Ramadhani Ramadhani
Research Subjects
Ramadhani Ramadhani has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Edi Kadarsa
Sriwijaya University
2 shared publications - Hendrik Jimmyanto
Universitas Tridinanti
2 shared publications - Abdulfatah Abdu Yusuf
University of Liberia
1 shared publication - Harmein Rahman
Institut Teknologi Bandung
1 shared publication Joni Arliansyah
Sriwijaya University, Faculty of Engineering, Civil Engineering Department, Indonesia
1 shared publication- Joni Arliansyah
Sriwijaya University
1 shared publication
Latest Publications
- Open Access
- 1 May 2026
- Published by Mustansiriyah University College of Engineering in Journal of Engineering and Sustainable Development
- Vol. 30 (3) , 310-323
Performance Characterization of Rubberized Asphalt Mixtures Incorporating Waste Tire and Solid Natural Rubber
The performance of asphalt mixtures modified with 7% and 10% waste tire and solid natural rubber is assessed in this study, along with the effects of replacing fine aggregate with these materials. According to binder testing, a 10% rubber modification improved viscosity and deformation resistance while raising the softening point to 62.25°C. According to Marshall's findings, modified binders needed a higher optimal asphalt content of 6.05% to 6.25%. While the 7% modification produced the highest stability of 23.0 kN, replacing 50% of the river sand with Solid Natural Rubber decreased stability to 6.29 kN, falling short of requirements due to reduced structural rigidity. The 10% rubber mixture showed notable increases in stiffness modulus, increasing by 88.99% at 25°C and 105.69% at 40°C, according to testing. Additionally, the 10% modification achieved the highest durability, with 3,701 cycles, a 9.4% improvement over the control, according to the Indirect Tensile Fatigue Test results. According to the study's findings, rubber modifications of 7% and 10% greatly increase load-bearing capacity and fatigue resistance; however, in order to preserve the pavement's structural stability and integrity, rubber use as a fine aggregate replacement must be strictly limited.
- 1 May 2026
- Published by Mustansiriyah University College of Engineering in Journal of Engineering and Sustainable Development
- Vol. 30 (3) , 310-323
Open AccessPerformance Characterization of Rubberized Asphalt Mixtures Incorporating Waste Tire and Solid Natural Rubber
The performance of asphalt mixtures modified with 7% and 10% waste tire and solid natural rubber is assessed in this study, along with the effects of replacing fine aggregate with these materials. According to binder testing, a 10% rubber modification improved viscosity and deformation resistance while raising the softening point to 62.25°C. According to Marshall's findings, modified binders needed a higher optimal asphalt content of 6.05% to 6.25%. While the 7% modification produced the highest stability of 23.0 kN, replacing 50% of the river sand with Solid Natural Rubber decreased stability to 6.29 kN, falling short of requirements due to reduced structural rigidity. The 10% rubber mixture showed notable increases in stiffness modulus, increasing by 88.99% at 25°C and 105.69% at 40°C, according to testing. Additionally, the 10% modification achieved the highest durability, with 3,701 cycles, a 9.4% improvement over the control, according to the Indirect Tensile Fatigue Test results. According to the study's findings, rubber modifications of 7% and 10% greatly increase load-bearing capacity and fatigue resistance; however, in order to preserve the pavement's structural stability and integrity, rubber use as a fine aggregate replacement must be strictly limited.
- Open Access
- 20 June 2025
- Published by Taylor & Francis in Journal of Natural Fibers
- Vol. 22 (1)
Bio-Based Rice Husk Ash as an Eco-Friendly Filler in Pre-Vulcanized Latex Asphalt Concrete Wearing Course Mixtures
- 20 June 2025
- Published by Taylor & Francis in Journal of Natural Fibers
- Vol. 22 (1)
Open AccessBio-Based Rice Husk Ash as an Eco-Friendly Filler in Pre-Vulcanized Latex Asphalt Concrete Wearing Course Mixtures
- Open Access
- 24 May 2024
- Published by Warsaw University of Life Sciences - SGGW Press in Scientific Review Engineering and Environmental Sciences (SREES)
- Vol. 33 (2) , 185-204
The effect of pre-vulcanized latex usage on Marshall characteristics and stiffness modulus in hot mix asphalt wearing course (AC-WC) mixtures
Flexible pavement itself uses asphalt binder as a binding material between aggregates, but with the increasing number of vehicle loads, the ability of flexible pavement needs to be improved. A rubber is a natural polymer material that can be used to improve asphalt mixtures’ performance. This paper aims to analyze the effect of using pre-vulcanized latex on characteristics in hot mix asphalt wearing course mixtures. Pre-vulcanized latex is used as a substitute material for asphalt binder at levels of 7% and 9% by weight. Based on Marshall test results, the AC-WC mixture using pre-vulcanized latex achieved Marshall stability of 11.63 kN or increased by 32.28% at 7% content, while at 9%, it resulted in Marshall stability of 10.69 kN or increased by 21.06%, compared to the specification limit, which is 8.83 kN. The stiffness modulus test results of the asphalt mixture showed that at a temperature of 25°C, there was an increase of 17.46% and 28.26%, respectively, when using pre-vulcanized latex at levels of 7% and 9%. These findings indicate that the use of pre-vulcanized latex as a partial replacement for asphalt has a positive impact on temperature changes in the pavement material.
- 24 May 2024
- Published by Warsaw University of Life Sciences - SGGW Press in Scientific Review Engineering and Environmental Sciences (SREES)
- Vol. 33 (2) , 185-204
Open AccessThe effect of pre-vulcanized latex usage on Marshall characteristics and stiffness modulus in hot mix asphalt wearing course (AC-WC) mixtures
Flexible pavement itself uses asphalt binder as a binding material between aggregates, but with the increasing number of vehicle loads, the ability of flexible pavement needs to be improved. A rubber is a natural polymer material that can be used to improve asphalt mixtures’ performance. This paper aims to analyze the effect of using pre-vulcanized latex on characteristics in hot mix asphalt wearing course mixtures. Pre-vulcanized latex is used as a substitute material for asphalt binder at levels of 7% and 9% by weight. Based on Marshall test results, the AC-WC mixture using pre-vulcanized latex achieved Marshall stability of 11.63 kN or increased by 32.28% at 7% content, while at 9%, it resulted in Marshall stability of 10.69 kN or increased by 21.06%, compared to the specification limit, which is 8.83 kN. The stiffness modulus test results of the asphalt mixture showed that at a temperature of 25°C, there was an increase of 17.46% and 28.26%, respectively, when using pre-vulcanized latex at levels of 7% and 9%. These findings indicate that the use of pre-vulcanized latex as a partial replacement for asphalt has a positive impact on temperature changes in the pavement material.