Mahmut Bucurgat
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Mahmut Bucurgat has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
Şemsettin Altındal
Faculty of Science, Department of Physics, Gazi University, Yenimahalle, ANKARA, Turkey
2 shared publications- Ahmet Faruk Özdemir
Süleyman Demirel University
1 shared publication - Can Babacanoğlu
Turkish Medicines and Medical Devices Agency, Quality Management Coordinator, Ankara, Turkey
1 shared publication - Sevtap Aydın Dilsiz
Department of Pharmaceutical Toxicology, Faculty of Pharmacy Hacettepe University Ankara Turkey
1 shared publication - Tuğbagül Çal Doğan
Department of Pharmaceutical Toxicology, Faculty of Pharmacy Hacettepe University Ankara Turkey
1 shared publication Özgül Çağla Uyanık
Faculty of Science, Department of Physics, Gazi University, Yenimahalle, ANKARA, Turkey
1 shared publication
Latest Publications
- 10 September 2026
- Published by Springer Nature in Applied Physics A
- Vol. 132 (10) , 1002
Comparative investigation of the electrical and photoresponse characteristics of Au/n-Si and Au/(PVA: Zn)/n-Si Schottky barrier diodes
- 10 September 2026
- Published by Springer Nature in Applied Physics A
- Vol. 132 (10) , 1002
Comparative investigation of the electrical and photoresponse characteristics of Au/n-Si and Au/(PVA: Zn)/n-Si Schottky barrier diodes
- Open Access
- 16 June 2025
- Published by Springer Nature in European Food Research and Technology
- Vol. 251 (9) , 2779-2791
In vitro evaluation of the possible genotoxic effects of acrylamide and 5-hydroxymetylfurfural by single cell gel electroporesis (comet) assay
Food cooking processes containing carbohydrates forms acrylamide (AA) and 5-hydroxymethylfurfural (HMF) through Maillard reaction. These two substances are known as carcinogenic. Coffee consumption is a major exposure route of AA and HMF. Caffeic acid (CA) is an antioxidant naturally found in coffee. Our study aimed to evaluate the possible oxidative DNA damage induced by AA and HMF in CA-treated or CA-untreated Chinese hamster lung fibroblast cells (V79 cells) and human hepatocellular carcinoma cell lines (HepG2 cells). Genotoxicity was evaluated by the single cell gel electrophoresis (comet) technique. The cells were treated with different concentrations of AA, HMF (1–100 μM) and CA (25 and 50 μM) and different combinations of AA, HMF and CA with each other for 1 h. DNA damage was expressed as DNA tail intensity. In V79 cells, the doses of AA (1–50 μM) and HMF (1–100 μM) did not increase DNA damage alone. DNA damage was increased at the doses of 100 μM AA, 25 μM HMF, 25 and 50 μM CA and the genotoxic effects of AA were decreased when combined with 25 and 50 μM CA in V79 cells. In HepG2 cells, only 5 μM and 10 μM HMF increased DNA damage, but most of dose combinations of AA and HMF with CA caused more DNA damage in HepG2 cells than V79 cells. Our results show that AA and HMF alone may not cause considerable DNA damage, however CA might induce DNA damage at high doses in V79 cells.
- 16 June 2025
- Published by Springer Nature in European Food Research and Technology
- Vol. 251 (9) , 2779-2791
Open AccessIn vitro evaluation of the possible genotoxic effects of acrylamide and 5-hydroxymetylfurfural by single cell gel electroporesis (comet) assay
Food cooking processes containing carbohydrates forms acrylamide (AA) and 5-hydroxymethylfurfural (HMF) through Maillard reaction. These two substances are known as carcinogenic. Coffee consumption is a major exposure route of AA and HMF. Caffeic acid (CA) is an antioxidant naturally found in coffee. Our study aimed to evaluate the possible oxidative DNA damage induced by AA and HMF in CA-treated or CA-untreated Chinese hamster lung fibroblast cells (V79 cells) and human hepatocellular carcinoma cell lines (HepG2 cells). Genotoxicity was evaluated by the single cell gel electrophoresis (comet) technique. The cells were treated with different concentrations of AA, HMF (1–100 μM) and CA (25 and 50 μM) and different combinations of AA, HMF and CA with each other for 1 h. DNA damage was expressed as DNA tail intensity. In V79 cells, the doses of AA (1–50 μM) and HMF (1–100 μM) did not increase DNA damage alone. DNA damage was increased at the doses of 100 μM AA, 25 μM HMF, 25 and 50 μM CA and the genotoxic effects of AA were decreased when combined with 25 and 50 μM CA in V79 cells. In HepG2 cells, only 5 μM and 10 μM HMF increased DNA damage, but most of dose combinations of AA and HMF with CA caused more DNA damage in HepG2 cells than V79 cells. Our results show that AA and HMF alone may not cause considerable DNA damage, however CA might induce DNA damage at high doses in V79 cells.
- 1 June 2021
- Published by Igdir University in Iğdır Üniversitesi Fen Bilimleri Enstitüsü Dergisi
- Vol. 11 (2) , 1058-1067
Voltage Dependent Barrier Height, Ideality Factor and Surface States in Au/(NiS-PVP)/n-Si (MPS) type Schottky Barrier Diodes
Metal-Polymer-Semiconductor (MPS) Schottky Barrier Diodes (SBD) were manufactured and their basic electrical parameters were obtained by the measurement of the forward and reverse bias current-voltage (I-V) in the wide bias voltage range (±3V) to determine the voltage dependent effects on Nickel-Sulphur (NiS) doped Poly Vinyl Pyrrolidone (PVP) polymer interlayer. The saturation current (I0), zero-bias barrier height (ΦB0), rectifying rate (RR), ideality factor (n) and the real value of series - shunt resistances (Rs - Rsh) were calculated. The voltage dependent profile of n (V), ΦB(V), and Rs (V) were derived. The forward bias ln I-V plot of the MPS type SBD indicates a good rectifier behaviour and it has two distinctive linear parts with different slopes which correspond to low (0.288 ≤V ≤0.625 V) and moderate (0.672 ≤ V ≤ 0.960 V) bias voltages and then deviates from linearity due to Rs and interlayer at high forward bias voltages. Energy dependent profile of Nss was obtained from the forward bias I-V data by considering voltage dependent barrier height (ΦB) and n. Nss plot represents U-shape behaviour in the forbidden bandgap. The mean value of Nss was found at about 7.0x1012 eV-1 cm-2 and this value is in the acceptable limit for a semiconductor device and such lower values of Nss are the consequences of the passivation effect on the surface states.
- 1 June 2021
- Published by Igdir University in Iğdır Üniversitesi Fen Bilimleri Enstitüsü Dergisi
- Vol. 11 (2) , 1058-1067
Voltage Dependent Barrier Height, Ideality Factor and Surface States in Au/(NiS-PVP)/n-Si (MPS) type Schottky Barrier Diodes
Metal-Polymer-Semiconductor (MPS) Schottky Barrier Diodes (SBD) were manufactured and their basic electrical parameters were obtained by the measurement of the forward and reverse bias current-voltage (I-V) in the wide bias voltage range (±3V) to determine the voltage dependent effects on Nickel-Sulphur (NiS) doped Poly Vinyl Pyrrolidone (PVP) polymer interlayer. The saturation current (I0), zero-bias barrier height (ΦB0), rectifying rate (RR), ideality factor (n) and the real value of series - shunt resistances (Rs - Rsh) were calculated. The voltage dependent profile of n (V), ΦB(V), and Rs (V) were derived. The forward bias ln I-V plot of the MPS type SBD indicates a good rectifier behaviour and it has two distinctive linear parts with different slopes which correspond to low (0.288 ≤V ≤0.625 V) and moderate (0.672 ≤ V ≤ 0.960 V) bias voltages and then deviates from linearity due to Rs and interlayer at high forward bias voltages. Energy dependent profile of Nss was obtained from the forward bias I-V data by considering voltage dependent barrier height (ΦB) and n. Nss plot represents U-shape behaviour in the forbidden bandgap. The mean value of Nss was found at about 7.0x1012 eV-1 cm-2 and this value is in the acceptable limit for a semiconductor device and such lower values of Nss are the consequences of the passivation effect on the surface states.