Ana Cristina Carranza Sanchez
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ana Cristina Carranza Sanchez has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Eduardo Camacho- Espinosa
Centro de Investigación y de Estudios Avanzados del IPN-Unidad Mérida
3 shared publications - Enrique Rosendo
Posgrado en Dispositivos Semiconductores (PDS), Benemérita Universidad Autónoma de Puebla (BUAP)
3 shared publications - Crisoforo Morales
Centro de Investigaciónes en semiconductores, Instituto de Ciencias (ICUAP). BUAP
2 shared publications - Eduardo Flores
Applied Physics Department, Center for Research and Advanced Studies (CINVESTAV-Merida), Merida 97310, Mexico
2 shared publications - Ricardo Mis-Fernández
Applied Physics Department, CINVESTAV-IPN, Mérida, C.P. 97310, Yucatán, México
2 shared publications A Coyopol
Centro de Investigaciones en Dispositivos Semiconductores, Instituto de Ciencias, BUAP, 14 Sur y Av. San Claudio, C. U. Edificio IC-6, C.P. 72570 Puebla, Mexico
1 shared publication
Latest Publications
- Open Access
- 24 July 2026
- Published by Elsevier in Solar Energy
- Vol. 316
Indium-dependent performance and voltage limitation in fully sputtered indium zinc oxide/CdTe solar cells
- 24 July 2026
- Published by Elsevier in Solar Energy
- Vol. 316
Open AccessIndium-dependent performance and voltage limitation in fully sputtered indium zinc oxide/CdTe solar cells
- Open Access
- 24 October 2025
- Published by Springer Nature in Transactions on Electrical and Electronic Materials
- Vol. 27 (3) , 510-522
Theoretical Optimization of Environmentally Friendly Alternative Indium-Doped Zinc Oxide (IZO) in CdTe Solar Cell Technology by SCAPS-1D
This research paper investigates the potential use of indium-doped zinc oxide (IZO) as a window layer in solar cells. To achieve this, the heterostructure Al/ITO/IZO/CdTe/ back contact was simulated using SCAPS-1D, demonstrating its viability. The thickness and carrier concentration of both IZO and CdTe were systematically varied to optimize their values and optimal values was found to be 0.05 μm and N D =10 20 cm −3 for IZO and 3.0 μm and N A =10 16 cm −3 for CdTe respectively. Furthermore, the study explored the influence of defect density of IZO/CdTe interface on performance of solar cell, interval of simulation was from 10 10 to 10 15 cm −2 the better performance was obtained at lower defect density. Optimum shunt and series resistance values are in the interval of 3000–5000 Ω $$\:{\bullet\:cm}^{2}$$ and 1–5 Ω $$\:{\bullet\:cm}^{2}$$ respectively. Finally, it was demonstrated by extensive optimization of these parameters and using ITO as TCO and Pt as back contact, the highest predicted efficiency was 25.24%, with Voc of 0.96 V and Jsc of 30.12 mA/cm².- 24 October 2025
- Published by Springer Nature in Transactions on Electrical and Electronic Materials
- Vol. 27 (3) , 510-522
Open AccessTheoretical Optimization of Environmentally Friendly Alternative Indium-Doped Zinc Oxide (IZO) in CdTe Solar Cell Technology by SCAPS-1D
This research paper investigates the potential use of indium-doped zinc oxide (IZO) as a window layer in solar cells. To achieve this, the heterostructure Al/ITO/IZO/CdTe/ back contact was simulated using SCAPS-1D, demonstrating its viability. The thickness and carrier concentration of both IZO and CdTe were systematically varied to optimize their values and optimal values was found to be 0.05 μm and N D =10 20 cm −3 for IZO and 3.0 μm and N A =10 16 cm −3 for CdTe respectively. Furthermore, the study explored the influence of defect density of IZO/CdTe interface on performance of solar cell, interval of simulation was from 10 10 to 10 15 cm −2 the better performance was obtained at lower defect density. Optimum shunt and series resistance values are in the interval of 3000–5000 Ω $$\:{\bullet\:cm}^{2}$$ and 1–5 Ω $$\:{\bullet\:cm}^{2}$$ respectively. Finally, it was demonstrated by extensive optimization of these parameters and using ITO as TCO and Pt as back contact, the highest predicted efficiency was 25.24%, with Voc of 0.96 V and Jsc of 30.12 mA/cm². - Open Access
- 14 August 2024
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 39 (9) , 095007
Influence of power ramps on the physical properties of AZO thin films deposited at room temperature by RF magnetron sputtering technique
Aluminum-doped zinc oxide (AZO) thin films were deposited on glass substrates at room temperature by RF sputtering technique. Power ramps between 125 and 105 W were applied with a step of 4 W by intervals of 15, 7.5 and 1.8 min, for 180 min at 1.60 Pa. In this study, we investigated the structural, morphological, electrical, and optical properties of AZO films. X-ray Diffraction analysis showed that the films have a wurtzite-type hexagonal crystalline structure with a preferential crystallographic orientation (002) normal to the c axis. The average transmittance is greater than 76% for the wavelength range in the visible spectrum. The bandgap values were found between 3.32 and 4.01 eV, and refractive index was 1.79–2.60. Atomic force microscope measurements show homogeneous films with a roughness between 17–22 nm. A minimum resistivity value of 2.0 × 10−3 Ω cm was obtained for the film by using a power ramp of 4 W/1.8 min.
- 14 August 2024
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 39 (9) , 095007
Open AccessInfluence of power ramps on the physical properties of AZO thin films deposited at room temperature by RF magnetron sputtering technique
Aluminum-doped zinc oxide (AZO) thin films were deposited on glass substrates at room temperature by RF sputtering technique. Power ramps between 125 and 105 W were applied with a step of 4 W by intervals of 15, 7.5 and 1.8 min, for 180 min at 1.60 Pa. In this study, we investigated the structural, morphological, electrical, and optical properties of AZO films. X-ray Diffraction analysis showed that the films have a wurtzite-type hexagonal crystalline structure with a preferential crystallographic orientation (002) normal to the c axis. The average transmittance is greater than 76% for the wavelength range in the visible spectrum. The bandgap values were found between 3.32 and 4.01 eV, and refractive index was 1.79–2.60. Atomic force microscope measurements show homogeneous films with a roughness between 17–22 nm. A minimum resistivity value of 2.0 × 10−3 Ω cm was obtained for the film by using a power ramp of 4 W/1.8 min.
- Open Access
Performance simulation of solar cell based on AZO/CdTe heterostructure by SCAPS 1D software