Chi Zhang
Research Subjects
Chi Zhang has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Xiaojia Wang
Department of Mechanical Engineering, University of Minnesota 1 , Minneapolis, Minnesota 55455
4 shared publications - Xiaotian Xu
Department of Mechanical Engineering, University of Minnesota, Twin Cities, Minneapolis, 55455, UNITED STATES
3 shared publications - K. Andre Mkhoyan
Department of Chemical Engineering and Materials Science, University of Minnesota, Minneapolis, MN 55455, USA
2 shared publications - Silu Guo
University of Minnesota Twin Cities
2 shared publications - Yingying Zhang
Department of Mechanical Engineering, University of Minnesota 1 , Minneapolis, Minnesota 55455, USA
2 shared publications - Bharat Jalan
University of Minnesota Twin Cities
1 shared publication
Latest Publications
- 6 November 2025
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
Phenyl Side Groups Enhance Phonon Transport in Rubrene Crystals
Rubrene single crystals, renowned for their record-high hole mobility among organic semiconductors, are widely used in organic electronics where thermal management is essential. This study reports a comprehensive investigation of thermal transport in rubrene along its three primary crystallographic directions, integrating crystal growth, structural characterization, thermal measurements, and molecular dynamics (MD) simulations. Contrary to the well-established 2D nature of charge transport favored in the ab-plane, we observe that the room-temperature thermal conductivity along the interlayer c-axis (Λc = 0.29 W m-1 K-1) exceeds those along the a- and b-axes (Λa = 0.22 W m-1 K-1 and Λb = 0.24 W m-1 K-1), despite strong π-π stacking in the ab-plane. MD simulations reveal the origins of this counterintuitive observation, highlighting the pivotal role of phenyl side groups in facilitating phonon transport along the c-axis. Phonon dispersion and density of states analyses indicate enhanced low-frequency vibrational modes (0-3.7 THz) associated with the side groups. Participation ratio analyses confirm that vibrational modes in both the side groups and backbone have comparable degrees of spatial localization for carrying heat; however, higher phonon group velocities along the c-axis suggest more efficient thermal transport through the phenyl groups. Additionally, the 1/T temperature dependence of thermal conductivities along all three axes suggests crystalline behavior in rubrene as might be expected despite its complex molecular structure. These findings uncover a previously underappreciated role of side group dynamics in phonon transport in molecular crystals and provide new insights into developing thermal management strategies for organic electronic devices.
- 6 November 2025
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
Phenyl Side Groups Enhance Phonon Transport in Rubrene Crystals
Rubrene single crystals, renowned for their record-high hole mobility among organic semiconductors, are widely used in organic electronics where thermal management is essential. This study reports a comprehensive investigation of thermal transport in rubrene along its three primary crystallographic directions, integrating crystal growth, structural characterization, thermal measurements, and molecular dynamics (MD) simulations. Contrary to the well-established 2D nature of charge transport favored in the ab-plane, we observe that the room-temperature thermal conductivity along the interlayer c-axis (Λc = 0.29 W m-1 K-1) exceeds those along the a- and b-axes (Λa = 0.22 W m-1 K-1 and Λb = 0.24 W m-1 K-1), despite strong π-π stacking in the ab-plane. MD simulations reveal the origins of this counterintuitive observation, highlighting the pivotal role of phenyl side groups in facilitating phonon transport along the c-axis. Phonon dispersion and density of states analyses indicate enhanced low-frequency vibrational modes (0-3.7 THz) associated with the side groups. Participation ratio analyses confirm that vibrational modes in both the side groups and backbone have comparable degrees of spatial localization for carrying heat; however, higher phonon group velocities along the c-axis suggest more efficient thermal transport through the phenyl groups. Additionally, the 1/T temperature dependence of thermal conductivities along all three axes suggests crystalline behavior in rubrene as might be expected despite its complex molecular structure. These findings uncover a previously underappreciated role of side group dynamics in phonon transport in molecular crystals and provide new insights into developing thermal management strategies for organic electronic devices.
- 26 March 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 137 (12)
Thermal performance of materials for heat-assisted magnetic recording
To increase the storage capacity of hard disk drives, Heat-Assisted Magnetic Recording (HAMR) takes advantage of laser heating to temporarily reduce the coercivity of recording media, enabling the writing of very small data bits on materials with high thermal stability. One key challenge in implementing HAMR is effective thermal management, which requires reliable determination of the thermal properties of HAMR materials over their range of operating temperature. This work reports the thermal properties of dielectric (amorphous silica, amorphous alumina, and AlN), metallic (gold and copper), and magnetic alloy (NiFe and CoFe) thin films used in HAMR heads from room temperature to 500 K measured with time-domain thermoreflectance. Our results show that the thermal conductivities of amorphous silica and alumina films increase with temperature, following the typical trends for amorphous materials. The polycrystalline AlN film exhibits weak thermal anisotropy, and its in-plane and through-plane thermal conductivities decrease with temperature. The measured thermal conductivities of AlN are significantly lower than that which would be present in single-crystal bulk material, and this is attributed to enhanced phonon-boundary scattering and phonon-defect scattering. The gold, copper, NiFe, and CoFe films show little temperature dependence in their thermal conductivities over the same temperature range. The measured thermal conductivities of gold and copper films are explained by the diffuse electron-boundary scattering using an empirical model.
- 26 March 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 137 (12)
Thermal performance of materials for heat-assisted magnetic recording
To increase the storage capacity of hard disk drives, Heat-Assisted Magnetic Recording (HAMR) takes advantage of laser heating to temporarily reduce the coercivity of recording media, enabling the writing of very small data bits on materials with high thermal stability. One key challenge in implementing HAMR is effective thermal management, which requires reliable determination of the thermal properties of HAMR materials over their range of operating temperature. This work reports the thermal properties of dielectric (amorphous silica, amorphous alumina, and AlN), metallic (gold and copper), and magnetic alloy (NiFe and CoFe) thin films used in HAMR heads from room temperature to 500 K measured with time-domain thermoreflectance. Our results show that the thermal conductivities of amorphous silica and alumina films increase with temperature, following the typical trends for amorphous materials. The polycrystalline AlN film exhibits weak thermal anisotropy, and its in-plane and through-plane thermal conductivities decrease with temperature. The measured thermal conductivities of AlN are significantly lower than that which would be present in single-crystal bulk material, and this is attributed to enhanced phonon-boundary scattering and phonon-defect scattering. The gold, copper, NiFe, and CoFe films show little temperature dependence in their thermal conductivities over the same temperature range. The measured thermal conductivities of gold and copper films are explained by the diffuse electron-boundary scattering using an empirical model.
- Open Access
- 24 July 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 123 (4)
Temperature-dependent thermal conductivity of MBE-grown epitaxial SrSnO3 films
As an ultrawide bandgap (∼4.1 eV) semiconductor, single crystalline SrSnO3 (SSO) has promising electrical properties for applications in power electronics and transparent conductors. The device performance can be limited by heat dissipation issues. However, a systematic study detailing its thermal transport properties remains elusive. This work studies the temperature-dependent thermal properties of a single crystalline SSO thin film prepared with hybrid molecular beam epitaxy. By combining time-domain thermoreflectance and Debye–Callaway modeling, physical insight into thermal transport mechanisms is provided. At room temperature, the 350-nm SSO film has a thermal conductivity of 4.4 W m−1 K−1, ∼60% lower than those of other perovskite oxides (SrTiO3, BaSnO3) with the same ABO3 structural formula. This difference is attributed to the low zone-boundary frequency of SSO, resulting from its distorted orthorhombic structure with tilted octahedra. At high temperatures, the thermal conductivity of SSO decreases with temperature following a ∼T−0.54 dependence, weaker than the typical T−1 trend dominated by the Umklapp scattering. This work not only reveals the fundamental mechanisms of thermal transport in single crystalline SSO but also sheds light on the thermal design and optimization of SSO-based electronic applications.
- 24 July 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 123 (4)
Open AccessTemperature-dependent thermal conductivity of MBE-grown epitaxial SrSnO3 films
As an ultrawide bandgap (∼4.1 eV) semiconductor, single crystalline SrSnO3 (SSO) has promising electrical properties for applications in power electronics and transparent conductors. The device performance can be limited by heat dissipation issues. However, a systematic study detailing its thermal transport properties remains elusive. This work studies the temperature-dependent thermal properties of a single crystalline SSO thin film prepared with hybrid molecular beam epitaxy. By combining time-domain thermoreflectance and Debye–Callaway modeling, physical insight into thermal transport mechanisms is provided. At room temperature, the 350-nm SSO film has a thermal conductivity of 4.4 W m−1 K−1, ∼60% lower than those of other perovskite oxides (SrTiO3, BaSnO3) with the same ABO3 structural formula. This difference is attributed to the low zone-boundary frequency of SSO, resulting from its distorted orthorhombic structure with tilted octahedra. At high temperatures, the thermal conductivity of SSO decreases with temperature following a ∼T−0.54 dependence, weaker than the typical T−1 trend dominated by the Umklapp scattering. This work not only reveals the fundamental mechanisms of thermal transport in single crystalline SSO but also sheds light on the thermal design and optimization of SSO-based electronic applications.
- Open Access
- 6 May 2023
- Published by Springer Nature in Nature Communications
- Vol. 14 (1) , 1-9
Wide-range continuous tuning of the thermal conductivity of La0.5Sr0.5CoO3-δ films via room-temperature ion-gel gating
Solid-state control of the thermal conductivity of materials is of exceptional interest for novel devices such as thermal diodes and switches. Here, we demonstrate the ability tocontinuouslytune the thermal conductivity of nanoscale films of La0.5Sr0.5CoO3-δ(LSCO) by a factor of over 5, via a room-temperature electrolyte-gate-induced non-volatile topotactic phase transformation from perovskite (withδ≈ 0.1) to an oxygen-vacancy-ordered brownmillerite phase (withδ= 0.5), accompanied by a metal-insulator transition. Combining time-domain thermoreflectance and electronic transport measurements, model analyses based on molecular dynamics and Boltzmann transport equation, and structural characterization by X-ray diffraction, we uncover and deconvolve the effects of these transitions on heat carriers, including electrons and lattice vibrations. The wide-range continuous tunability of LSCO thermal conductivity enabled by low-voltage (below 4 V) room-temperature electrolyte gating opens the door to non-volatile dynamic control of thermal transport in perovskite-based functional materials, for thermal regulation and management in device applications.
- 6 May 2023
- Published by Springer Nature in Nature Communications
- Vol. 14 (1) , 1-9
Open AccessWide-range continuous tuning of the thermal conductivity of La0.5Sr0.5CoO3-δ films via room-temperature ion-gel gating
Solid-state control of the thermal conductivity of materials is of exceptional interest for novel devices such as thermal diodes and switches. Here, we demonstrate the ability tocontinuouslytune the thermal conductivity of nanoscale films of La0.5Sr0.5CoO3-δ(LSCO) by a factor of over 5, via a room-temperature electrolyte-gate-induced non-volatile topotactic phase transformation from perovskite (withδ≈ 0.1) to an oxygen-vacancy-ordered brownmillerite phase (withδ= 0.5), accompanied by a metal-insulator transition. Combining time-domain thermoreflectance and electronic transport measurements, model analyses based on molecular dynamics and Boltzmann transport equation, and structural characterization by X-ray diffraction, we uncover and deconvolve the effects of these transitions on heat carriers, including electrons and lattice vibrations. The wide-range continuous tunability of LSCO thermal conductivity enabled by low-voltage (below 4 V) room-temperature electrolyte gating opens the door to non-volatile dynamic control of thermal transport in perovskite-based functional materials, for thermal regulation and management in device applications.