TTTommi Tikkanen

Tommi Tikkanen

*This is an algorithmically generated author record based on publicly available information.

Tommi Tikkanen has a total of 23 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Head Impacts during the Direct Frontal (Forehead) and Side (Temple) Collision - Human vs. Hybrid III Dummy

    by Lubos Tomsovsky, Lucie Literova, Petr Kubovy, Frantisek Lopot, Martin Havlicek, Ondrej Stocek, Lukas Fara, Roman Jezdik, Hynek Purs, Tommi Tikkanen, et al.

    The paper is focused on the dynamic response of Hybrid III crash-test dummy during low-severity frontal (forehead) and side (temple) head impacts. The measurements used a pedestrian dummy (Hybrid III 50th percentile male dummy, Jasti Co., ltd., Tokyo, Japan) and a unique pendulum impact testing machine (impactor) of own design and construction. The tests were conducted at two various impact intensities (velocities) that did not exceed the speed of 1.6 m/s. The primary outcome variable was a resultant magnitude of acceleration measured on the vertex of dummy's head and the results were compared to 11 human volunteers. The goal of the study was to analyse the biofidelity of Hybrid III Dummy in a pedestrian setting during low-severity frontal and side head impacts by comparing the dynamics and kinematics of the dummy's head to human volunteers.


  • Open Access

    Pedestrian Safety in Frontal Tram Collision, Part 2: Laminated Glass as a Crucial Part of the Absorption and Deformation Zone—Its Impact Test and Analysis

    by Roman Jezdik, Marek Sebik, Petr Kubovy, Frantisek Marsik, Frantisek Lopot, Barbora Hajkova, Dita Hylmarova, Martin Havlicek, Ondrej Stocek, Martin Doubek, et al.

    As was shown in the previous part of the study, windshields are an important part of the passive safety means of modern low-floor trams with an extraordinary effect on pedestrian safety in a pedestrian–tram collisions. Therefore, maximum attention must be paid to the definition of tram windshield characteristics. This article describes a windshield crash test, from which data are obtained to verify the feasibility of the applied computational approaches. A developed analytical model is utilised for a simple description of the energy balance during collision with an illustrative definition of the important parameters of laminated glass as well as their clear physical interpretations. The finite element analysis (FEA) performed in Ansys software using two versions of material definition, namely a simpler (*MAT_ELASTIC with nonlocal failure criterion) and a more complex (*MAT_GLASS with brittle stress-state-dependent failure) material model, which are presented as suitable for obtaining a detailed description of the shattering process of laminated glass, which can also be used effectively in windshield engineering.


  • Open Access

    Pedestrian Safety in Frontal Tram Collision, Part 1: Historical Overview and Experimental-Data-Based Biomechanical Study of Head Clashing in Frontal and Side Impacts

    by Frantisek Lopot, Lubos Tomsovsky, Frantisek Marsik, Jan Masek, Petr Kubovy, Roman Jezdik, Monika Sorfova, Barbora Hajkova, Dita Hylmarova, Martin Havlicek, et al.

    This article represents the first paper in a two-part series dealing with safety during tram–pedestrian collisions. This research is dedicated to the safety of trams for pedestrians during collisions and is motivated by the increased number of lethal cases. The first part of this paper includes an overview of tram face development from the earliest designs to the current ones in use and, at the same time, provides a synopsis and explanation of the technical context, including a link to current and forthcoming legislation. The historical design development can be characterised by three steps, from an almost vertical front face, to leaned and pointed shapes, to the current inclined low-edged windshield without a protruding coupler. However, since most major manufacturers now export their products worldwide and customisation is only of a technically insignificant nature, our conclusions are generalisable (supported by the example of Berlin). The most advantageous shape of the tram’s front, minimising the effects on pedestrians in all collision phases, has evolved rather spontaneously and was unprompted, and it is now being built into the European Commission regulations. The goal of the second part of this paper is to conduct a series of tram–pedestrian collisions with a focus on the frontal and side impacts using a crash test dummy (anthropomorphic test device—ATD). Four tram types approaching the collision at four different impact speeds (5 km/h, 10 km/h, 15 km/h, and 20 km/h) were used. The primary outcome variable was the resultant head acceleration. The risk and severity of possible head injuries were assessed using the head injury criterion (HIC15) and its linkage to the injury level on the Abbreviated Injury Scale (AIS). The results showed increasing head impacts with an increasing speed for all tram types and collision scenarios. Higher values of head acceleration were reached during the frontal impact (17–124 g) compared to the side one (2–84 g). The HIC15 values did not exceed the value of 300 for any experimental setting, and the probability of AIS4+ injuries did not exceed 10%. The outcomes of tram–pedestrian collisions can be influenced by the ATD’s position and orientation, the impact speed and front-end design of trams, and the site of initial contact.


  • Open Access

    Experimental Validation of the Biomechanical Response of an Anthropo-morphic Testing Device (Dummy) at Low Impact Velocities

    by Karel Jelen, Petr Kubovy, Frantisek Lopot, Lukas Fara, Roman Jezdik, Filip Hrusa, Hynek Purs, Tommi Tikkanen, Martin Novak, Martin Svoboda, et al.

    The paper describes the experimental validation of the biomechanical response of the Hybrid III 50th Percentile Male Pedestrian Dummy (JASTI, Tokyo, Japan) at low impact velocity (up to 2.2 m/s) in comparison with that of human probands. The paper is based on previous research that was focused on the tram-pedestrian crash tests using the same dummy. The biofidelity of dummy was analysed in two collision scenarios: the anteroposterior impact (chest impact) and lateral impact (shoulder impact) using a unique pendulum impact testing machine of own design and construction. The primary outcome variable was the peak resultant acceleration of the head and chest during the impact. Based on the labbased measurements, the unique impact testing machine was found adequate and precise for the purposes of future crash-test analyses in the area of automotive industry. The proposed methodology and measurement protocol were shown proper to compare the data between the dummy and human participants. Following the pilot experiments, the kinematic and dynamic data between the dummy and human participants were analysed to assess the biofidelity of dummy for the frontal and side impact during tram-pedestrian collisions at low impact velocities.


  • Open Access

    The Biomechanics of Head Injuries during Tram-Pedestrian Accidents

    by Karel Jelen, Eva Tlapakova, Monika Sorfova, Ondrej Fanta, Petr Kubovy, Frantisek Lopot, Filip Hrusa, Lukas Fara, Roman Jezdik, Hynek Purs, et al.

    The goal of the study was to analyse the kinematic and dynamic response of the human head during the primary impact of tram-pedestrian collisions. The anthropomorphic test device (dummy) was used for two collision scenarios: the frontal (dummy facing the approaching tram) and side impact (dummy standing with its shoulder towards the tram). The crash tests were conducted with four different types of tram, typical for the Prague's public transportation, and at four different impact speeds (5, 10, 15, 20 km/h). The primary outcome variable was the resultant head acceleration. The risk and severity of possible head injuries were analysed using the head injury criterion (HIC15) and the corresponding level of injury on the Abbreviated Injury Scale (AIS). The results of kinematic analysis showed that during the primary impact, the head of dummy always got hit by trams' front ends in the case of frontal impact while in the case of side impact, the head got only hit at higher speeds (15 and 20 km/h) with modern tram types. The results of dynamic analysis showed an increasing trend of head impacts with higher speeds for all tram types and collision scenarios. However, the head acceleration was higher in the case of frontal impacts compared to side impacts. The HIC15 did not exceed the value of 300 in any case and the probability of AIS3+ did not exceed 10%. The results suggest that the outcomes of tram-pedestrian collisions can be influenced by the tram type (its front-end design), impact speed, collision scenario, and the site of initial contact.