SMShenghui Mu

Shenghui Mu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Shenghui Mu has a total of 6 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    A core loss estimation method based on improved waveform coefficient Steinmetz equation for asymmetric triangular flux density waveform

    by Yongjian Li, Kangshuo Qin, Shenghui Mu, Jiatong Yin

    Accurate estimation of high frequency magnetic core losses under non-sinusoidal excitations is critical to the design of solid-state transformers. This paper proposes a waveform transformation principle, termed the equal derivative transformation (EDT), for piecewise linear flux density waveforms. Under the same maximum flux density, an asymmetric triangular flux density wave can be transformed into a symmetric one with a different frequency in terms of the calculation of core losses, hence the introduction of the improved waveform coefficient Steinmetz equation (iWcSE). The magnetic characteristics of three different toroidal samples (nanocrystalline alloy FT-3KL, amorphous alloy 1K101, ferrite N87) under square excitation at different duty ratios and certain frequencies are measured. Core losses predicted by the model are in good agreement with the measurement.


  • Open Access

    Magnetic property measurement and analysis of high-frequency soft magnetic materials under non-sinusoidal excitation considering temperature effect

    by Yongjian Li, Chuhao Jin, Ming Yang, Shenghui Mu, Changgeng Zhang

    Electrical equipment operates under various temperatures and non-sinusoidal excitation, which makes magnetic properties of soft magnetic materials quite different from those under room temperature and sinusoidal excitation. Magnetic properties and loss characteristics of the ferrite (N87) and nanocrystalline alloy (FT-3KL) are measured and analyzed in the range of 25 °C to 125 °C from 5 kHz to 20 kHz under both square and rectangular excitation with different duty ratios. The temperature dependence of these materials under different conditions is systematically compared with normalization method. The comprehensive performance of core materials is discussed in combination with the experimental phenomena and results.


  • Open Access

    Core loss measurement and comparative analysis for soft magnetic materials under complex non-sinusoidal excitations

    by Yongjian Li, Shenghui Mu, Changgeng Zhang, Ming Yang

    With the advancement of wide-bandgap power devices, the power electronics equipment is developing toward higher switching frequencies and more complex switching modes in recent years. Accurate prediction of the core loss for magnetic components has been emphasized as the excitations of magnetic materials varying depending on the operating mode of the power supplies. Therefore, this paper presents the results of an extensive core loss study performed on nanocrystalline alloy (FT-3KL), amorphous alloy (1K101) and ultra-thin oriented silicon steel (GT-50). Firstly, an automatic setup for core loss measurement of soft magnetic materials fed by a full-bridge inverter based on silicon carbide (SiC) MOSFET is proposed. Then, the effects of switching oscillations from the inverter and the characteristic parameters of complex non-sinusoidal excitations on the core loss are analyzed comparatively. The core loss shows different regular distributions with the change of each characteristic parameter of excitations respectively. However, the regular distributions will be influenced by the high-frequency switching oscillations, which makes the prediction of core loss more complicated. This paper can provide a reference for the development of high-precision core loss model and performance optimization of power electronics equipment.