G. N. Almeida
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
G. N. Almeida has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Alysson Martins Almeida Silva
Mechanical Sciences Graduate Program University of Brasília (UnB) Brasília Brazil
1 shared publication - E. Paulo Da Silva
Mechanical Engineering Department, Faculty of Technology, University of Brasília, Asa Norte, Brasília 70910-900, DF, Brazil
1 shared publication - L. F. S. Lima
Chemistry Department, Federal University of Minas Gerais, Av. Pres. Antônio Carlos, 6627, Pampulha, Belo Horizonte 31270-901, MG, Brazil
1 shared publication - Nelcy Della Santina Mohallem
Departamento de Química, Universidade Federal de Minas Gerais (UFMG), Brazil
1 shared publication - R. N. de Souza
Mechanical Engineering Department, Faculty of Technology, University of Brasília, Asa Norte, Brasília 70910-900, DF, Brazil
1 shared publication
Latest Publications
- Open Access
The Influence of the Synthesis Method on the Characteristics of BaTiO3
In this work, barium titanate powders were produced by sol-gel and sol-precipitation methods from metal alkoxides. In the sol-gel method, tetraisopropyl orthotitanate was mixed with 2-propanol, acetic acid and barium acetate, and the gel samples obtained were calcined at 600 °C, 800 °C and 1000 °C. Through the sol-precipitation method, tetraisopropyl orthotitanate was mixed with acetic acid and deionized water and precipitated by the addition of a concentrated solution of KOH. The products were calcined at various temperatures, and the microstructural and dielectric properties of the BaTiO3 prepared for the two processes were analyzed and compared. The results of these analyses allowed us to observe an increase in the tetragonal phase and the dielectric constant (15–50 at 20 kHz) with increasing temperatures in the samples produced by the sol-gel method, while the sample obtained by sol precipitation was cubic. The presence of BaCO3 is more evident in the sample produced by sol-precipitation, and the band gap of the products obtained did not show significant variation, changing the synthesis method (3.363–3.594 eV).
Open AccessThe Influence of the Synthesis Method on the Characteristics of BaTiO3
In this work, barium titanate powders were produced by sol-gel and sol-precipitation methods from metal alkoxides. In the sol-gel method, tetraisopropyl orthotitanate was mixed with 2-propanol, acetic acid and barium acetate, and the gel samples obtained were calcined at 600 °C, 800 °C and 1000 °C. Through the sol-precipitation method, tetraisopropyl orthotitanate was mixed with acetic acid and deionized water and precipitated by the addition of a concentrated solution of KOH. The products were calcined at various temperatures, and the microstructural and dielectric properties of the BaTiO3 prepared for the two processes were analyzed and compared. The results of these analyses allowed us to observe an increase in the tetragonal phase and the dielectric constant (15–50 at 20 kHz) with increasing temperatures in the samples produced by the sol-gel method, while the sample obtained by sol precipitation was cubic. The presence of BaCO3 is more evident in the sample produced by sol-precipitation, and the band gap of the products obtained did not show significant variation, changing the synthesis method (3.363–3.594 eV).