Yutaka Shinoda
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yutaka Shinoda has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Fumihiro Wakai
National Institute for Materials Science
1 shared publication - Takashi Akatsu
Ceramic Research Center of Saga University
1 shared publication - Yoshihide Tabata
Laboratory for Materials and Structures, Institute of Innovative Research, Tokyo Institute of Technology, R3-24 4259 Nagatsuta, Midori, Yokohama 226-8503, Japan
1 shared publication
Latest Publications
- Open Access
Effect of Equibiaxial Pre-Stress on Mechanical Properties Evaluated Using Depth-Sensing Indentation with a Point-Sharp Indenter
This study examined the effect of an imposed equibiaxial pre-stress (EBPS) on the evaluation of mechanical properties, using the depth-sensing indentation method with a point-sharp indenter, through a numerical analysis of indentations simulated with the 3D finite element method. The predicted elastic modulus, E*, and yield stress, Y*, were used as elastic and plastic deformation resistances under the indentation, respectively. It was found that both increased nominally with the increase in compressive EBPS and decreased with the increase in tensile EBPS, even though the induced change in the piling-up or sinking-in around the indentations was not significant. The effect of EBPS on E* was described by the Hooke’s law for an isotropic elastoplastic material, whereas that on Y* was accounted for by the change in the von Mises stress due to EBPS.
Open AccessEffect of Equibiaxial Pre-Stress on Mechanical Properties Evaluated Using Depth-Sensing Indentation with a Point-Sharp Indenter
This study examined the effect of an imposed equibiaxial pre-stress (EBPS) on the evaluation of mechanical properties, using the depth-sensing indentation method with a point-sharp indenter, through a numerical analysis of indentations simulated with the 3D finite element method. The predicted elastic modulus, E*, and yield stress, Y*, were used as elastic and plastic deformation resistances under the indentation, respectively. It was found that both increased nominally with the increase in compressive EBPS and decreased with the increase in tensile EBPS, even though the induced change in the piling-up or sinking-in around the indentations was not significant. The effect of EBPS on E* was described by the Hooke’s law for an isotropic elastoplastic material, whereas that on Y* was accounted for by the change in the von Mises stress due to EBPS.