improved Cross-Polar Discrimination in a Dielectric Resonator Antenna by Conduction-Current Control
This work, for the first time, investigates the comprehensive sources of cross-polarized (XP) radiation from a dielectric resonator antenna (DRA). The study uses a recently developed theory on DRA radiation and models the XP sources with the help of well-known definition by Ludwig. This eventually focuses on the conduction current distribution on the metallic ground. The interpretation leads to a concept of synthesizing effective conduction current in order to satisfying the required condition of low XP fields. A representative prototype of a cylindrical DRA on engineered ground plane has been realized to operate in C-band. It exhibits nearly 12 % matching bandwidth with more than 25 dB co-to-cross polar discrimination over both orthogonal (H-) and diagonal (D-) planes. Relative improvement in XP level promised by the measured data is ~15 dB in D- and ~10 dB in H-planes. This proof of concept may now be extended to other DRA geometries and for practical applications in the near future.
- 31 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 71 (3) , 2820-2825
Uniformly Improved Cross-Polar Discrimination in a Dielectric Resonator Antenna by Conduction-Current Control
This work, for the first time, investigates the comprehensive sources of cross-polarized (XP) radiation from a dielectric resonator antenna (DRA). The study uses a recently developed theory on DRA radiation and models the XP sources with the help of well-known definition by Ludwig. This eventually focuses on the conduction current distribution on the metallic ground. The interpretation leads to a concept of synthesizing effective conduction current in order to satisfying the required condition of low XP fields. A representative prototype of a cylindrical DRA on engineered ground plane has been realized to operate in C-band. It exhibits nearly 12 % matching bandwidth with more than 25 dB co-to-cross polar discrimination over both orthogonal (H-) and diagonal (D-) planes. Relative improvement in XP level promised by the measured data is ~15 dB in D- and ~10 dB in H-planes. This proof of concept may now be extended to other DRA geometries and for practical applications in the near future.
- 18 November 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 19 (1) , 99-103
Suppression of Cross-Polarized Fields of Microstrip Patch Across All Skewed and Orthogonal Radiation Planes
- 18 November 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 19 (1) , 99-103
Suppression of Cross-Polarized Fields of Microstrip Patch Across All Skewed and Orthogonal Radiation Planes