Jonathan Pratt
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jonathan Pratt has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
Andrew A. Allerman
Sandia National Laboratories 3 , Albuquerque, New Mexico 87123
4 shared publications- Brianna Alexandra Klein
Sandia National Laboratories
4 shared publications - Siddharth Rajan
The Ohio State University
4 shared publications - Yinxuan Zhu
The Ohio State University
4 shared publications - Seungheon Shin
Department of Electrical and Computer Engineering, The Ohio State University 1 , Columbus, Ohio 43210
3 shared publications - Agnes Maneesha Dominic Merwin Xavier
Department of Electrical and Computer Engineering, The Ohio State University 1 , Columbus, Ohio 43210
2 shared publications
Latest Publications
- 29 July 2026
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 44 (5)
Impact of Ga deposition and desorption on the properties of high Al-fraction AlGaN grown by plasma-assisted molecular beam epitaxy
We have grown two sets of 500-nm-thick n+-Al0.85Ga0.15N layers on AlN templates at various substrate temperatures between 700 and 875 °C by plasma-assisted molecular beam epitaxy, differing only in the detailed surface treatment prior to growth. In one set, Ga deposition and desorption (Ga D&D) on the template surface is performed at the substrate temperature used for growth prior to film deposition, while in the other set, the Ga D&D is performed at 875 °C for all the samples. These layers were doped with Si at a nominal concentration of 3 × 1019 cm−3. We observe significantly red-shifted (∼850 meV) photoluminescence for sub-bandgap optical pumping, the intensity of which increases as the growth temperature of the layer increases. We attribute this sub-bandgap emission to the presence of nanoscale compositional inhomogeneities in the layers and speculate that they contribute to the reduced Hall mobility. Reciprocal space mapping indicates that most of the AlGaN layers are under compressive strain and are pseudomorphic to the AlN template, while the samples with the highest Hall mobility and least intense sub-bandgap emission are under smaller tensile strain. We attribute the presence of tensile strain to layer growth on a Ga-rich compliant pseudosubstrate that presents for Ga D&D and growth at 700 and 750 °C, for which Ga desorption is incomplete prior to growth initiation.
- 29 July 2026
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 44 (5)
Impact of Ga deposition and desorption on the properties of high Al-fraction AlGaN grown by plasma-assisted molecular beam epitaxy
We have grown two sets of 500-nm-thick n+-Al0.85Ga0.15N layers on AlN templates at various substrate temperatures between 700 and 875 °C by plasma-assisted molecular beam epitaxy, differing only in the detailed surface treatment prior to growth. In one set, Ga deposition and desorption (Ga D&D) on the template surface is performed at the substrate temperature used for growth prior to film deposition, while in the other set, the Ga D&D is performed at 875 °C for all the samples. These layers were doped with Si at a nominal concentration of 3 × 1019 cm−3. We observe significantly red-shifted (∼850 meV) photoluminescence for sub-bandgap optical pumping, the intensity of which increases as the growth temperature of the layer increases. We attribute this sub-bandgap emission to the presence of nanoscale compositional inhomogeneities in the layers and speculate that they contribute to the reduced Hall mobility. Reciprocal space mapping indicates that most of the AlGaN layers are under compressive strain and are pseudomorphic to the AlN template, while the samples with the highest Hall mobility and least intense sub-bandgap emission are under smaller tensile strain. We attribute the presence of tensile strain to layer growth on a Ga-rich compliant pseudosubstrate that presents for Ga D&D and growth at 700 and 750 °C, for which Ga desorption is incomplete prior to growth initiation.
- Top Cited PapersOpen Access
- 26 May 2026
- Published by AIP Publishing in APL Electronic Devices
- Vol. 2 (2)
High breakdown field multi-kV UWBG AlGaN transistors
We demonstrate high-performance UWBG AlGaN PolFETs exhibiting a state-of-the-art combination of nearly 1 A/mm on-state current (∼960 mA/mm) and a large breakdown field (>4.8 MV/cm) in high carrier density (1.15 × 1013 cm−2). Multi-kV robustness is successfully demonstrated, exhibiting 1.28 and 2.17 kV by utilizing a gate-connected field plate structure in 3.9 and 6.8 μm LGD, corresponding to the extremely low specific on-resistance of 1.25 and 2.86 mΩ cm2, respectively. High RF performance is also achieved, providing fT and fMAX of 8.5 and 15 GHz, respectively, for 3.9 μm LGD. These results highlight UWBG AlGaN as a platform for both high-voltage RF and power applications.
- 26 May 2026
- Published by AIP Publishing in APL Electronic Devices
- Vol. 2 (2)
Top Cited PapersOpen AccessHigh breakdown field multi-kV UWBG AlGaN transistors
We demonstrate high-performance UWBG AlGaN PolFETs exhibiting a state-of-the-art combination of nearly 1 A/mm on-state current (∼960 mA/mm) and a large breakdown field (>4.8 MV/cm) in high carrier density (1.15 × 1013 cm−2). Multi-kV robustness is successfully demonstrated, exhibiting 1.28 and 2.17 kV by utilizing a gate-connected field plate structure in 3.9 and 6.8 μm LGD, corresponding to the extremely low specific on-resistance of 1.25 and 2.86 mΩ cm2, respectively. High RF performance is also achieved, providing fT and fMAX of 8.5 and 15 GHz, respectively, for 3.9 μm LGD. These results highlight UWBG AlGaN as a platform for both high-voltage RF and power applications.
- Open Access
- 1 December 2025
- Published by AIP Publishing in APL Electronic Devices
- Vol. 1 (4)
Barrier electrostatics and contact engineering for ultra-wide bandgap AlGaN HFETs
We report ultra-wide bandgap (UWBG) AlGaN heterostructure field-effect transistors (HFETs) exhibiting a high breakdown field (>5.3 MV/cm) and a low contact resistance (∼1.55 Ω mm), tailored for high-power radio frequency applications. A split-doped barrier architecture, employing two distinct doping concentrations, is shown to enhance both the breakdown field and contact resistance. This design enables a state-of-the-art combination of maximum drain current (487 mA/mm) and breakdown field, along with a high cutoff frequency of 7.2 GHz. These results demonstrate a viable pathway to push device performance toward the material limits while minimizing contact resistance in UWBG AlGaN HFETs, paving the way for next-generation high-power, high-frequency applications.
- 1 December 2025
- Published by AIP Publishing in APL Electronic Devices
- Vol. 1 (4)
Open AccessBarrier electrostatics and contact engineering for ultra-wide bandgap AlGaN HFETs
We report ultra-wide bandgap (UWBG) AlGaN heterostructure field-effect transistors (HFETs) exhibiting a high breakdown field (>5.3 MV/cm) and a low contact resistance (∼1.55 Ω mm), tailored for high-power radio frequency applications. A split-doped barrier architecture, employing two distinct doping concentrations, is shown to enhance both the breakdown field and contact resistance. This design enables a state-of-the-art combination of maximum drain current (487 mA/mm) and breakdown field, along with a high cutoff frequency of 7.2 GHz. These results demonstrate a viable pathway to push device performance toward the material limits while minimizing contact resistance in UWBG AlGaN HFETs, paving the way for next-generation high-power, high-frequency applications.
- Top Cited PapersOpen Access
- 29 August 2025
- Published by AIP Publishing in APL Electronic Devices
- Vol. 1 (3)
High breakdown electric field (>5 MV/cm) in UWBG AlGaN transistors
We report on the design and demonstration of ultra-wide bandgap (UWBG) AlGaN-channel metal–insulator heterostructure field effect transistors (HEFTs) for high-power, high-frequency applications. We find that the integration of gate dielectrics and field plates greatly improves the breakdown field in these devices, with one of the highest average breakdown fields of 5.3 MV/cm (a breakdown voltage of >260 V) with an associated maximum current density of 342 mA/mm and a cutoff frequency of 9.1 GHz. The reported results provide the potential of UWBG AlGaN HEFTs for the next generation of high-power radio frequency applications.
- 29 August 2025
- Published by AIP Publishing in APL Electronic Devices
- Vol. 1 (3)
Top Cited PapersOpen AccessHigh breakdown electric field (>5 MV/cm) in UWBG AlGaN transistors
We report on the design and demonstration of ultra-wide bandgap (UWBG) AlGaN-channel metal–insulator heterostructure field effect transistors (HEFTs) for high-power, high-frequency applications. We find that the integration of gate dielectrics and field plates greatly improves the breakdown field in these devices, with one of the highest average breakdown fields of 5.3 MV/cm (a breakdown voltage of >260 V) with an associated maximum current density of 342 mA/mm and a cutoff frequency of 9.1 GHz. The reported results provide the potential of UWBG AlGaN HEFTs for the next generation of high-power radio frequency applications.
- 10 February 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 126 (6)
Heterostructure and interfacial engineering for low-resistance contacts to ultra-wide bandgap AlGaN
We report on the heterostructure and interfacial engineering of metalorganic chemical vapor deposition (MOCVD) grown reverse graded contacts to ultra-wide bandgap AlGaN. A record low contact resistivity of 1.4 × 10−6 Ω cm2 was reported on an Al0.82Ga0.18N metal-semiconductor field effect transistor by compositionally grading the contact layer from Al0.85Ga0.15N → Al0.14Ga0.86N with degenerate doping and proper interfacial engineering considering bandgap-narrowing-induced band offset between the channel and the contact layer. This represents orders-of-magnitude of lower contact resistivity than that obtained in similar MOCVD-grown structures. A detailed, layer-by-layer analysis of the reverse graded contact and TCAD simulation of the bandgap narrowing effect highlighted that the reverse graded contact layer itself is extremely conductive, and interfacial resistance due to bandgap-narrowing-induced barrier between contact and channel dominates the contact resistance.
- 10 February 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 126 (6)
Heterostructure and interfacial engineering for low-resistance contacts to ultra-wide bandgap AlGaN
We report on the heterostructure and interfacial engineering of metalorganic chemical vapor deposition (MOCVD) grown reverse graded contacts to ultra-wide bandgap AlGaN. A record low contact resistivity of 1.4 × 10−6 Ω cm2 was reported on an Al0.82Ga0.18N metal-semiconductor field effect transistor by compositionally grading the contact layer from Al0.85Ga0.15N → Al0.14Ga0.86N with degenerate doping and proper interfacial engineering considering bandgap-narrowing-induced band offset between the channel and the contact layer. This represents orders-of-magnitude of lower contact resistivity than that obtained in similar MOCVD-grown structures. A detailed, layer-by-layer analysis of the reverse graded contact and TCAD simulation of the bandgap narrowing effect highlighted that the reverse graded contact layer itself is extremely conductive, and interfacial resistance due to bandgap-narrowing-induced barrier between contact and channel dominates the contact resistance.