Agnes Maneesha Dominic Merwin Xavier
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Agnes Maneesha Dominic Merwin Xavier has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
Andrew A. Allerman
Sandia National Laboratories 5 , Albuquerque, New Mexico 87123
2 shared publications- Brianna Alexandra Klein
Sandia National Laboratories
2 shared publications - Chandan Joishi
Department of Electrical and Computer Engineering, The Ohio State University 1 , Columbus, Ohio 43210
2 shared publications - Jonathan Pratt
Department of Electrical and Computer Engineering, The Ohio State University 1 , Columbus, Ohio 43210
2 shared publications Siddharth Rajan
Department of Electrical and Computer Engineering, The Ohio State University 1 , Columbus, Ohio 43210
2 shared publications- Siddharth Rajan
The Ohio State University
2 shared publications
Latest Publications
- 29 July 2026
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 44 (5)
Impact of Ga deposition and desorption on the properties of high Al-fraction AlGaN grown by plasma-assisted molecular beam epitaxy
We have grown two sets of 500-nm-thick n+-Al0.85Ga0.15N layers on AlN templates at various substrate temperatures between 700 and 875 °C by plasma-assisted molecular beam epitaxy, differing only in the detailed surface treatment prior to growth. In one set, Ga deposition and desorption (Ga D&D) on the template surface is performed at the substrate temperature used for growth prior to film deposition, while in the other set, the Ga D&D is performed at 875 °C for all the samples. These layers were doped with Si at a nominal concentration of 3 × 1019 cm−3. We observe significantly red-shifted (∼850 meV) photoluminescence for sub-bandgap optical pumping, the intensity of which increases as the growth temperature of the layer increases. We attribute this sub-bandgap emission to the presence of nanoscale compositional inhomogeneities in the layers and speculate that they contribute to the reduced Hall mobility. Reciprocal space mapping indicates that most of the AlGaN layers are under compressive strain and are pseudomorphic to the AlN template, while the samples with the highest Hall mobility and least intense sub-bandgap emission are under smaller tensile strain. We attribute the presence of tensile strain to layer growth on a Ga-rich compliant pseudosubstrate that presents for Ga D&D and growth at 700 and 750 °C, for which Ga desorption is incomplete prior to growth initiation.
- 29 July 2026
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 44 (5)
Impact of Ga deposition and desorption on the properties of high Al-fraction AlGaN grown by plasma-assisted molecular beam epitaxy
We have grown two sets of 500-nm-thick n+-Al0.85Ga0.15N layers on AlN templates at various substrate temperatures between 700 and 875 °C by plasma-assisted molecular beam epitaxy, differing only in the detailed surface treatment prior to growth. In one set, Ga deposition and desorption (Ga D&D) on the template surface is performed at the substrate temperature used for growth prior to film deposition, while in the other set, the Ga D&D is performed at 875 °C for all the samples. These layers were doped with Si at a nominal concentration of 3 × 1019 cm−3. We observe significantly red-shifted (∼850 meV) photoluminescence for sub-bandgap optical pumping, the intensity of which increases as the growth temperature of the layer increases. We attribute this sub-bandgap emission to the presence of nanoscale compositional inhomogeneities in the layers and speculate that they contribute to the reduced Hall mobility. Reciprocal space mapping indicates that most of the AlGaN layers are under compressive strain and are pseudomorphic to the AlN template, while the samples with the highest Hall mobility and least intense sub-bandgap emission are under smaller tensile strain. We attribute the presence of tensile strain to layer growth on a Ga-rich compliant pseudosubstrate that presents for Ga D&D and growth at 700 and 750 °C, for which Ga desorption is incomplete prior to growth initiation.
- Open Access
- 1 June 2026
- Published by AIP Publishing in APL Electronic Devices
- Vol. 2 (2)
Scaled ultra-wide bandgap AlGaN polarization-graded FET with ultra-thin buffer layer
We report on the design and experimental demonstration of ultra-wide-bandgap AlGaN polarization-graded field-effect transistors (PolFETs) with ultra-thin channels aimed at enabling high current capability, RF performance, and reduced thermal resistance. Polarization-graded AlGaN layers and ultra-thin pseudomorphic AlGaN buffer layers are employed to achieve low thermal resistance while maintaining high structural quality. The demonstrated PolFETs achieve a maximum soft-saturation drain current density of 800 mA/mm at VG = 4 V and ∼500 mA/mm at VG = 0 V, along with current- and power-gain cutoff frequencies (fT/fmax) of 26/28 GHz, respectively. Small-signal modeling was performed to analyze parasitic and transit delays, and gate-resistance thermometry was implemented to characterize device thermal behavior and benchmark against state-of-the-art AlGaN HEMTs. The ultra-thin AlGaN PolFET exhibits a thermal resistance of 12 K mm/W, representing a significant reduction compared to conventional AlGaN transistor structures. These results demonstrate the feasibility of polarization-engineered ultra-wide-bandgap AlGaN transistors for RF and mm-wave applications, with the added advantage of improved thermal performance.
- 1 June 2026
- Published by AIP Publishing in APL Electronic Devices
- Vol. 2 (2)
Open AccessScaled ultra-wide bandgap AlGaN polarization-graded FET with ultra-thin buffer layer
We report on the design and experimental demonstration of ultra-wide-bandgap AlGaN polarization-graded field-effect transistors (PolFETs) with ultra-thin channels aimed at enabling high current capability, RF performance, and reduced thermal resistance. Polarization-graded AlGaN layers and ultra-thin pseudomorphic AlGaN buffer layers are employed to achieve low thermal resistance while maintaining high structural quality. The demonstrated PolFETs achieve a maximum soft-saturation drain current density of 800 mA/mm at VG = 4 V and ∼500 mA/mm at VG = 0 V, along with current- and power-gain cutoff frequencies (fT/fmax) of 26/28 GHz, respectively. Small-signal modeling was performed to analyze parasitic and transit delays, and gate-resistance thermometry was implemented to characterize device thermal behavior and benchmark against state-of-the-art AlGaN HEMTs. The ultra-thin AlGaN PolFET exhibits a thermal resistance of 12 K mm/W, representing a significant reduction compared to conventional AlGaN transistor structures. These results demonstrate the feasibility of polarization-engineered ultra-wide-bandgap AlGaN transistors for RF and mm-wave applications, with the added advantage of improved thermal performance.
- 10 February 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 126 (6)
Heterostructure and interfacial engineering for low-resistance contacts to ultra-wide bandgap AlGaN
We report on the heterostructure and interfacial engineering of metalorganic chemical vapor deposition (MOCVD) grown reverse graded contacts to ultra-wide bandgap AlGaN. A record low contact resistivity of 1.4 × 10−6 Ω cm2 was reported on an Al0.82Ga0.18N metal-semiconductor field effect transistor by compositionally grading the contact layer from Al0.85Ga0.15N → Al0.14Ga0.86N with degenerate doping and proper interfacial engineering considering bandgap-narrowing-induced band offset between the channel and the contact layer. This represents orders-of-magnitude of lower contact resistivity than that obtained in similar MOCVD-grown structures. A detailed, layer-by-layer analysis of the reverse graded contact and TCAD simulation of the bandgap narrowing effect highlighted that the reverse graded contact layer itself is extremely conductive, and interfacial resistance due to bandgap-narrowing-induced barrier between contact and channel dominates the contact resistance.
- 10 February 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 126 (6)
Heterostructure and interfacial engineering for low-resistance contacts to ultra-wide bandgap AlGaN
We report on the heterostructure and interfacial engineering of metalorganic chemical vapor deposition (MOCVD) grown reverse graded contacts to ultra-wide bandgap AlGaN. A record low contact resistivity of 1.4 × 10−6 Ω cm2 was reported on an Al0.82Ga0.18N metal-semiconductor field effect transistor by compositionally grading the contact layer from Al0.85Ga0.15N → Al0.14Ga0.86N with degenerate doping and proper interfacial engineering considering bandgap-narrowing-induced band offset between the channel and the contact layer. This represents orders-of-magnitude of lower contact resistivity than that obtained in similar MOCVD-grown structures. A detailed, layer-by-layer analysis of the reverse graded contact and TCAD simulation of the bandgap narrowing effect highlighted that the reverse graded contact layer itself is extremely conductive, and interfacial resistance due to bandgap-narrowing-induced barrier between contact and channel dominates the contact resistance.
- 20 February 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 122 (8) , 081108
Design and demonstration of efficient transparent 30% Al-content AlGaN interband tunnel junctions
Ultra-violet (UV) light emitting diodes operating at 339 nm using transparent interband tunnel junctions are reported. Tunneling-based ultraviolet light emitting diodes were grown by plasma-assisted molecular beam epitaxy on 30% Al-content AlGaN layers. A low tunnel junction voltage drop is obtained through the use of compositionally graded n and p-type layers in the tunnel junction, which enhance hole density and tunneling rates. The transparent tunnel junction-based UV LED reported here show a low voltage drop of 5.55 V at 20 A/cm2 and an on-wafer external quantum efficiency of 1.02% at 80 A/cm2.
- 20 February 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 122 (8) , 081108
Design and demonstration of efficient transparent 30% Al-content AlGaN interband tunnel junctions
Ultra-violet (UV) light emitting diodes operating at 339 nm using transparent interband tunnel junctions are reported. Tunneling-based ultraviolet light emitting diodes were grown by plasma-assisted molecular beam epitaxy on 30% Al-content AlGaN layers. A low tunnel junction voltage drop is obtained through the use of compositionally graded n and p-type layers in the tunnel junction, which enhance hole density and tunneling rates. The transparent tunnel junction-based UV LED reported here show a low voltage drop of 5.55 V at 20 A/cm2 and an on-wafer external quantum efficiency of 1.02% at 80 A/cm2.