B. Moshfegh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
B. Moshfegh has a total of 1 co-authors. Here are the top co-authors by number of shared publications:
- D. Rundström
Division of Energy and Mechanical Engineering, Department of Technology and Build Environment, University of Gävle, 801 76 Gävle, Sweden; Department of Mechanical Engineering, Linköping University, Linköping, Sweden
1 shared publication
Latest Publications
- 22 September 2008
- Published by Wiley in Journal of Heat Transfer
- Vol. 130 (12) , 121401
Investigation of Heat Transfer and Pressure Drop of an Impinging Jet in a Cross-Flow for Cooling of a Heated Cube
The objective of this study is to investigate the thermal performance and the cost measured in pressure drops of a targeted cooling system with use of an impinging jet in combination with a low-velocity channel flow on a heated wall-mounted cube. The effects of the Reynolds numbers of the impinging jet and the cross-flow, as well as the distance between the top and bottom plates, are investigated. A steady-state 3D computational fluid dynamics model was developed with use of a Reynolds stress model as turbulence model. The geometrical case is a channel with a heated cube in the middle of the base plate and two inlets, one horizontal channel flow and one vertical impinging jet. The numerical model was validated against experimental data with a similar geometrical setup. The velocity field was measured by particle image velocimetry and the surface temperature was measured by an infrared imaging system. This case results in a very complex flow structure where several flow-related phenomena influence the heat transfer rate and the pressure drops. The average heat transfer coefficients on each side of the cube and the pressure loss coefficients are presented; correlations for the average heat transfer coefficient on the cube and the pressure loss coefficients are created.
- 22 September 2008
- Published by Wiley in Journal of Heat Transfer
- Vol. 130 (12) , 121401
Investigation of Heat Transfer and Pressure Drop of an Impinging Jet in a Cross-Flow for Cooling of a Heated Cube
The objective of this study is to investigate the thermal performance and the cost measured in pressure drops of a targeted cooling system with use of an impinging jet in combination with a low-velocity channel flow on a heated wall-mounted cube. The effects of the Reynolds numbers of the impinging jet and the cross-flow, as well as the distance between the top and bottom plates, are investigated. A steady-state 3D computational fluid dynamics model was developed with use of a Reynolds stress model as turbulence model. The geometrical case is a channel with a heated cube in the middle of the base plate and two inlets, one horizontal channel flow and one vertical impinging jet. The numerical model was validated against experimental data with a similar geometrical setup. The velocity field was measured by particle image velocimetry and the surface temperature was measured by an infrared imaging system. This case results in a very complex flow structure where several flow-related phenomena influence the heat transfer rate and the pressure drops. The average heat transfer coefficients on each side of the cube and the pressure loss coefficients are presented; correlations for the average heat transfer coefficient on the cube and the pressure loss coefficients are created.