Dong-Hwa Chung
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Dong-Hwa Chung has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Jae-Sub Ko
DaeyangTech corp., Kwang yang, Korea. Tel: +82-61-793-5925
2 shared publications - Ki-Tae Park
DaeyangTech corp., Kwang yang, Korea. Tel: +82-61-793-5925
2 shared publications - Byung-Jin Jung
Department of Electrical Control Engineering, Sunchon University, Suncheon, Korea. Tel: +82-61-750-3540
1 shared publication - Do-Yeon Kim
Department of Electrical Control Engineering, Sunchon University, Suncheon, Korea. Tel: +82-61-750-3540
1 shared publication - Jae-Sub Ko
Department of Electrical Control Engineering, Sunchon University, Suncheon, Korea. Tel: +82-61-750-3540
1 shared publication - Jung-Sik Choi
Department of Electrical Control Engineering, Sunchon University, Suncheon, Korea. Tel: +82-61-750-3540
1 shared publication
Latest Publications
- 1 April 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 508-513
Design of Fuzzy Controller based on PC for Solar Tracking System
In this paper proposed the solar tracking system to use a fuzzy based on PC in order to increase an output of the PV array. The solar tracking system operated two DC motors driving by signal of photo sensor. The control of dual axes is not an easy task due to nonlinear dynamics and unavailability of the parameters. Recently, artificial intelligent control of the fuzzy control, neural-network and genetic algorithm etc. have been studied. The fuzzy control made a nonlinear dynamics to well perform and had a robust and highly efficient characteristic about a parameter variable as well as a nonlinear characteristic. Hence the fuzzy control was used to perform the tracking system after comparing with error values of setting-up, nonlinear altitude and azimuth. In this paper designed a fuzzy controller for improving output of PV array and evaluated comparison with efficient of conventional P controller. The data which were obtained by experiment were able to show a validity of the proposed controller.
- 1 April 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 508-513
Design of Fuzzy Controller based on PC for Solar Tracking System
In this paper proposed the solar tracking system to use a fuzzy based on PC in order to increase an output of the PV array. The solar tracking system operated two DC motors driving by signal of photo sensor. The control of dual axes is not an easy task due to nonlinear dynamics and unavailability of the parameters. Recently, artificial intelligent control of the fuzzy control, neural-network and genetic algorithm etc. have been studied. The fuzzy control made a nonlinear dynamics to well perform and had a robust and highly efficient characteristic about a parameter variable as well as a nonlinear characteristic. Hence the fuzzy control was used to perform the tracking system after comparing with error values of setting-up, nonlinear altitude and azimuth. In this paper designed a fuzzy controller for improving output of PV array and evaluated comparison with efficient of conventional P controller. The data which were obtained by experiment were able to show a validity of the proposed controller.
- 1 April 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 514-519
Maximum Power Point Tracking Control of PV System for DC Motors Drive with Neural Network
This paper presents an application of a Neural Network(NN) for Maximum Power Point Tracking (MPPT) of PV supplied DC motor. A variation of solar irradiation is most important factor in the MPPT of PV system. That is nonlinear, aperiodic and complicated. NN was widely used due to easily solving a complex math problem. The paper consists of solar radiation source, DC-DC converter, DC motor and load(cf, pump). NN algorithm apply to DC-DC converter through an Adaptive control of Neural Network, calculates Converter-Chopping ratio using an Adaptive control of NN. The results of an Adaptive control of NN compared with the results of Converter-Chopping ratio which are calculated mathematical modeling and evaluate the proposed algorithm. The experimental data show that an adequacy of the algorithm was established through the compared data.
- 1 April 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 514-519
Maximum Power Point Tracking Control of PV System for DC Motors Drive with Neural Network
This paper presents an application of a Neural Network(NN) for Maximum Power Point Tracking (MPPT) of PV supplied DC motor. A variation of solar irradiation is most important factor in the MPPT of PV system. That is nonlinear, aperiodic and complicated. NN was widely used due to easily solving a complex math problem. The paper consists of solar radiation source, DC-DC converter, DC motor and load(cf, pump). NN algorithm apply to DC-DC converter through an Adaptive control of Neural Network, calculates Converter-Chopping ratio using an Adaptive control of NN. The results of an Adaptive control of NN compared with the results of Converter-Chopping ratio which are calculated mathematical modeling and evaluate the proposed algorithm. The experimental data show that an adequacy of the algorithm was established through the compared data.