Truong Tien Hoang Duong
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Truong Tien Hoang Duong has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Alexandr Nikolaevich Simonov
Monash University
3 shared publications - Douglas R. MacFarlane
School of Chemistry, Monash University, Clayton 3800, Victoria, Australia
3 shared publications - Hoang-Long Du
School of Chemistry Monash University Clayton Victoria Australia
3 shared publications - Ngoc Trung Nguyen
School of Chemistry Monash University Clayton Victoria Australia
3 shared publications - Peter Strasser
Department of Chemistry Technical University Berlin Berlin Germany
3 shared publications - Thi Mung Vu
School of Chemistry Monash University Clayton Victoria Australia
3 shared publications
Latest Publications
- 3 November 2026
- Published by Royal Society of Chemistry (RSC) in Energy & Environmental Science
- Vol. 19 (21) , 7394-7407
High-selectivity nitrogen electroreduction to ammonia at near-ambient pressure
An advanced electrolyte and N 2 bubbling enable formation of a LiF/Li 2 S n -rich SEI, supporting high-performance Li-NRR at near-ambient pressure in the presence of water.
- 3 November 2026
- Published by Royal Society of Chemistry (RSC) in Energy & Environmental Science
- Vol. 19 (21) , 7394-7407
High-selectivity nitrogen electroreduction to ammonia at near-ambient pressure
An advanced electrolyte and N 2 bubbling enable formation of a LiF/Li 2 S n -rich SEI, supporting high-performance Li-NRR at near-ambient pressure in the presence of water.
- Open Access
- 10 September 2026
- Published by Wiley in Angewandte Chemie International Edition
- Vol. 65 (44) , e2841666
The Promise and Challenges of Ammonia Electrosynthesis From Dinitrogen and Water Using an Electrochemical Palladium Membrane
Sustainable ammonia production can be achieved via an electrochemical process coupling the lithium redox‐mediated nitrogen reduction (Li‐NRR) with hydrogen oxidation, but a more practical approach uses water oxidation (the oxygen evolution reaction; OER) as the anode reaction. However, coupling the Li‐NRR and the OER is restricted by incompatibility of the anhydrous conditions required for nitrogen reduction with water. Aiming to resolve this, we investigated an electrolyser with an electrochemical palladium‐based membrane, which transforms protons generated by the OER to palladium hydride in aqueous media and releases protons into non‐aqueous Li‐NRR media to sustain ammonia production. The hydride formation/oxidation mechanism, validated through experiments with deuterated water, ensures exclusive membrane selectivity to protons, and is facilitated by the palladium‐gold electrocatalysts. We demonstrate ammonia electrosynthesis from nitrogen (15 bar) and water at a faradaic efficiency of 59 ± 4%, yield rate of 20 ± 1 nmol s −1 cm −2 and energy efficiency of 9.0 ± 0.7% over more than two days. However, deeper investigation of the system revealed ammonia‐promoted corrosion of the palladium‐based membrane—a challenge that needs to be addressed in the future developments of this technology.
- 10 September 2026
- Published by Wiley in Angewandte Chemie International Edition
- Vol. 65 (44) , e2841666
Open AccessThe Promise and Challenges of Ammonia Electrosynthesis From Dinitrogen and Water Using an Electrochemical Palladium Membrane
Sustainable ammonia production can be achieved via an electrochemical process coupling the lithium redox‐mediated nitrogen reduction (Li‐NRR) with hydrogen oxidation, but a more practical approach uses water oxidation (the oxygen evolution reaction; OER) as the anode reaction. However, coupling the Li‐NRR and the OER is restricted by incompatibility of the anhydrous conditions required for nitrogen reduction with water. Aiming to resolve this, we investigated an electrolyser with an electrochemical palladium‐based membrane, which transforms protons generated by the OER to palladium hydride in aqueous media and releases protons into non‐aqueous Li‐NRR media to sustain ammonia production. The hydride formation/oxidation mechanism, validated through experiments with deuterated water, ensures exclusive membrane selectivity to protons, and is facilitated by the palladium‐gold electrocatalysts. We demonstrate ammonia electrosynthesis from nitrogen (15 bar) and water at a faradaic efficiency of 59 ± 4%, yield rate of 20 ± 1 nmol s −1 cm −2 and energy efficiency of 9.0 ± 0.7% over more than two days. However, deeper investigation of the system revealed ammonia‐promoted corrosion of the palladium‐based membrane—a challenge that needs to be addressed in the future developments of this technology.
- Open Access
- 10 September 2026
- Published by Wiley in Angewandte Chemie
- Vol. 138 (44) , e2841666
The Promise and Challenges of Ammonia Electrosynthesis From Dinitrogen and Water Using an Electrochemical Palladium Membrane
Sustainable ammonia production can be achieved via an electrochemical process coupling the lithium redox‐mediated nitrogen reduction (Li‐NRR) with hydrogen oxidation, but a more practical approach uses water oxidation (the oxygen evolution reaction; OER) as the anode reaction. However, coupling the Li‐NRR and the OER is restricted by incompatibility of the anhydrous conditions required for nitrogen reduction with water. Aiming to resolve this, we investigated an electrolyser with an electrochemical palladium‐based membrane, which transforms protons generated by the OER to palladium hydride in aqueous media and releases protons into non‐aqueous Li‐NRR media to sustain ammonia production. The hydride formation/oxidation mechanism, validated through experiments with deuterated water, ensures exclusive membrane selectivity to protons, and is facilitated by the palladium‐gold electrocatalysts. We demonstrate ammonia electrosynthesis from nitrogen (15 bar) and water at a faradaic efficiency of 59 ± 4%, yield rate of 20 ± 1 nmol s −1 cm −2 and energy efficiency of 9.0 ± 0.7% over more than two days. However, deeper investigation of the system revealed ammonia‐promoted corrosion of the palladium‐based membrane—a challenge that needs to be addressed in the future developments of this technology.
- 10 September 2026
- Published by Wiley in Angewandte Chemie
- Vol. 138 (44) , e2841666
Open AccessThe Promise and Challenges of Ammonia Electrosynthesis From Dinitrogen and Water Using an Electrochemical Palladium Membrane
Sustainable ammonia production can be achieved via an electrochemical process coupling the lithium redox‐mediated nitrogen reduction (Li‐NRR) with hydrogen oxidation, but a more practical approach uses water oxidation (the oxygen evolution reaction; OER) as the anode reaction. However, coupling the Li‐NRR and the OER is restricted by incompatibility of the anhydrous conditions required for nitrogen reduction with water. Aiming to resolve this, we investigated an electrolyser with an electrochemical palladium‐based membrane, which transforms protons generated by the OER to palladium hydride in aqueous media and releases protons into non‐aqueous Li‐NRR media to sustain ammonia production. The hydride formation/oxidation mechanism, validated through experiments with deuterated water, ensures exclusive membrane selectivity to protons, and is facilitated by the palladium‐gold electrocatalysts. We demonstrate ammonia electrosynthesis from nitrogen (15 bar) and water at a faradaic efficiency of 59 ± 4%, yield rate of 20 ± 1 nmol s −1 cm −2 and energy efficiency of 9.0 ± 0.7% over more than two days. However, deeper investigation of the system revealed ammonia‐promoted corrosion of the palladium‐based membrane—a challenge that needs to be addressed in the future developments of this technology.
- Open Access
- 21 February 2023
- Published by Publishing House for Science and Technology, Vietnam Academy of Science and Technology (Publications) in Communications in Physics
- Vol. 33 (1) , 41
Core/shell \(\textbf{CoFe}_{2}\textbf{O}_{4}/\textbf{Fe}_{3}\textbf{O}_{4}\) Nanoparticles: Effects of Hard/soft Magnetic Weight Fraction on Structure, Particle Size and Magnetic PropertiesCoFe\(_{2}\)O\(_{4}\)/Fe\(_{3}\)O\(_{4}\) nanocomposite particles were synthesized by using co-precipitation combined with hydrothermal methods. The phase composition, surface morphology and magnetic properties of the nanocomposites were investigated using X- ray diffraction, scanning electron microscopy and vibrating sample magnetometer. Findings show that the samples comprise two phases, and Fe\(_{3}\)O\(_{4}\) particles are coated on the surface of CoFe\(_{2}\)O\(_{4}\) particles. The average particle size of CoFe\(_{2}\)O\(_{4}\) was ditrisbuted in the range of 50 -- 100 nm. While the particle of Fe\(_{3}\)O\(_{4}\) displayed a spherical shape and particle size distributed from 10 -- 20 nm. The MS of CoFe\(_{2}\)O\(_{4}\)@Fe\(_{3}\)O\(_{4}\) core–shell particles increase with the decrease in the mass ratio of hard to soft ferrites. The structure, magnetic properties and the degree of exchange coupling between the magnetic phases were investigated.- 21 February 2023
- Published by Publishing House for Science and Technology, Vietnam Academy of Science and Technology (Publications) in Communications in Physics
- Vol. 33 (1) , 41
Open AccessCore/shell \(\textbf{CoFe}_{2}\textbf{O}_{4}/\textbf{Fe}_{3}\textbf{O}_{4}\) Nanoparticles: Effects of Hard/soft Magnetic Weight Fraction on Structure, Particle Size and Magnetic PropertiesCoFe\(_{2}\)O\(_{4}\)/Fe\(_{3}\)O\(_{4}\) nanocomposite particles were synthesized by using co-precipitation combined with hydrothermal methods. The phase composition, surface morphology and magnetic properties of the nanocomposites were investigated using X- ray diffraction, scanning electron microscopy and vibrating sample magnetometer. Findings show that the samples comprise two phases, and Fe\(_{3}\)O\(_{4}\) particles are coated on the surface of CoFe\(_{2}\)O\(_{4}\) particles. The average particle size of CoFe\(_{2}\)O\(_{4}\) was ditrisbuted in the range of 50 -- 100 nm. While the particle of Fe\(_{3}\)O\(_{4}\) displayed a spherical shape and particle size distributed from 10 -- 20 nm. The MS of CoFe\(_{2}\)O\(_{4}\)@Fe\(_{3}\)O\(_{4}\) core–shell particles increase with the decrease in the mass ratio of hard to soft ferrites. The structure, magnetic properties and the degree of exchange coupling between the magnetic phases were investigated.