YPYoungjun Park

Youngjun Park

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Youngjun Park has a total of 7 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Dynamic Motion of a Vane in Six Degrees of Freedom and Its Effect on Wear in a Rotary-Vane Compressor Considering Fluid Lubrication

    by Gwanghee Hong, Youngjun Park, Gunhee Jang

    Vanes are critical components of a rotary-vane compressor. If the vanes do not achieve sufficient contact with the inner wall of the cylinder, the compression chambers do not form completely. However, excessive contact between the vane and the cylinder wall can produce wear on both, also decreasing the lifespan of the compressor. We applied the Poisson equation and the Reynolds equation to calculate the gas force and fluid-reaction force acting on the vane. We solved the equations for the motion of the rigid vane in six degrees of freedom to determine the dynamic motion of the vane. We operated the rotary-vane compressor for 800 h under the same simulation conditions and measured the wear patterns of the vane, the bottom thrust bearing, and the cylinder wall. Finally, we validated the proposed method by confirming that the simulated contact force matches well with the measured wear patterns on the vane and the inner wall of the cylinder. The proposed method overcomes the limitations of the previous three-degrees-of-freedom analyses of the vane and will contribute to developing a robust and efficient rotary-vane compressor.

  • Open Access

    Lubrication Analysis of a Mechanical Seal Considering the Mixed Lubricant State of Gas and Liquid During External Power Shutdown of a Reactor Cooling Pump

    by Youngjun Park, Gwanghee Hong, Sanghyun Jun, Jeongmook Choi, Taegyu Kim, Minsoo Kang, Gunhee Jang

    We proposed a method to calculate the pressure, opening force, and leakage rate in a mechanical seal under the mixed lubricant state of a gas and liquid for the mechanical seal in a reactor cooling pump (RCP) during external power loss. We calculated the pressure by solving the nonlinear finite element equation composed of the linear Reynolds equation of an incompressible liquid lubricant and the nonlinear Reynolds equation of a compressible gas lubricant using the Newton–Raphson method. In addition, we calculated the temperature distribution by solving the two-dimensional energy equation utilizing the finite element method. Additionally, we included the turbulence effect in the incompressible liquid lubricant and the turbulence and slip effects in the compressible gas lubricant. The accuracy of the developed program was validated by comparing the simulated opening force and leakage rate of both the mechanical seal with the liquid lubricant and the mechanical seal with the gas lubricant with prior research. Our analysis shows that in high-temperature environments, the increase in the gas region at the lubrication surface leads to a decrease in pressure and opening force and an increase in the leakage rate. Conversely, as the outer pressure increases, the gas region decreases, resulting in an increase in pressure, opening force, and leakage rate.


  • Open Access

    Thermo-Fluid–Structural Coupled Analysis of a Mechanical Seal in Extended Loss of AC Power of a Reactor Coolant Pump

    by Youngjun Park, Gwanghee Hong, Sanghyun Jun, Jeongmook Choi, Taegyu Kim, Minsoo Kang, Gunhee Jang

    We proposed a numerical method to investigate the thermo-fluid–structural coupled characteristics of a mechanical seal of a reactor coolant pump (RCP), especially during extended loss of AC power (ELAP) operation. We developed a finite element program for the general Reynolds equation, including the turbulence effect to calculate the pressure, opening force, and leakage rate of fluid lubricant and the two-dimensional energy equation to calculate the temperature distribution of the fluid lubricant. We verified the accuracy of the developed program by comparing the simulated temperature distribution and leakage rate of this study with those of previous research. Heat conduction and elastic deformation due to pressure and temperature changes at the seal structure were analyzed using an ANSYS program. The results showed that temperature more significantly affected the elastic deformation of the seal structure near clearance than pressure both under normal and ELAP operating conditions. High temperature and pressure of the coolant under ELAP operating conditions deform the seal structure, resulting in a much smaller clearance of the fluid film than normal operating condition. However, even with a small clearance under ELAP operation, the leakage rate slightly increases due to the high internal pressure of the coolant. This research will contribute to the development of robust mechanical seals for RCPs by accurately predicting the characteristics of mechanical seals, especially when the RCP is operating under ELAP.


  • Open Access

    Effect of Laminar, Turbulent and Slip Conditions on the Dynamic Coefficients of a Dry Gas Seal

    by Youngjun Park, Mibbeum Hahn, Gunhee Jang

    The dynamic coefficients of a dry gas seal affect the dynamic characteristics of rotor-seal systems. Fluid films in a dry gas seal can be laminar, turbulent or with slip conditions, according to various operating conditions and design parameters. They can be defined as laminar or turbulent, depending on the Reynolds number, and as slip or non-slip, depending on the Knudsen number. However, previous research did not consider the effect of laminar, turbulent and slip conditions on the dynamic coefficients of a dry gas seal. We proposed a mathematical perturbation method to calculate the dynamic coefficients of the dry gas seal according to laminar, turbulent, and slip effects. We derived the perturbed equations of the modified Reynolds equation, which includes the effects of laminar, turbulent and slip conditions. The pressure of the modified Reynolds equation was solved using the finite element method and the Newton–Raphson method, and the perturbed pressures with respect to three degrees of freedom were calculated by substituting the calculated pressure into the perturbed equations. We verified the proposed method by comparing the simulated results with prior studies. The dynamic coefficients of a T-grooved dry gas seal were investigated according to laminar, turbulent, and slip conditions in a fluid film with different clearances.