Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Xiangze Meng has a total of 5 co-authors. Here are the top co-authors by number of shared publications:

  • Le Kang

    Engineering Research Center for High Performance Polymer and Molding Technology, Ministry of Education, Qingdao University of Science & Technology, Qingdao 266042, China

    1 shared publication
  • Li Liu

    Institute of High Performance Polymer, Qingdao University of Science & Technology, Qingdao 266042, China

    1 shared publication
  • Mei Shen

    Key Laboratory of Rubber-Plastics, Ministry of Education, School of Polymer Science and Engineering, Qingdao University of Science and Technology, Qingdao 266042, China

    1 shared publication
  • Xiaohao Tang

    Engineering Research Center of High Performance Polymer and Molding Technology, Ministry of Education, Qingdao University of Science and Technology, Qingdao 266042, China

    1 shared publication
  • Xin Guo

    Engineering Research Center of High-Performance Polymer and Molding Technology, Ministry of Education, Qingdao University of Science and Technology, Qingdao 266042, China

    1 shared publication

Latest Publications

  • Open Access

    Highly Strong Interface Adhesion of Polyester Fiber Rubber Composite via Fiber Surface Modification by Meta-Cresol/Formaldehyde Latex Dipping Emulsion

    by Xiangze Meng, Le Kang, Xin Guo, Xiaohao Tang, Li Liu, Mei Shen

    As a skeleton material, polyester (PET) fiber can significantly improve the strength and durability of rubber composites, but the interfacial adhesion between polyester fiber and rubber is poor due to the chemical inertia of PET fiber surface. Resorcinol-formaldehyde-latex (RFL) impregnating solution is usually used to treat PET fibers, but RFL contains toxic components such as resorcinol, which is harmful to the human body. A simple and less toxic resin-impregnating system cresol-formaldehyde-latex (CFL) was obtained by alternating resorcinol with low-toxicity cresol and m-cresol formaldehyde resin was synthesized from m-cresol and formaldehyde. CFL (m-cresol formaldehyde resin latex) systems with different C/F mole ratios and CF resin/latex ratios were adopted to modify the surface of PET fibers. The strip peeling adhesive and the H pull-out test results indicated that the PET fiber/rubber adhesion strength increased with the increase in the formaldehyde dosage and the CF resin content, and the peeling force value and the H-pull-out force of treated PET/rubber composites reached 7.3 N/piece and 56.8 N, respectively. The optimal choice of CFL adhesive system was obtained, when the C/F mole ratio was 1/2 and the CF resin/latex weight ratio was 0.23. This environment-friendly CFL dipping emulsion can be used as a new surface modification strategy as it can remarkably enhance the interfacial adhesion of PET/rubber composites.