SSSuzuka Suzuki

Suzuka Suzuki

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Suzuka Suzuki has a total of 3 co-authors. Here are the top co-authors by number of shared publications:

  • Haruhisa Nakano

    Department of Orthodontics, Showa Medical University School of Dentistry, Tokyo, Japan

    1 shared publication
  • Koutaro Maki

    Department of Orthodontics, School of Dentistry, Showa University, Tokyo, Japan

    1 shared publication
  • Yu Kataoka

    Department of Conservative Dentistry, Division of Biomaterials and Engineering, Showa University School of Dentistry, Showa University, Tokyo, Japan

    1 shared publication

Latest Publications

  • Open Access

    Clear aligner orthodontic force and conformity during lateral expansion

    by Suzuka Suzuki, Haruhisa Nakano, Yu Kataoka, Koutaro Maki

    Purpose: This study aimed to find the clear aligner form which buccal tipping is less likely to occur by experimentally comparing the marginal type of the aligners with the orthodontic force and conformity (flotation) on the first molars during lateral expansion. Materials and methods: Four different marginal types (conventional aligners with no palatal coverage, partial palatal coverage [with or without 2.0 mm buccal extension], and complete palatal coverage) and three levels of lateral expansion (no expansion, 0.25-mm expansion, and 0.50-mm expansion) were used. The force applied to the first molar was measured by attaching a pressure sensor to the palatal side of the left first molar on a modelled maxillary constricted dental arch. The conformity (flotation) was measured by micro-CT with each aligner attached to the model. Results: Conventional aligners showed no significant difference in force at 0.25-mm or 0.50-mm expansion, but significant flotation at the midpoint and cervical side. The force of all three types of palatal coverage aligners increased significantly (p < 0.01) with increasing expansion and showed less flotation (p < 0.01) compared to the conventional type. Complete palatal coverage aligners had little flotation at 0.25-mm expansion and no expansion. Conclusion: Conventional aligners should have greater buccal tipping of the molars due to increased flotation with expansion. Complete palatal coverage aligners with 0.25-mm expansion had the best conformity, suggesting that they may prevent unplanned buccal tipping of the molars and allow lateral expansion to occur as intended.