Leo Brody
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Leo Brody has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Fanxing Li
North Carolina State University
3 shared publications Azin Saberi Bosari
Department of Chemical and Biomolecular Engineering, North Carolina State University, 911 Partners Way, Raleigh, North Carolina 27695-7905, USA
2 shared publications- Julie E. Rorrer
Department of Chemical Engineering, University of Washington, Seattle, USA
2 shared publications Mahe Rukh
Department of Chemical and Biomolecular Engineering, North Carolina State University, 911 Partners Way, Raleigh, North Carolina 27695-7905, USA
2 shared publicationsRunxia Cai
Department of Chemical and Biomolecular Engineering, North Carolina State University, 911 Partners Way, Raleigh, North Carolina 27695-7905, USA
2 shared publicationsAlexandra Pierce
Department of Chemical and Biomolecular Engineering, North Carolina State University, 911 Partners Way, Raleigh, North Carolina 27695-7905, USA
1 shared publication
Latest Publications
- Open Access
- 1 January 2026
- Published by Royal Society of Chemistry (RSC) in Reaction Chemistry & Engineering
Autonomous closed-loop optimization of n -butane hydrogenolysis: a case study for history-dependent heterogeneous catalytic reactions
A closed-loop autonomous reactor platform for heterogeneous catalysis shows that catalyst deactivation pins Bayesian-optimized optima to early observations. Catalyst history, not the acquisition policy, sets the outcome of self-driving campaigns.
- 1 January 2026
- Published by Royal Society of Chemistry (RSC) in Reaction Chemistry & Engineering
Open AccessAutonomous closed-loop optimization of n -butane hydrogenolysis: a case study for history-dependent heterogeneous catalytic reactions
A closed-loop autonomous reactor platform for heterogeneous catalysis shows that catalyst deactivation pins Bayesian-optimized optima to early observations. Catalyst history, not the acquisition policy, sets the outcome of self-driving campaigns.
- 16 September 2025
- Published by Springer Nature in Nature Chemistry
- Vol. 17 (10) , 1442-1444
Single-site catalyst cuts branched polyolefins to pieces
- 16 September 2025
- Published by Springer Nature in Nature Chemistry
- Vol. 17 (10) , 1442-1444
Single-site catalyst cuts branched polyolefins to pieces
- Open Access
- 25 July 2024
- Published by Royal Society of Chemistry (RSC) in Energy & Environmental Science
- Vol. 17 (17) , 6279-6290
High-throughput design of complex oxides as isothermal, redox-activated CO 2 sorbents for green hydrogen generation
A new family of Isothermal, redox-activated CO 2 sorbents were successfully developed using a high-throughput combinatorial approach to facilitate the generation of green hydrogen from biogenic carbonaceous feedstocks.
- 25 July 2024
- Published by Royal Society of Chemistry (RSC) in Energy & Environmental Science
- Vol. 17 (17) , 6279-6290
Open AccessHigh-throughput design of complex oxides as isothermal, redox-activated CO 2 sorbents for green hydrogen generation
A new family of Isothermal, redox-activated CO 2 sorbents were successfully developed using a high-throughput combinatorial approach to facilitate the generation of green hydrogen from biogenic carbonaceous feedstocks.
- Open Access
- 14 June 2023
- Published by IOP Publishing in Journal of Physics: Energy
- Vol. 5 (3) , 035004
Sorption-enhanced steam reforming of toluene using multifunctional perovskite phase transition sorbents in a chemical looping scheme
Sorption-enhanced steam reforming (SESR) of toluene (SESRT) using catalytic CO2 sorbents is a promising route to convert the aromatic tar byproducts formed in lignocellulosic biomass gasification into hydrogen (H2) or H2-rich syngas. Commonly used sorbents such as CaO are effective in capturing CO2 initially but are prone to lose their sorption capacity over repeated cycles due to sintering at high temperatures. Herein, we present a demonstration of SESRT using A- and B-site doped Sr1−x A’ x Fe1−y B’ y O3−δ (A’ = Ba, Ca; B’ = Co) perovskites in a chemical looping scheme. We found that surface impregnation of 5–10 mol% Ni on the perovskite was effective in improving toluene conversion. However, upon cycling, the impregnated Ni tends to migrate into the bulk and lose activity. This prompted the adoption of a dual bed configuration using a pre-bed of NiO/γ–Al2O3 catalyst upstream of the sorbent. A comparison is made between isothermal operation and a more traditional temperature-swing mode, where for the latter, an average sorption capacity of ∼38% was witnessed over five SESR cycles with H2-rich product syngas evidenced by a ratio of H2: CO x > 4.0. XRD analysis of fresh and cycled samples of Sr0.25Ba0.75Fe0.375Co0.625O3-δ reveal that this material is an effective phase transition sorbent—capable of cyclically capturing and releasing CO2 without irreversible phase changes occurring.
- 14 June 2023
- Published by IOP Publishing in Journal of Physics: Energy
- Vol. 5 (3) , 035004
Open AccessSorption-enhanced steam reforming of toluene using multifunctional perovskite phase transition sorbents in a chemical looping scheme
Sorption-enhanced steam reforming (SESR) of toluene (SESRT) using catalytic CO2 sorbents is a promising route to convert the aromatic tar byproducts formed in lignocellulosic biomass gasification into hydrogen (H2) or H2-rich syngas. Commonly used sorbents such as CaO are effective in capturing CO2 initially but are prone to lose their sorption capacity over repeated cycles due to sintering at high temperatures. Herein, we present a demonstration of SESRT using A- and B-site doped Sr1−x A’ x Fe1−y B’ y O3−δ (A’ = Ba, Ca; B’ = Co) perovskites in a chemical looping scheme. We found that surface impregnation of 5–10 mol% Ni on the perovskite was effective in improving toluene conversion. However, upon cycling, the impregnated Ni tends to migrate into the bulk and lose activity. This prompted the adoption of a dual bed configuration using a pre-bed of NiO/γ–Al2O3 catalyst upstream of the sorbent. A comparison is made between isothermal operation and a more traditional temperature-swing mode, where for the latter, an average sorption capacity of ∼38% was witnessed over five SESR cycles with H2-rich product syngas evidenced by a ratio of H2: CO x > 4.0. XRD analysis of fresh and cycled samples of Sr0.25Ba0.75Fe0.375Co0.625O3-δ reveal that this material is an effective phase transition sorbent—capable of cyclically capturing and releasing CO2 without irreversible phase changes occurring.
- 3 June 2023
- Published by Elsevier in Chemical Engineering Journal
- Vol. 469
Numerical modeling of chemical looping oxidative dehydrogenation of ethane in parallel packed beds
- 3 June 2023
- Published by Elsevier in Chemical Engineering Journal
- Vol. 469
Numerical modeling of chemical looping oxidative dehydrogenation of ethane in parallel packed beds