Chandra Bhal Singh
Research Subjects
Chandra Bhal Singh has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Akhilesh Kumar Singh
School of Materials Science and Technology Indian Institute of Technology (Banaras Hindu University) Varanasi Uttar Pradesh India
6 shared publications Nafis Ahmed
3 shared publicationsP. Balaji Bhargav
3 shared publicationsVandana Singh
3 shared publicationsAkhilesh Kumar Singh
School of Materials Science and Technology
2 shared publicationsBhola Nath Pal
2 shared publications
Latest Publications
- 4 November 2026
- Published by Wiley in ChemistrySelect
- Vol. 11 (42)
Effect of Thin Film Deposition Method on Growth, Structural, and Optical Properties of ZnO:Al Films
Wide bandgap semiconductors such as ZnO:Al are widely researched for UV‐photodetector applications. Here, we report the comparative study of deposition‐method‐dependent AZO thin‐film growth and their functional properties. Structural analysis (XRD) shows that dip‐and spin‐coated films exhibit dominant (101) peak, whereas magnetron‐sputtered films show strong (002) c ‐axis orientation. Williamson–Hall analysis of XRD data indicates that sputtered AZO films have better crystallinity and a tensile microstrain state. Magnetron‐sputtered AZO films have a higher bandgap ( E g = 3.56 eV), but lower Urbach energy ( E U = 173.37 meV) as compared to solution‐processed thin films ( E g = 3.40 eV, E U = 246.7 meV). Surface roughness, FFT, and power spectral density‐based fractal analysis of AFM data further suggest that solution‐processed films exhibit high roughness, diffusion‐limited nucleation, and partial grain coalescence, whereas sputtered films display dense, smooth morphology with uniform grain distribution. I – V characteristics reveal that dip‐coated films exhibit SCLC‐like and trap‐filling‐dominated conduction. In contrast, spin‐coated and sputtered films show near‐Ohmic conduction. The combined analysis establishes a strong correlation between deposition method, microstructure, disorder, and charge transport. These findings highlight the importance of controlling growth conditions to tailor the structural and optoelectronic properties of AZO thin films.
- 4 November 2026
- Published by Wiley in ChemistrySelect
- Vol. 11 (42)
Effect of Thin Film Deposition Method on Growth, Structural, and Optical Properties of ZnO:Al Films
Wide bandgap semiconductors such as ZnO:Al are widely researched for UV‐photodetector applications. Here, we report the comparative study of deposition‐method‐dependent AZO thin‐film growth and their functional properties. Structural analysis (XRD) shows that dip‐and spin‐coated films exhibit dominant (101) peak, whereas magnetron‐sputtered films show strong (002) c ‐axis orientation. Williamson–Hall analysis of XRD data indicates that sputtered AZO films have better crystallinity and a tensile microstrain state. Magnetron‐sputtered AZO films have a higher bandgap ( E g = 3.56 eV), but lower Urbach energy ( E U = 173.37 meV) as compared to solution‐processed thin films ( E g = 3.40 eV, E U = 246.7 meV). Surface roughness, FFT, and power spectral density‐based fractal analysis of AFM data further suggest that solution‐processed films exhibit high roughness, diffusion‐limited nucleation, and partial grain coalescence, whereas sputtered films display dense, smooth morphology with uniform grain distribution. I – V characteristics reveal that dip‐coated films exhibit SCLC‐like and trap‐filling‐dominated conduction. In contrast, spin‐coated and sputtered films show near‐Ohmic conduction. The combined analysis establishes a strong correlation between deposition method, microstructure, disorder, and charge transport. These findings highlight the importance of controlling growth conditions to tailor the structural and optoelectronic properties of AZO thin films.
- 3 September 2026
- Published by Elsevier in Ceramics International
- Vol. 52 (27) , 52350-52365
Off-stoichiometry effects on crystal structure, microstructure, dielectric and ferroelectric properties of (1-x)Bi(Mg3/4W1/4)O3-xPbTiO3 ceramics
- 3 September 2026
- Published by Elsevier in Ceramics International
- Vol. 52 (27) , 52350-52365
Off-stoichiometry effects on crystal structure, microstructure, dielectric and ferroelectric properties of (1-x)Bi(Mg3/4W1/4)O3-xPbTiO3 ceramics
- 19 March 2026
- Published by Elsevier in Optical Materials
- Vol. 175
Enhanced photodetection performance in ferroelectric-driven magnetron sputtered thin film p-Si/Ba(Pr)Ti(Mo,Nb)O3/Ag devices
- 19 March 2026
- Published by Elsevier in Optical Materials
- Vol. 175
Enhanced photodetection performance in ferroelectric-driven magnetron sputtered thin film p-Si/Ba(Pr)Ti(Mo,Nb)O3/Ag devices
- 2 March 2026
- Published by American Chemical Society (ACS) in ACS Applied Optical Materials
- Vol. 4 (3) , 785-799
Surface Morphology-Dependent Photodetection of the Magnetron-Sputtered Nb-Doped BaTiO 3 Ferroelectric Thin Film Device
- 2 March 2026
- Published by American Chemical Society (ACS) in ACS Applied Optical Materials
- Vol. 4 (3) , 785-799
Surface Morphology-Dependent Photodetection of the Magnetron-Sputtered Nb-Doped BaTiO 3 Ferroelectric Thin Film Device
- Open Access
- 18 September 2025
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 10 (38) , 43779-43796
Doping-Induced Relaxor Ferroelectricity and Site Engineering in Ba1–xPr2x/3Ti1–y(Mo1/2Nb1/2)yO3 Ceramics for Enhanced Permittivity and Energy Storage Performance
In this study, site engineering at the Ba and Ti sites of BaTiO3 has been done to develop Ba1-x Pr2x/3Ti1-y (Mo1/2Nb1/2) y O3 [BTMN] ceramics, with x = 0.003 and y = 0.02, 0.04, 0.06, 0.08, 0.1, to improve permittivity and energy storage performance. The solid-state reaction method was used to synthesize samples. X-ray diffraction analysis revealed a crystallographic phase transition from tetragonal (P4mm) to cubic (Pm-3m) structure with increasing (Mo1/2Nb1/2) concentration. Raman spectroscopy further validates this finding with the disappearance of the characteristic tetragonal peak at 303 cm-1 for higher dopant levels (y ≥ 0.06). Grain size displays a nonlinear trend where grain size first increases to 0.49 μm for intermediate compositions and then decreases to 0.25 μm at higher dopant levels. Dielectric characterization revealed that the increased relative permittivity (εr = 2840.46 at 20 Hz) and low dielectric loss (0.0390) have been achieved for the BTMN06 sample, and all other compositions exhibited low dielectric loss (T c) shifted downward from 115 °C (BTMN02) to 31 °C (BTMN10), reflecting increased structural disorder induced by doping. Relaxor behavior was quantified by an increasing diffusion parameter (1.28 to 1.95) for permittivity, with enhanced polarization stability and slim P-E hysteresis loops at higher dopant levels. Energy storage characteristics showed superior recoverable energy densities (317.7 mJ/cm3 for BTMN08 and 292.2 mJ/cm3 for BTMN10 with efficiencies 91 and 92.6% respectively), validating the material's potential for high-efficiency capacitive energy storage in advanced applications.
- 18 September 2025
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 10 (38) , 43779-43796
Open AccessDoping-Induced Relaxor Ferroelectricity and Site Engineering in Ba1–xPr2x/3Ti1–y(Mo1/2Nb1/2)yO3 Ceramics for Enhanced Permittivity and Energy Storage Performance
In this study, site engineering at the Ba and Ti sites of BaTiO3 has been done to develop Ba1-x Pr2x/3Ti1-y (Mo1/2Nb1/2) y O3 [BTMN] ceramics, with x = 0.003 and y = 0.02, 0.04, 0.06, 0.08, 0.1, to improve permittivity and energy storage performance. The solid-state reaction method was used to synthesize samples. X-ray diffraction analysis revealed a crystallographic phase transition from tetragonal (P4mm) to cubic (Pm-3m) structure with increasing (Mo1/2Nb1/2) concentration. Raman spectroscopy further validates this finding with the disappearance of the characteristic tetragonal peak at 303 cm-1 for higher dopant levels (y ≥ 0.06). Grain size displays a nonlinear trend where grain size first increases to 0.49 μm for intermediate compositions and then decreases to 0.25 μm at higher dopant levels. Dielectric characterization revealed that the increased relative permittivity (εr = 2840.46 at 20 Hz) and low dielectric loss (0.0390) have been achieved for the BTMN06 sample, and all other compositions exhibited low dielectric loss (T c) shifted downward from 115 °C (BTMN02) to 31 °C (BTMN10), reflecting increased structural disorder induced by doping. Relaxor behavior was quantified by an increasing diffusion parameter (1.28 to 1.95) for permittivity, with enhanced polarization stability and slim P-E hysteresis loops at higher dopant levels. Energy storage characteristics showed superior recoverable energy densities (317.7 mJ/cm3 for BTMN08 and 292.2 mJ/cm3 for BTMN10 with efficiencies 91 and 92.6% respectively), validating the material's potential for high-efficiency capacitive energy storage in advanced applications.
- 4 April 2025
- Published by Elsevier in Ceramics International
- Vol. 51 (19) , 28058-28072
Band gap engineering and multicolor emission in environment friendly Dy-Ti Co-doped LiNbO3 ceramics for advanced electrical energy storage, LED and laser applications
- 4 April 2025
- Published by Elsevier in Ceramics International
- Vol. 51 (19) , 28058-28072
Band gap engineering and multicolor emission in environment friendly Dy-Ti Co-doped LiNbO3 ceramics for advanced electrical energy storage, LED and laser applications
- 13 March 2024
- Published by Elsevier in Ceramics International
- Vol. 50 (11) , 20376-20390
Enhanced dielectrics, ferroelectric and optical properties of lithium niobate for high temperature applications using potassium oxide (K2O) additive
- 13 March 2024
- Published by Elsevier in Ceramics International
- Vol. 50 (11) , 20376-20390
Enhanced dielectrics, ferroelectric and optical properties of lithium niobate for high temperature applications using potassium oxide (K2O) additive
- 14 February 2023
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 945
Impact of Sr2+ doping on the structural, dielectric, ferroelectric and optical properties of YFeO3 perovskite phosphor
- 14 February 2023
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 945
Impact of Sr2+ doping on the structural, dielectric, ferroelectric and optical properties of YFeO3 perovskite phosphor
- 2 February 2023
- Published by Elsevier in Journal of Non-Crystalline Solids
- Vol. 605
Defect study of phosphorous doped a-Si:H thin films using cathodoluminescence, IR and Raman spectroscopy
- 2 February 2023
- Published by Elsevier in Journal of Non-Crystalline Solids
- Vol. 605
Defect study of phosphorous doped a-Si:H thin films using cathodoluminescence, IR and Raman spectroscopy