Jillian Karpyshyn
Jillian Karpyshyn has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Ivan Wong
Department of Orthopaedic Surgery, Nova Scotia Health, Halifax, Nova Scotia, Canada
3 shared publications Jie Ma
Division of Orthopaedic Surgery, Nova Scotia Health, Halifax, Nova Scotia, Canada
2 shared publicationsPascal Boileau
ICR-Institute for Sports and Reconstructive Bone & Joint Surgery, Clinique Kantys Centre, Groupe Kantys, Nice, France
2 shared publicationsAaron J Bois
Section of Orthopaedic Surgery, Department of Surgery, Cumming School of Medicine, University of Calgary, Calgary, AB, Canada
1 shared publicationCatherine Hui
Division of Orthopaedics, Department of Surgery, Faculty of Medicine and Dentistry, University of Alberta, Edmonton, Alberta, Canada
1 shared publication- Eiji Itoi
Department of Orthopaedic Surgery, Tohoku Rosai Hospital, Sendai, Japan
1 shared publication
Latest Publications
- Open Access
- 11 December 2025
- Published by Elsevier in JSES Reviews, Reports, and Techniques
- Vol. 6 (2) , 100640
Accessory subscapularis muscle: implications for muscle splitting during arthroscopic Latarjet procedure
- 11 December 2025
- Published by Elsevier in JSES Reviews, Reports, and Techniques
- Vol. 6 (2) , 100640
Open AccessAccessory subscapularis muscle: implications for muscle splitting during arthroscopic Latarjet procedure
- Open Access
- 10 June 2025
- Published by Elsevier in JSES Reviews, Reports, and Techniques
- Vol. 5 (4) , 1138-1142
Arthroscopic glenoidoplasty for correcting overlateralized coracoid graft with painful and stiff shoulder after Latarjet procedure: surgical technique and case series
- 10 June 2025
- Published by Elsevier in JSES Reviews, Reports, and Techniques
- Vol. 5 (4) , 1138-1142
Open AccessArthroscopic glenoidoplasty for correcting overlateralized coracoid graft with painful and stiff shoulder after Latarjet procedure: surgical technique and case series
- Open Access
- 31 May 2024
- Published by Elsevier in Journal of Shoulder and Elbow Surgery
- Vol. 33 (12) , 2867-2877
Clinical and radiographic outcomes of primary vs. revision arthroscopic anatomic glenoid reconstruction with distal tibial allograft for anterior shoulder instability with bone loss
- 31 May 2024
- Published by Elsevier in Journal of Shoulder and Elbow Surgery
- Vol. 33 (12) , 2867-2877
Open AccessClinical and radiographic outcomes of primary vs. revision arthroscopic anatomic glenoid reconstruction with distal tibial allograft for anterior shoulder instability with bone loss
- Open Access
- 29 October 2023
- Published by Elsevier in Journal of ISAKOS
- Vol. 9 (2) , 168-183
Controversies in surgical management of anterior shoulder instability. State of the Art
- 29 October 2023
- Published by Elsevier in Journal of ISAKOS
- Vol. 9 (2) , 168-183
Open AccessControversies in surgical management of anterior shoulder instability. State of the Art
- Open Access
- 14 March 2023
- Published by Elsevier in Journal of Shoulder and Elbow Arthroplasty
- Vol. 7
3D Printed Patient-Specific Cutting Guides for Bone Grafting in Reverse Shoulder Arthroplasty: A Novel Technique
- 14 March 2023
- Published by Elsevier in Journal of Shoulder and Elbow Arthroplasty
- Vol. 7
Open Access3D Printed Patient-Specific Cutting Guides for Bone Grafting in Reverse Shoulder Arthroplasty: A Novel Technique
- Open Access
- 1 May 2021
- Published by SAGE Publications in Orthopaedic Journal of Sports Medicine
- Vol. 9 (5)
Biomechanical Strength of All-Inside ACL Reconstruction Grafts Using Side-to-Side and Backup Fixation
The all-inside anterior cruciate ligament reconstruction (ACLR) procedure uses a single hamstring tendon folded twice and secured to itself to form a 4-stranded graft. There are several possible configurations for preparing the graft. To investigate the biomechanical properties of a new graft preparation technique in comparison with 2 commonly used configurations. Controlled laboratory study. Five porcine flexor tendons were prepared into the test graft configuration: side-to-side fixation with a backup fixation at the button loop (graft M). The test configuration was compared with the results of a previous study that included grafts with simple interrupted sutures (graft A; n = 5) and end-to-end fixation (graft C; n = 5). All grafts were subjected to the same mechanical testing protocol to determine the mean failure load, stiffness, rate of elongation, and total elongation during both cyclic loading and pull to failure. Differences between groups were evaluated. Graft A had a significantly lower failure load (637 ± 99 N) compared with graft M (883 ± 66 N; P = .002) and graft C (846 ± 26 N; P = .002). Graft A also had significantly lower stiffness (166 ± 12 N/mm) compared with graft M (215 ± 8 N/mm; P < .001) and graft C (212 ± 11 N/mm; P < .001). Graft C had a significantly lower elongation during cyclic loading (3.42 ± 0.24 mm) compared with graft M (4.37 ± 0.74 mm; P = .026) and graft A (4.90 ± 0.88 mm; P = .006). The unsecured fixation was the weakest graft, with the lowest failure load and stiffness. The new side-to-side configuration and end-to-end configuration were equally strong. The new side-to-side configuration was not biomechanically superior to the end-to-end configuration; however, they were both stronger than unsecured fixation. As the all-inside ACLR is gaining popularity, this study provides surgeons with a new method of preparing grafts and evaluates the method with respect to currently used configurations.
- 1 May 2021
- Published by SAGE Publications in Orthopaedic Journal of Sports Medicine
- Vol. 9 (5)
Open AccessBiomechanical Strength of All-Inside ACL Reconstruction Grafts Using Side-to-Side and Backup Fixation
The all-inside anterior cruciate ligament reconstruction (ACLR) procedure uses a single hamstring tendon folded twice and secured to itself to form a 4-stranded graft. There are several possible configurations for preparing the graft. To investigate the biomechanical properties of a new graft preparation technique in comparison with 2 commonly used configurations. Controlled laboratory study. Five porcine flexor tendons were prepared into the test graft configuration: side-to-side fixation with a backup fixation at the button loop (graft M). The test configuration was compared with the results of a previous study that included grafts with simple interrupted sutures (graft A; n = 5) and end-to-end fixation (graft C; n = 5). All grafts were subjected to the same mechanical testing protocol to determine the mean failure load, stiffness, rate of elongation, and total elongation during both cyclic loading and pull to failure. Differences between groups were evaluated. Graft A had a significantly lower failure load (637 ± 99 N) compared with graft M (883 ± 66 N; P = .002) and graft C (846 ± 26 N; P = .002). Graft A also had significantly lower stiffness (166 ± 12 N/mm) compared with graft M (215 ± 8 N/mm; P < .001) and graft C (212 ± 11 N/mm; P < .001). Graft C had a significantly lower elongation during cyclic loading (3.42 ± 0.24 mm) compared with graft M (4.37 ± 0.74 mm; P = .026) and graft A (4.90 ± 0.88 mm; P = .006). The unsecured fixation was the weakest graft, with the lowest failure load and stiffness. The new side-to-side configuration and end-to-end configuration were equally strong. The new side-to-side configuration was not biomechanically superior to the end-to-end configuration; however, they were both stronger than unsecured fixation. As the all-inside ACLR is gaining popularity, this study provides surgeons with a new method of preparing grafts and evaluates the method with respect to currently used configurations.