Edi Kadarsa
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Edi Kadarsa has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Joni Arliansyah
Sriwijaya University
3 shared publications - Joni Arliansyah2 shared publications
- Ramadhani Ramadhani
Universitas IBA
2 shared publications - Abdulfatah Abdu Yusuf
University of Liberia
1 shared publication - Delli Noviarti Rachman
Student of Engineering Science Study Program Doctoral, Sriwijaya University, Faculty of Engineering, Palembang, Indonesia
1 shared publication - Harmein Rahman
Institut Teknologi Bandung
1 shared publication
Latest Publications
- 16 October 2026
- Published by Turkish Journal of Engineering in Turkish Journal of Engineering
- Vol. 10 (4) , 1339-1351
Performance of HDPE Waste and Lignin-Modified Asphalt for Sustainable Road Pavement
Asphalt is the main binding material in flexible pavements, which is viscoelastic, flexible, and recyclable, thus supporting sustainable road construction. However, conventional asphalt has limitations in withstanding heavy traffic loads and temperature variations, making it susceptible to rutting and durability problems. Utilizing High-Density Polyethylene (HDPE) plastic waste and lignin as asphalt modifiers is a promising alternative because HDPE can enhance stiffness and deformation resistance. In contrast, lignin can improve binder compatibility and mixture stability. This research aims to determine the Optimum Asphalt Content (OAC) for 60/70 penetration asphalt modified with 4%, 5%, and 6% HDPE and 3% lignin. Evaluation was conducted using the Marshall test and the Marshall immersion test. The research results showed that the OAC values were 5.65% for penetration 60/70 asphalt, 5.63% for 4H3L, 5.73% for 5H3L, and 5.60% for 6H3L. The highest Marshall stability was obtained in the 6H3L mixture at 2316 kg, while the 24-hour immersion stability remained high at 2099 kg. All mixtures also achieved Residual Strength Index values above 90%, indicating adequate resistance to moisture damage. The study contributes experimental evidence that HDPE waste and lignin can improve mixture stability while maintaining adequate moisture resistance
- 16 October 2026
- Published by Turkish Journal of Engineering in Turkish Journal of Engineering
- Vol. 10 (4) , 1339-1351
Performance of HDPE Waste and Lignin-Modified Asphalt for Sustainable Road Pavement
Asphalt is the main binding material in flexible pavements, which is viscoelastic, flexible, and recyclable, thus supporting sustainable road construction. However, conventional asphalt has limitations in withstanding heavy traffic loads and temperature variations, making it susceptible to rutting and durability problems. Utilizing High-Density Polyethylene (HDPE) plastic waste and lignin as asphalt modifiers is a promising alternative because HDPE can enhance stiffness and deformation resistance. In contrast, lignin can improve binder compatibility and mixture stability. This research aims to determine the Optimum Asphalt Content (OAC) for 60/70 penetration asphalt modified with 4%, 5%, and 6% HDPE and 3% lignin. Evaluation was conducted using the Marshall test and the Marshall immersion test. The research results showed that the OAC values were 5.65% for penetration 60/70 asphalt, 5.63% for 4H3L, 5.73% for 5H3L, and 5.60% for 6H3L. The highest Marshall stability was obtained in the 6H3L mixture at 2316 kg, while the 24-hour immersion stability remained high at 2099 kg. All mixtures also achieved Residual Strength Index values above 90%, indicating adequate resistance to moisture damage. The study contributes experimental evidence that HDPE waste and lignin can improve mixture stability while maintaining adequate moisture resistance
- Open Access
- 20 June 2025
- Published by Taylor & Francis in Journal of Natural Fibers
- Vol. 22 (1)
Bio-Based Rice Husk Ash as an Eco-Friendly Filler in Pre-Vulcanized Latex Asphalt Concrete Wearing Course Mixtures
- 20 June 2025
- Published by Taylor & Francis in Journal of Natural Fibers
- Vol. 22 (1)
Open AccessBio-Based Rice Husk Ash as an Eco-Friendly Filler in Pre-Vulcanized Latex Asphalt Concrete Wearing Course Mixtures
- Open Access
- 24 May 2024
- Published by Warsaw University of Life Sciences - SGGW Press in Scientific Review Engineering and Environmental Sciences (SREES)
- Vol. 33 (2) , 185-204
The effect of pre-vulcanized latex usage on Marshall characteristics and stiffness modulus in hot mix asphalt wearing course (AC-WC) mixtures
Flexible pavement itself uses asphalt binder as a binding material between aggregates, but with the increasing number of vehicle loads, the ability of flexible pavement needs to be improved. A rubber is a natural polymer material that can be used to improve asphalt mixtures’ performance. This paper aims to analyze the effect of using pre-vulcanized latex on characteristics in hot mix asphalt wearing course mixtures. Pre-vulcanized latex is used as a substitute material for asphalt binder at levels of 7% and 9% by weight. Based on Marshall test results, the AC-WC mixture using pre-vulcanized latex achieved Marshall stability of 11.63 kN or increased by 32.28% at 7% content, while at 9%, it resulted in Marshall stability of 10.69 kN or increased by 21.06%, compared to the specification limit, which is 8.83 kN. The stiffness modulus test results of the asphalt mixture showed that at a temperature of 25°C, there was an increase of 17.46% and 28.26%, respectively, when using pre-vulcanized latex at levels of 7% and 9%. These findings indicate that the use of pre-vulcanized latex as a partial replacement for asphalt has a positive impact on temperature changes in the pavement material.
- 24 May 2024
- Published by Warsaw University of Life Sciences - SGGW Press in Scientific Review Engineering and Environmental Sciences (SREES)
- Vol. 33 (2) , 185-204
Open AccessThe effect of pre-vulcanized latex usage on Marshall characteristics and stiffness modulus in hot mix asphalt wearing course (AC-WC) mixtures
Flexible pavement itself uses asphalt binder as a binding material between aggregates, but with the increasing number of vehicle loads, the ability of flexible pavement needs to be improved. A rubber is a natural polymer material that can be used to improve asphalt mixtures’ performance. This paper aims to analyze the effect of using pre-vulcanized latex on characteristics in hot mix asphalt wearing course mixtures. Pre-vulcanized latex is used as a substitute material for asphalt binder at levels of 7% and 9% by weight. Based on Marshall test results, the AC-WC mixture using pre-vulcanized latex achieved Marshall stability of 11.63 kN or increased by 32.28% at 7% content, while at 9%, it resulted in Marshall stability of 10.69 kN or increased by 21.06%, compared to the specification limit, which is 8.83 kN. The stiffness modulus test results of the asphalt mixture showed that at a temperature of 25°C, there was an increase of 17.46% and 28.26%, respectively, when using pre-vulcanized latex at levels of 7% and 9%. These findings indicate that the use of pre-vulcanized latex as a partial replacement for asphalt has a positive impact on temperature changes in the pavement material.
- Open Access
- 14 May 2024
- Published by Warsaw University of Life Sciences - SGGW Press in Scientific Review Engineering and Environmental Sciences (SREES)
- Vol. 33 (2) , 205-224
Public-private partnerships scheme of pioneer train case study in South Sumatera area
Pioneer trains in Indonesia have been fully funded by the government. The construction needs a lot of funding that would burden the state budget. One of the alternatives is the public-private partnership scheme. This study aims to analyze the most effective unbundling scenario for financing and maintaining the Indralaya-Tanjung Senai train. The life cycle costs and conducting sensitivity analysis according to applicable regulations. The scenarios are based on ticket price increases and government support for the operation and maintenance (O&M) for this pioneer train route, calculated net present value (NPV) and internal rate of return (IRR) value. Scenario 1 assumes that tickets do not receive subsidies; private companies are responsible for O&M costs. Scenario 2 assumes that ticket prices are set by private companies; the government is responsible for procurement and maintenance costs. Scenario 3 assumes that the government provides subsidies of IDR 10,000 per passenger as well as railway infrastructure; private companies bear the cost of procuring railbuses and operational expenses. Based on calculations with Scenario 1 NPV is IDR 0.73 billion; with Scenario 2 is IDR 4.64 billion and with Scenario 3 is IDR (–)1.34 billion. The analysis shows that increasing passenger fares according to price raises and inflation rates, and subsidies from governments for maintenance costs will make this railroad project financially feasible.
- 14 May 2024
- Published by Warsaw University of Life Sciences - SGGW Press in Scientific Review Engineering and Environmental Sciences (SREES)
- Vol. 33 (2) , 205-224
Open AccessPublic-private partnerships scheme of pioneer train case study in South Sumatera area
Pioneer trains in Indonesia have been fully funded by the government. The construction needs a lot of funding that would burden the state budget. One of the alternatives is the public-private partnership scheme. This study aims to analyze the most effective unbundling scenario for financing and maintaining the Indralaya-Tanjung Senai train. The life cycle costs and conducting sensitivity analysis according to applicable regulations. The scenarios are based on ticket price increases and government support for the operation and maintenance (O&M) for this pioneer train route, calculated net present value (NPV) and internal rate of return (IRR) value. Scenario 1 assumes that tickets do not receive subsidies; private companies are responsible for O&M costs. Scenario 2 assumes that ticket prices are set by private companies; the government is responsible for procurement and maintenance costs. Scenario 3 assumes that the government provides subsidies of IDR 10,000 per passenger as well as railway infrastructure; private companies bear the cost of procuring railbuses and operational expenses. Based on calculations with Scenario 1 NPV is IDR 0.73 billion; with Scenario 2 is IDR 4.64 billion and with Scenario 3 is IDR (–)1.34 billion. The analysis shows that increasing passenger fares according to price raises and inflation rates, and subsidies from governments for maintenance costs will make this railroad project financially feasible.
- Open Access
- 1 April 2023
- Published by Atlantis Press SARL
- p. 220-232
Material Substitution for Flexible Pavement Using Waste Material Fly Ash and Bottom Ash from Bukit Asam Electric Steam Power Plant
- 1 April 2023
- Published by Atlantis Press SARL
- p. 220-232
Open AccessMaterial Substitution for Flexible Pavement Using Waste Material Fly Ash and Bottom Ash from Bukit Asam Electric Steam Power Plant
- Open Access
- 1 April 2023
- Published by Atlantis Press SARL
- p. 272-279
The Waste Characteristics of Demolition Construction Rigid Pavement as Aggregate’s Alternative on Road Pavement
- 1 April 2023
- Published by Atlantis Press SARL
- p. 272-279
Open AccessThe Waste Characteristics of Demolition Construction Rigid Pavement as Aggregate’s Alternative on Road Pavement