Aaron Chou
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Aaron Chou has a total of 115 co-authors. Here are the top co-authors by number of shared publications:
- William Wester
Fermi National Accelerator Laboratory, P.O. Box 500, Batavia, IL 60510, USA
3 shared publications - Akash V. Dixit
National Institute of Standards and Technology, Boulder
2 shared publications - Chris Stoughton
Fermi National Accelerator Laboratory
2 shared publications - Craig Hogan
University of Chicago
2 shared publications - H.Richard Gustafson
Univ. of Michigan, Ann Arbor, MI (United States)
2 shared publications M. Hollister
Fermi National Accelerator Laboratory, Batavia, USA
2 shared publications
Latest Publications
- Open Access
- 13 November 2025
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 135 (20) , 201002
Flux-Tunable Cavity for Dark Matter Detection
Developing a dark matter detector with wide mass tunability is an immensely desirable property, yet, it is challenging due to maintaining strong sensitivity. Resonant cavities for dark matter detection have traditionally employed mechanical tuning, moving parts around to change electromagnetic boundary conditions. However, these cavities have proven challenging to operate in sub-Kelvin cryogenic environments due to differential thermal contraction, low heat capacities, and low thermal conductivities. Instead, we develop an electronically tunable cavity architecture by coupling a superconducting 3D microwave cavity with a dc flux tunable superconducting quantum interference device. With a flux delivery system engineered to maintain high coherence in the cavity, we perform a hidden-photon dark matter search below the quantum-limited threshold. A microwave photon counting technique is employed through repeated quantum nondemolition measurements using a transmon qubit. With this device, we perform a hidden-photon search and constrain the kinetic mixing angle to ϵ < 8.2 × 10 − 15 in a tunable band from 5.672 to 5.694 GHz. By coupling multimode tunable cavities to the transmon, wider hidden-photon searching ranges are possible.
- 13 November 2025
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 135 (20) , 201002
Open AccessFlux-Tunable Cavity for Dark Matter Detection
Developing a dark matter detector with wide mass tunability is an immensely desirable property, yet, it is challenging due to maintaining strong sensitivity. Resonant cavities for dark matter detection have traditionally employed mechanical tuning, moving parts around to change electromagnetic boundary conditions. However, these cavities have proven challenging to operate in sub-Kelvin cryogenic environments due to differential thermal contraction, low heat capacities, and low thermal conductivities. Instead, we develop an electronically tunable cavity architecture by coupling a superconducting 3D microwave cavity with a dc flux tunable superconducting quantum interference device. With a flux delivery system engineered to maintain high coherence in the cavity, we perform a hidden-photon dark matter search below the quantum-limited threshold. A microwave photon counting technique is employed through repeated quantum nondemolition measurements using a transmon qubit. With this device, we perform a hidden-photon search and constrain the kinetic mixing angle to ϵ < 8.2 × 10 − 15 in a tunable band from 5.672 to 5.694 GHz. By coupling multimode tunable cavities to the transmon, wider hidden-photon searching ranges are possible.
- Open Access
- 11 November 2025
- Published by Springer Nature in Nature Communications
- Vol. 16 (1) , 1-5
Measurement of correlated charge noise in superconducting qubits at an underground facility
The charge environment of superconducting qubits may be studied through the introduction of controlled, quantified amounts of ionizing radiation. We measure space- and time-correlated charge jumps on a four-qubit device, operating 107 meters below the Earth’s surface in a low-radiation, cryogenic facility designed for the characterization of low-threshold particle detectors. The rock overburden of this facility reduces the cosmic ray muon flux by over 99% compared to laboratories at sea level. Combined with 4 π coverage of a movable lead shield, this facility enables quantifiable control over the flux of ionizing radiation on the qubit device. Long-time-series charge tomography measurements on these weakly charge-sensitive qubits capture discontinuous jumps in the induced charge on the qubit islands, corresponding to the interaction of ionizing radiation with the qubit substrate. The rate of these charge jumps scales with the flux of ionizing radiation on the qubit package, as characterized by a series of independent measurements on another energy-resolving detector operating simultaneously in the same cryostat with the qubits. Using lead shielding, we achieve a minimum charge jump rate of $$0.1{9}_{-0.03}^{+0.04}$$ mHz, almost an order of magnitude lower than that measured in surface tests, but a factor of roughly seven higher than expected based on reduction of ambient gammas alone. We operate four qubits for over 22 consecutive hours with zero correlated charge jumps at length scales above three millimeters.- 11 November 2025
- Published by Springer Nature in Nature Communications
- Vol. 16 (1) , 1-5
Open AccessMeasurement of correlated charge noise in superconducting qubits at an underground facility
The charge environment of superconducting qubits may be studied through the introduction of controlled, quantified amounts of ionizing radiation. We measure space- and time-correlated charge jumps on a four-qubit device, operating 107 meters below the Earth’s surface in a low-radiation, cryogenic facility designed for the characterization of low-threshold particle detectors. The rock overburden of this facility reduces the cosmic ray muon flux by over 99% compared to laboratories at sea level. Combined with 4 π coverage of a movable lead shield, this facility enables quantifiable control over the flux of ionizing radiation on the qubit device. Long-time-series charge tomography measurements on these weakly charge-sensitive qubits capture discontinuous jumps in the induced charge on the qubit islands, corresponding to the interaction of ionizing radiation with the qubit substrate. The rate of these charge jumps scales with the flux of ionizing radiation on the qubit package, as characterized by a series of independent measurements on another energy-resolving detector operating simultaneously in the same cryostat with the qubits. Using lead shielding, we achieve a minimum charge jump rate of $$0.1{9}_{-0.03}^{+0.04}$$ mHz, almost an order of magnitude lower than that measured in surface tests, but a factor of roughly seven higher than expected based on reduction of ambient gammas alone. We operate four qubits for over 22 consecutive hours with zero correlated charge jumps at length scales above three millimeters. - Top Cited PapersOpen Access
- 1 April 2023
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 94 (4)
Dark matter axion search using a Josephson Traveling wave parametric amplifier
We describe the first implementation of a Josephson Traveling Wave Parametric Amplifier (JTWPA) in an axion dark matter search. The operation of the JTWPA for a period of about two weeks achieved sensitivity to axion-like particle dark matter with axion–photon couplings above 10−13 Ge V−1 over a narrow range of axion masses centered around 19.84 µeV by tuning the resonant frequency of the cavity over the frequency range of 4796.7–4799.5 MHz. The JTWPA was operated in the insert of the axion dark matter experiment as part of an independent receiver chain that was attached to a 0.56-l cavity. The ability of the JTWPA to deliver high gain over a wide (3 GHz) bandwidth has engendered interest from those aiming to perform broadband axion searches, a longstanding goal in this field.
- 1 April 2023
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 94 (4)
Top Cited PapersOpen AccessDark matter axion search using a Josephson Traveling wave parametric amplifier
We describe the first implementation of a Josephson Traveling Wave Parametric Amplifier (JTWPA) in an axion dark matter search. The operation of the JTWPA for a period of about two weeks achieved sensitivity to axion-like particle dark matter with axion–photon couplings above 10−13 Ge V−1 over a narrow range of axion masses centered around 19.84 µeV by tuning the resonant frequency of the cavity over the frequency range of 4796.7–4799.5 MHz. The JTWPA was operated in the insert of the axion dark matter experiment as part of an independent receiver chain that was attached to a 0.56-l cavity. The ability of the JTWPA to deliver high gain over a wide (3 GHz) bandwidth has engendered interest from those aiming to perform broadband axion searches, a longstanding goal in this field.
- Open Access
- 22 March 2023
- Published by Office of Scientific and Technical Information (OSTI)
The Fermilab Holometer: A program to measure Planck scale indeterminacy
The U.S. Department of Energy's Office of Scientific and Technical Information
- 22 March 2023
- Published by Office of Scientific and Technical Information (OSTI)
Open AccessThe Fermilab Holometer: A program to measure Planck scale indeterminacy
The U.S. Department of Energy's Office of Scientific and Technical Information
- Open Access
- 1 November 2009
- Published by Office of Scientific and Technical Information (OSTI)
The Fermilab Holometer: A Program to Measure Planck Scale Indeterminacy
The U.S. Department of Energy's Office of Scientific and Technical Information
- 1 November 2009
- Published by Office of Scientific and Technical Information (OSTI)
Open AccessThe Fermilab Holometer: A Program to Measure Planck Scale Indeterminacy
The U.S. Department of Energy's Office of Scientific and Technical Information
- Open Access
- 29 July 2002
- Published by Office of Scientific and Technical Information (OSTI)
Optimizing the Linear Collider Detector for the Measurement of the Higgs to Charm Branching Ratio
Several different vertex detector designs for the Linear Collider Detector (LCD) are evaluated in the context of measurements of the branching ratio of the standard model Higgs particle decaying into charm/anti-charm final states. Fast Monte Carlo simulations are used to model the detector and neural network-optimized flavor tagging is used to perform the measurements. These tools are used to study the effects of pixel resolution, material thickness, and inner layer radius on the flavor tagging efficiency-purity curve and ultimately on the branching ratio measurement error.
- 29 July 2002
- Published by Office of Scientific and Technical Information (OSTI)
Open AccessOptimizing the Linear Collider Detector for the Measurement of the Higgs to Charm Branching Ratio
Several different vertex detector designs for the Linear Collider Detector (LCD) are evaluated in the context of measurements of the branching ratio of the standard model Higgs particle decaying into charm/anti-charm final states. Fast Monte Carlo simulations are used to model the detector and neural network-optimized flavor tagging is used to perform the measurements. These tools are used to study the effects of pixel resolution, material thickness, and inner layer radius on the flavor tagging efficiency-purity curve and ultimately on the branching ratio measurement error.