Effect of Equibiaxial Pre-Stress on Mechanical Properties Evaluated Using Depth-Sensing Indentation with a Point-Sharp Indenter
Open Access
Abstract
This study examined the effect of an imposed equibiaxial pre-stress (EBPS) on the evaluation of mechanical properties, using the depth-sensing indentation method with a point-sharp indenter, through a numerical analysis of indentations simulated with the 3D finite element method. The predicted elastic modulus, E*, and yield stress, Y*, were used as elastic and plastic deformation resistances under the indentation, respectively. It was found that both increased nominally with the increase in compressive EBPS and decreased with the increase in tensile EBPS, even though the induced change in the piling-up or sinking-in around the indentations was not significant. The effect of EBPS on E* was described by the Hooke’s law for an isotropic elastoplastic material, whereas that on Y* was accounted for by the change in the von Mises stress due to EBPS.Keywords
Funding Information
- Japan Society for the Promotion of Science (22K04701)
This publication has 36 references indexed in Scilit:
- Determining the elastic modulus and hardness of an ultra-thin film on a substrate using nanoindentationJournal of Materials Research, 2009
- Plastic Properties Identification of Thin Film Utilizing Substrate Effect with Conical IndentationTRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A, 2008
- Measuring residual stress in glasses and ceramics using instrumented indentationJournal of Materials Research, 2007
- Estimation of residual stresses from elastic recovery of nanoindentationPhilosophical Magazine, 2006
- Effects of strain hardening and residual stress in impression on the instrumented indentation techniqueJournal of Materials Research, 2006
- Elastic Deformation of Coating/substrate Composites in Axisymmetric IndentationJournal of Materials Research, 2005
- Influence of equi-biaxial residual stress on unloading behaviour of nanoindentationActa Materialia, 2005
- Hardness measurements of thin films-determining the critical ratio of depth to thickness using FEMThin Solid Films, 1995
- An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experimentsJournal of Materials Research, 1992
- A method for interpreting the data from depth-sensing indentation instrumentsJournal of Materials Research, 1986