Hideo Sawada
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Hideo Sawada has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Chiharu Inomata
Department of Aerospace Engineering, Graduate School of Engineering, Tohoku University 1 , Tohoku, Miyagi 980-8578, Japan
1 shared publication - Keisuke Asai
Tohoku University
1 shared publication - Masahide Kuwata
Department of Aerospace Engineering, Graduate School of Engineering, Tohoku University 1 , Tohoku, Miyagi 980-8578, Japan
1 shared publication - Shigeru Obayashi
Institute of Fluid Science, Tohoku University, Sendai, Japan
1 shared publication - Sho Yokota
Department of Aerospace Engineering, Graduate School of Engineering, Tohoku University , Sendai, Miyagi 980-8579, Japan
1 shared publication - Taku Nonomura
Tohoku University
1 shared publication
Latest Publications
- 1 February 2023
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 94 (2) , 025102
Model position sensing method for low fineness ratio models in a magnetic suspension and balance system
A new model-position-sensing method for the levitation of models with a low fineness ratio (ratio of the longitudinal length to the diameter) in a magnetic suspension and balance system (MSBS) is proposed. MSBS is an ideal model-support device for wind-tunnel testing, which enables the study of flow fields around blunt bodies without flow disturbances introduced by mechanical support devices, with the aerodynamic forces determined from the magnetic forces using a pre-calibrated relationship. The new method allows wind tunnel experiments without mechanical supports with a low fineness ratio model. This method adopts two line sensors placed parallel to the central axis of the model image and measures the position with a resolution finer than 0.06 mm or deg even for thin model geometries. In addition, measurement errors were reduced by correcting a second-order term in the depth direction of the camera. A low fineness ratio circular cylinder model was levitated following sensor calibration. The model was supported in conditions with and without freestream flow. This position measurement method was also applied to a reentry capsule model. The model was levitated while keeping its position and attitude stabilized near the origin.
- 1 February 2023
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 94 (2) , 025102
Model position sensing method for low fineness ratio models in a magnetic suspension and balance system
A new model-position-sensing method for the levitation of models with a low fineness ratio (ratio of the longitudinal length to the diameter) in a magnetic suspension and balance system (MSBS) is proposed. MSBS is an ideal model-support device for wind-tunnel testing, which enables the study of flow fields around blunt bodies without flow disturbances introduced by mechanical support devices, with the aerodynamic forces determined from the magnetic forces using a pre-calibrated relationship. The new method allows wind tunnel experiments without mechanical supports with a low fineness ratio model. This method adopts two line sensors placed parallel to the central axis of the model image and measures the position with a resolution finer than 0.06 mm or deg even for thin model geometries. In addition, measurement errors were reduced by correcting a second-order term in the depth direction of the camera. A low fineness ratio circular cylinder model was levitated following sensor calibration. The model was supported in conditions with and without freestream flow. This position measurement method was also applied to a reentry capsule model. The model was levitated while keeping its position and attitude stabilized near the origin.