Ahmed Cheriet
Ahmed Cheriet has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Abdelkader Bekri
Tahri Mohamed University
2 shared publications - Abdeldjebar Hazzab
Tahri Mohamed University
1 shared publication - Ali Hamed
Tahri Mohamed Bechar University
1 shared publication - Ambrish Chandra
University of Quebec Montreal
1 shared publication - Hicham Gouabi
Tahri Mohamed University
1 shared publication - Hireche Slimane
Tahri Mohamed University
1 shared publication
Latest Publications
- Open Access
- 1 February 2025
- Published by Institute of Advanced Engineering and Science in Indonesian Journal of Electrical Engineering and Computer Science
- Vol. 37 (2) , 781-788
Designing fuzzy membership functions using genetic algorithm with a new encoding method
This article presents a new method for designing fuzzy membership functions using the genetic algorithm (GA) without the use of constraints. Conventional approaches to designing these functions often involve manual tuning or optimization techniques with limitations. However, this article introduces a constraint-free approach, as the GA requires all constraints to be met for a chromosome; if even one condition is not satisfied, the chromosome is discarded, regardless of its ideal values for other variables. Consequently, a high number of constraints, especially in the studied case, increases the likelihood of chromosome rejection, leading to a time-consuming design process and suboptimal results.
- 1 February 2025
- Published by Institute of Advanced Engineering and Science in Indonesian Journal of Electrical Engineering and Computer Science
- Vol. 37 (2) , 781-788
Open AccessDesigning fuzzy membership functions using genetic algorithm with a new encoding method
This article presents a new method for designing fuzzy membership functions using the genetic algorithm (GA) without the use of constraints. Conventional approaches to designing these functions often involve manual tuning or optimization techniques with limitations. However, this article introduces a constraint-free approach, as the GA requires all constraints to be met for a chromosome; if even one condition is not satisfied, the chromosome is discarded, regardless of its ideal values for other variables. Consequently, a high number of constraints, especially in the studied case, increases the likelihood of chromosome rejection, leading to a time-consuming design process and suboptimal results.
- Open Access
- 1 June 2023
- Published by Institute of Advanced Engineering and Science in International Journal of Power Electronics and Drive Systems (IJPEDS)
- Vol. 14 (2) , 1085-1097
Novel strategy for fault e-diagnosis of wind energy conversion systems using wavelet analysis based on Rt-Lab and Arduino
The diagnosis of wind energy conversion systems (WECS) turns out to be necessary because of their relatively high cost of operation and maintenance. Wind turbines are hard-to-access structures, and they are often located in remote areas. Therefore, a remote diagnosis (e-diagnosis) is required. This paper proposes an alternative approach for the e-diagnosis of a WECS based on the discrete wavelet transform (DWT) and frequency analysis of the aero generator stator currents. To validate this approach, real-time hardware in the loop (HIL) is used to simulate in real-time the mathematical model of the induction generator on the OPAL-RT OP5600 platform to generate the stator currents and the rotor speed. The DWT is applied to the current signal, to generate the DWT signal, which has a huge number of points that are not supported for direct transmission by the Arduino Mega RobotDyn because of its limited sample time. The absolute values of the DWT peak points (MDWT) are sent as point’s packages form to the diagnosis station via the ESP8266 integrated Wi-Fi board of the Arduino Mega RobotDyn to monitor the SCIG states and determine the number of broken bars.
- 1 June 2023
- Published by Institute of Advanced Engineering and Science in International Journal of Power Electronics and Drive Systems (IJPEDS)
- Vol. 14 (2) , 1085-1097
Open AccessNovel strategy for fault e-diagnosis of wind energy conversion systems using wavelet analysis based on Rt-Lab and Arduino
The diagnosis of wind energy conversion systems (WECS) turns out to be necessary because of their relatively high cost of operation and maintenance. Wind turbines are hard-to-access structures, and they are often located in remote areas. Therefore, a remote diagnosis (e-diagnosis) is required. This paper proposes an alternative approach for the e-diagnosis of a WECS based on the discrete wavelet transform (DWT) and frequency analysis of the aero generator stator currents. To validate this approach, real-time hardware in the loop (HIL) is used to simulate in real-time the mathematical model of the induction generator on the OPAL-RT OP5600 platform to generate the stator currents and the rotor speed. The DWT is applied to the current signal, to generate the DWT signal, which has a huge number of points that are not supported for direct transmission by the Arduino Mega RobotDyn because of its limited sample time. The absolute values of the DWT peak points (MDWT) are sent as point’s packages form to the diagnosis station via the ESP8266 integrated Wi-Fi board of the Arduino Mega RobotDyn to monitor the SCIG states and determine the number of broken bars.