XWXinyi Wen

Xinyi Wen

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Xinyi Wen has a total of 32 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    720 V quasi-vertical GaN-on-silicon p–n diodes with surge capability fabricated using selective area growth

    by Mohammed El Amrani, Junrui Lyu, Xinyi Wen, Alberto Marcuzzi, David Plaza Arguello, Zakariae M'Qaddem, Thomas Kaltsounis, Hala El Rammouz, Gaudenzio Meneghesso, Matteo Meneghini, et al.

    This work demonstrates, for the first time, avalanche breakdown capability in quasi-vertical gallium nitride (GaN) on silicon (Si) substrates employing localized epitaxial growth. On industry-standard 200 mm wafers, we integrated an 8 μm thick GaN drift layer onto Si, enabling the fabrication of 720 V quasi-vertical p–n diodes. This method yields high-performance power devices in CMOS-compatible cleanrooms at a reduced cost. The GaN p–n junctions exhibit a specific on-resistance of 3.3 mΩ cm2, a current on/off ratio exceeding 1010, and a current density of 1.4 kA/cm2 at 10 V. Robust avalanche behavior was confirmed through temperature-dependent reverse bias measurements from 298 to 373 K, and over 3000 over-voltage surge ruggedness was demonstrated by unclamped inductive switching stress tests. These results underscore the advantages of localized epitaxy for achieving high-quality GaN layers on Si, paving the way for scalable integration of high-voltage GaN power devices with conventional Si technology.


  • 984 V/3.0 mΩ·cm 2 Normally-Off and 817 V/ 2.7 mΩ·cm 2 Normally-On GaN Trench CAVETs With Wrap-Around Gate

    by Xinyi Wen, Hayao Kasai, Nishita Sinha, Junrui Lyu, Chuanzhe Meng, Koukichi Fujita, Tsuyoshi Yamasaki, Tatsuro Sawada, Tomohisa Hirayama, Srabanti Chowdhury

    Gallium Nitride (GaN) trench Current Aperture Vertical Electron Transistors with wrap-around gate (WG-CAVETs) were demonstrated on GaN substrates. The periodic trench-groove structure enhanced gate control and suppressed gate leakage to ~10-5 A/cm2 up to 40 V gate bias. Reducing the groove spacing (S) increased threshold voltage (VTH) and improved breakdown voltage. Both normally-on and normally-off WG-CAVETs were realized by varying S. A normally-on device with S = 4 μm achieved a specific on-resistance (RON,SP) of 2.7 mΩ⋅cm2 and a breakdown voltage of 817 V. Reducing S to 2 μm enabled a normally-off device (VTH = 4.6 V) with Ion/Ioff of 1.7×1010, RON,SP of 3.0 mΩ⋅cm2, and 984 V breakdown. Also, a normally-off multi-finger WG-CAVET (S = 2 μm) delivered 0.87 A, with RON,SP of 3.4 mΩ⋅cm2 and a breakdown voltage of 597 V. For comparative analysis, WG-CAVETs were fabricated with a thinner regrown channel, decreasing from 140 nm to 50 nm. Normally-off devices were achieved over a broader range of groove spacings, albeit with a cost of degraded output current and breakdown voltage.


  • Monolithic Bidirectional GaN-on-GaN Vertical Transistor Technologies: Exploring Bidirectional CAVET for Next-Generation Switching Applications with Symmetrical Power Control

    by Xinyi Wen, Hayao Kasai, Maliha Noshin, Chuanzhe Meng, Srabanti Chowdhury

    In this study, we designed and experimentally demonstrated a monolithic-integrated bidirectional GaN-on-GaN trench current aperture vertical electron transistor (BD-CAVET), capable of current conduction and voltage blocking in both directions. The trench CAVET was grown on a GaN substrate and incorporated a highly conductive 2D electron gas (2DEG) channel with a peak field effect mobility (${\mu}$FE) of 1,792 cm2/(V·s). The BD-CAVET exhibited symmetrical I–V characteristics in bidirectional mode, achieving a specific on-resistance (Ron,sp) of 2.5 mΩ·cm2 and a breakdown voltage of 200 V in both the first and third quadrants. In single-directional mode, the BD-CAVET conducted current in one direction with a turn-on offset voltage of 1 V. Reverse conduction of the fabricated trench CAVET was also investigated, revealing that the primary path for reverse current flow was through the 2DEG channel.


  • 10 MHz-Switching on GaN Trench CAVET up to 300 °C Operation Enabled by High Channel Mobility

    by Xinyi Wen, Bhawani Shankar, Kwangjae Lee, Hayao Kasai, Maliha Noshin, Jaeyi Chun, Yusuke Nakazato, Srabanti Chowdhury

    High-frequency, up to 10 MHz, switching of normally-on GaN trench CAVETs was demonstrated using an on-wafer double pulse test (DPT) system, along with high-temperature switching up to 300 °C reported for the first time. By innovatively inserting a low-temperature (LT) GaN interfacial layer to inhibit Mg out-diffusion from p-GaN, a record-high field effect mobility of 1821 cm 2 /(V·s) in a regrown AlGaN/GaN channel was confirmed from device transconductance characteristics, which enabled low-loss high-frequency switching capability of the fabricated device. CAVETs were effectively scaled up to 3-finger structures with reduced specific on-resistance (R on,sp ) to 0.98 mΩ·cm 2 . The device was switched using DPT, showing low turn-off/on times of 2.6/4.8 ns at 1 MHz and 4.5/7.0 ns at 10 MHz switching frequency. The high channel mobility of CAVET not only facilitates robust 10-MHz switching at room temperature but also ensures effective switching functionality even under high-temperature conditions reaching up to 300 °C.


  • Open Access

    Growth and mobility characterization of N-polar AlGaN channel high electron mobility transistors

    by Maliha Noshin, Xinyi Wen, Rohith Soman, Xiaoqing Xu, Srabanti Chowdhury

    All-AlGaN based high electron mobility transistors (HEMTs) are promising for increasing the power density in both RF and power devices, improving overall efficiency. Nitrogen (N) polar GaN/AlGaN HEMTs offer lower contact resistance compared to its metal-polar counterpart. In this work, we report the metal organic chemical vapor deposition (MOCVD)-based growth of N-polar AlGaN channel HEMT structures with a varying Al mole fraction in the AlxGa1−xN channel (x = 20%, 30%, 59%, and 73%). We confirmed the high-quality morphology and the Al composition of the grown structures using atomic force microscopy and x-ray diffraction spectra, respectively. We measured a mobility of ∼160 cm2/(V.s) in our N-polar AlGaN HEMT stack (20% Al in the channel) structure and found an alloy-scattering dominated transport with increasing Al mole fraction, further supported by our simulations that consider both alloy-scattering and optical phonon-scattering mechanisms. From 20% to 59% Al composition, we found a decreasing trend in mobility while for 59%–73% Al composition in the channel, both the simulated and the experimental mobility showed a nearly saturating trend. The structures were then fabricated into HEMTs with Al0.20Ga0.80N (channel)/Al0.59Ga0.41N (barrier), showing 320 mA/mm drain current for a 4 μm long-channel device.


  • Open Access

    High Current Density Trench CAVET on Bulk GaN Substrates with Low-Temperature GaN Suppressing Mg Diffusion

    by Xinyi Wen, Kwang Jae Lee, Yusuke Nakazato, Jaeyi Chun, Srabanti Chowdhury

    We report that, for the first time, a low-temperature GaN (LT-GaN) layer prepared by metal–organic chemical vapor deposition (MOCVD) regrowth was used as a Mg stopping layer (MSL) for a GaN trench current–aperture vertical electron transistor (CAVET) with p-GaN as a carrier blocking layer (CBL). Inserting LT-GaN on top of the p-GaN effectively suppresses Mg out-diffusion into the regrown AlGaN/GaN channel, contributing to the high current capability of GaN vertical devices with a p-GaN CBL. With different MOCVD growth conditions, MSLs inserted in trench CAVETs were comprehensively investigated for the influence of MSL regrowth temperature and thickness on device performance. With the best on-state current performance obtained in this study, the trench CAVET with a 100 nm thick MSL regrown at 750 °C shows a high drain current of 3.2 kA/cm2 and a low on-state resistance of 1.2 mΩ∙cm2. The secondary ion mass spectrometry (SIMS) depth profiles show that the trench CAVET with the 100 nm thick MSL regrown at 750 °C has a dramatically decreased Mg diffusion decay rate (~39 nm/decade) in AlGaN/GaN channel, compared to that of the CAVET without a MSL (~104 nm/decade). In developing GaN vertical devices embedded with a Mg-doped p-type layer, the LT-GaN as the MSL demonstrates a promising approach to effectively isolate Mg from the subsequently grown layers.