JKJae-Sub Ko

Jae-Sub Ko

*This is an algorithmically generated author record based on publicly available information.

Jae-Sub Ko has a total of 8 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Design of Fuzzy Controller based on PC for Solar Tracking System

    by Jung-Sik Choi, Do-Yeon Kim, Ki-Tae Park, Chung-Hoon Choi, Dong-Hwa Chung

    In this paper proposed the solar tracking system to use a fuzzy based on PC in order to increase an output of the PV array. The solar tracking system operated two DC motors driving by signal of photo sensor. The control of dual axes is not an easy task due to nonlinear dynamics and unavailability of the parameters. Recently, artificial intelligent control of the fuzzy control, neural-network and genetic algorithm etc. have been studied. The fuzzy control made a nonlinear dynamics to well perform and had a robust and highly efficient characteristic about a parameter variable as well as a nonlinear characteristic. Hence the fuzzy control was used to perform the tracking system after comparing with error values of setting-up, nonlinear altitude and azimuth. In this paper designed a fuzzy controller for improving output of PV array and evaluated comparison with efficient of conventional P controller. The data which were obtained by experiment were able to show a validity of the proposed controller.


  • Maximum Power Point Tracking Control of PV System for DC Motors Drive with Neural Network

    by Jae-Sub Ko, Byung-Jin Jung, Ki-Tae Park, Chung-Hoon Choi, Dong-Hwa Chung

    This paper presents an application of a Neural Network(NN) for Maximum Power Point Tracking (MPPT) of PV supplied DC motor. A variation of solar irradiation is most important factor in the MPPT of PV system. That is nonlinear, aperiodic and complicated. NN was widely used due to easily solving a complex math problem. The paper consists of solar radiation source, DC-DC converter, DC motor and load(cf, pump). NN algorithm apply to DC-DC converter through an Adaptive control of Neural Network, calculates Converter-Chopping ratio using an Adaptive control of NN. The results of an Adaptive control of NN compared with the results of Converter-Chopping ratio which are calculated mathematical modeling and evaluate the proposed algorithm. The experimental data show that an adequacy of the algorithm was established through the compared data.


  • Efficiency Optimization Control of SynRM Drive

    by Jung-Sik Choi, Jae-Sub Ko, Dong-Hwa Chung

    This paper proposes an efficiency optimization control algorithm for a synchronous reluctance motor (SynRM) which minimizes the copper and iron losses. Also, this paper presents a speed estimated control scheme of SynRM using artificial neural network (ANN). There exists a variety of combinations of and -axis current which provide a specific motor torque. The objective of the efficiency optimization controller is to seek a combination of and -axis current components, which provides minimum losses at a certain operating point in steady state. It is shown that the current components which directly govern the torque production have been very well regulated by the efficiency optimization control scheme. The proposed algorithm allows the electromagnetic losses in variable speed and torque drives to be reduced while keeping good torque control dynamics. The control performance of ANN is evaluated by analysis for various operating conditions. Analysis results are presented to show the validity of the proposed algorithm


  • Hybrid Artificial Intelligent Control for Speed Control of Induction motor

    by Jae-Sub Ko, Jung-Sik Choi, Dong-Hwa Chung

    This paper is proposed hybrid artificial intelligent controller for high performance of induction motor drive. The design of this algorithm based on fuzzy-neural network controller that is implemented using fuzzy control and neural network. This controller uses fuzzy rule as training patterns of a neural network. Also, this controller uses the back-propagation method to adjust the weights between the neurons of neural network in order to minimize the error between the command output and actual output. A model reference adaptive scheme is proposed in which the adaptation mechanism is executed by fuzzy logic based on the error and change of error measured between the motor speed and output of a reference model. The control performance of the hybrid artificial intelligent controller is evaluated by analysis for various operating conditions. The results of experiment prove that the proposed control system has strong high performance and robustness to parameter variation, and steady-state accuracy and transient response


  • Maximum Torque Control of IPMSM Drive with LM-FNN Controller

    by Jae-Sub Ko, Jung-Sik Choi, Dong-Hwa Chung

    Interior permanent magnet synchronous motor (IPMSM) has become a popular choice in electric vehicle and servo drive applications due to their excellent power to weight ratio. The paper is proposed maximum torque control of IPMSM drive using learning mechanism-fuzzy neural network (LM-FNN) and artificial neural network (ANN). The control method is applicable over the entire speed range and considered the limits of the inverter's current and voltage rated value. For each control mode, a condition that determines the optimal d-axis current for maximum torque operation is derived. This paper considers the design and implementation of novel technique of high performance speed control for IPMSM using LM-FNN and ANN. The hybrid combination of neural network and fuzzy control will produce a powerful representation flexibility and numerical processing capability. Also, this paper is proposed speed control of IPMSM using LM-FNN and estimation of speed using ANN. The back propagation neural network technique is used to provide a real time adaptive estimation of the motor speed. The proposed control algorithm is applied to IPMSM drive system controlled LM-FNN and ANN, the operating characteristics controlled by maximum torque control are examined in detail. Also, this paper is proposed the experimental results to verify the effectiveness of the LM-FNN and ANN