Shi-Yi Jin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Shi-Yi Jin has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Dong-Hyun Seo
Green Mobility R&D Center, Jeonbuk Institute of Automotive Convergence Technology, Gunsan 573450, Republic of Korea
2 shared publications - Jin-Gyun Chung
Division of Electronic Engineering, IT Convergence Research Center, Jeonbuk National University, Jeonju 54896, Republic of Korea
2 shared publications - Samuel Woo
Department of Software Science, Dankook University, Yongin 16890, Republic of Korea
2 shared publications - Jinhui Piao
Division of Electronic Engineering, IT Convergence Research Center, Jeonbuk National University, Jeonju 54896, Republic of Korea
1 shared publication - Yeon-Jin Kim
Division of Electronic Engineering, IT Convergence Research Center, Jeonbuk National University, Jeonju 54896, Republic of Korea
1 shared publication - Yong Eun Kim
Synergytion Co., Ltd., Cheonan 31156, Republic of Korea
1 shared publication
Latest Publications
- Open Access
- 28 February 2024
- Published by MDPI AG in Information
- Vol. 15 (3) , 132
Single-Frame-Based Data Compression for CAN Security
To authenticate a controller area network (CAN) data frame, a message authentication code (MAC) must be sent along with the CAN frame, but there is no space reserved for the MAC in the CAN frame. Recently, difference-based compression (DBC) algorithms have been used to create a space inside the frame. DBC has the advantage of being very efficient, but its drawback is that, if an error occurs in one frame, the effects of that error propagate to subsequent frames. In this paper, a CAN data compression algorithm is proposed that compresses the current frame without relying on previous frames. Therefore, an error generated in one frame cannot be propagated to subsequent frames. In addition, a CAN signal grouping technique is proposed based on entropy analysis. To efficiently authenticate CAN frames, the length of the compressed data must be 4 bytes or less (4BL). Simulation shows that the 4BL-compression ratio of a Kia Sorento vehicle is 99.36% in the DBC method, but 100% in the proposed method. In an LS Mtron tractor, the 4BL-compression ratio is 98.58% in the DBC method, but 100% in the proposed method. In addition, the execution time of the proposed compression algorithm is only 27.39% of that of the DBC algorithm. The results show that the proposed algorithm has better compression characteristics for CAN security than the DBC algorithms.
- 28 February 2024
- Published by MDPI AG in Information
- Vol. 15 (3) , 132
Open AccessSingle-Frame-Based Data Compression for CAN Security
To authenticate a controller area network (CAN) data frame, a message authentication code (MAC) must be sent along with the CAN frame, but there is no space reserved for the MAC in the CAN frame. Recently, difference-based compression (DBC) algorithms have been used to create a space inside the frame. DBC has the advantage of being very efficient, but its drawback is that, if an error occurs in one frame, the effects of that error propagate to subsequent frames. In this paper, a CAN data compression algorithm is proposed that compresses the current frame without relying on previous frames. Therefore, an error generated in one frame cannot be propagated to subsequent frames. In addition, a CAN signal grouping technique is proposed based on entropy analysis. To efficiently authenticate CAN frames, the length of the compressed data must be 4 bytes or less (4BL). Simulation shows that the 4BL-compression ratio of a Kia Sorento vehicle is 99.36% in the DBC method, but 100% in the proposed method. In an LS Mtron tractor, the 4BL-compression ratio is 98.58% in the DBC method, but 100% in the proposed method. In addition, the execution time of the proposed compression algorithm is only 27.39% of that of the DBC algorithm. The results show that the proposed algorithm has better compression characteristics for CAN security than the DBC algorithms.
- Open Access
- 18 February 2023
- Published by MDPI AG in Applied Sciences
- Vol. 13 (4) , 2654
MAC-Based Compression Ratio Improvement for CAN Security
Information security in a controller area network (CAN) is becoming more important as the connections between a vehicle’s internal and external networks increase. Encryption and authentication techniques can be applied to CAN data frames to enhance security. To authenticate a data frame, a message authentication code (MAC) needs to be transmitted with the CAN data frame. Therefore, space for transmitting the MAC is required within the CAN frame. Recently, the Triple ID algorithm has been proposed to create additional space in the data field of the CAN frame. The Triple ID algorithm ensures every CAN frame is authenticated by at least 4 bytes of MAC without changing the original CAN protocol. However, since the Triple ID algorithm uses six header bits, there is a problem associated with low data compression efficiency. In this paper, we propose an algorithm that can remove up to 15 bits from frames compressed with the Triple ID algorithm. Through simulation using CAN signals of a Kia Sorento vehicle and an LS Mtron tractor, we show that the generation of frames containing compressed messages of 4 bytes or more is reduced by up to 99.57% compared to the Triple ID method.
- 18 February 2023
- Published by MDPI AG in Applied Sciences
- Vol. 13 (4) , 2654
Open AccessMAC-Based Compression Ratio Improvement for CAN Security
Information security in a controller area network (CAN) is becoming more important as the connections between a vehicle’s internal and external networks increase. Encryption and authentication techniques can be applied to CAN data frames to enhance security. To authenticate a data frame, a message authentication code (MAC) needs to be transmitted with the CAN data frame. Therefore, space for transmitting the MAC is required within the CAN frame. Recently, the Triple ID algorithm has been proposed to create additional space in the data field of the CAN frame. The Triple ID algorithm ensures every CAN frame is authenticated by at least 4 bytes of MAC without changing the original CAN protocol. However, since the Triple ID algorithm uses six header bits, there is a problem associated with low data compression efficiency. In this paper, we propose an algorithm that can remove up to 15 bits from frames compressed with the Triple ID algorithm. Through simulation using CAN signals of a Kia Sorento vehicle and an LS Mtron tractor, we show that the generation of frames containing compressed messages of 4 bytes or more is reduced by up to 99.57% compared to the Triple ID method.