DKDavud Karakchi-Ogli

Davud Karakchi-Ogli

*This is an algorithmically generated author record based on publicly available information.

Davud Karakchi-Ogli has a total of 10 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    THE EFFECT OF HOLLOW STRUCTURE PARAMETER ON THE 3D-PRINTED WALL BEARING CAPACITY. EXPERIMENTAL MODEL

    by Galina Slavcheva, Артем Левченко, Maria Shvedova, Davut Karakchi-Ogli, Dmitriy Babenko, Pavel Yurov, Павел Юров

    We present the results of experimental studies and modelling of the evaluation of the bearing capacity of hollow 3D-printed walls with the printed shell performing bearing functions. The bearing capacity of hollow 3D-printed walls was experimentally assessed depending on the ratio of the void areas and casting layers in the wall structure. It was established that in case of central loading, a 3D-printed wall with bearing casting layers can serve as a bearing wall similar to traditional types of masonry construction without filling voids with structural concrete and reinforcement. We established the value of strength reduction of hollow 3D-printed walls, which amounted to ~0.1 – 0.25 MPa per 1 % of the increased area of voids. The limit value of the hollow structure parameter was determined, which must not exceed K = 0.75 in order to ensure the bearing capacity of self-bearing and non-bearing 3D-printed walls. We obtained an experimental model of the relationship between the hollow structure parameter and the bearing capacity, which allowed predicting the bearing capacity of a 3D-printed wall under central loading. It was suggested to take into account the hollow structure parameter K when calculating the elements of unreinforced 3D-printed walls under central compression according to the first group of limit states.


  • Open Access

    Strength and crack resistance of rubber and reinforced concrete T-beams

    by Polikutin Aleksei, Potapov Yuri, Zyabukhin Pavel, Oforkaja Theophilus, Davud Karakchi-Ogli

    The purpose of this study is to compare the strength, crack resistance and deformation of T-section beams made of reinforced concrete, rubber concrete and fiber rubber concrete. Rubber concrete (or abbreviated rubcon) is a highly effective composite polymer concrete based on liquid rubber, which has favorable physical and mechanical characteristics, as well as almost universal chemical resistance to aggressive media. This article presents the results of testing prototypes of T-beams using the following procedure. The beams were tested for bending by two forces applied in thirds of the span, increasing until failure. As longitudinal reinforcement, rods of class A500C were used. As transverse - Bp500, 5 mm in diameter, with a pitch of 50 mm. Fiber reinforcement is represented by steel fibers (ratio of diameter to fiber length 1/100), located randomly throughout the volume of the experimental beams. The section of the beams is assigned taking into account the requirements of SP 63.13330.2018 "Concrete and reinforced concrete structures": length - 1400 mm; web height - 95 mm; web width - 60 mm; flange height - 25 mm; flange width - 240 mm. It was found that the value of the destructive experimental bending moment in reinforced concrete beams is 1.20 times less than in rubcon and fiber rubcon beams. It was revealed that the most effective use of the strength of a normal section before reaching the maximum allowable deflection is observed in a rubcon beam (BKT240x95x25-2x10).