Elizabeth Caroline Britto
Elizabeth Caroline Britto has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
- S. Mohamed Nizar
The Grover Centre of Quantum Technology, Rajalakshmi Institute of Technology, Chennai, India
9 shared publications A.P. Kabilan
Department of Electronics and communication Engg., Chettinadu college of Engg &Tech Karur,. 639114. India
5 shared publications- Margarat Michael
IFET College of Engineering, Electronics and communication Engineering Department, Villupuram, Tamilnadu, India
5 shared publications X. Susan Christina
5 shared publications- Johnson William
Department of Electronics and Communications Engineering, Agnel Institute of Technology and Design, Goa, India
4 shared publications - Prabu Krishnan
Department of Electronics and Communication Engineering, National Institute of Technology Karnataka, Mangalore, India
4 shared publications
Latest Publications
- 30 September 2025
- Published by Springer Nature in Journal of Optics
- p. 1-8
Design and optimization of graphene-based terahertz absorber for stealth application
- 30 September 2025
- Published by Springer Nature in Journal of Optics
- p. 1-8
Design and optimization of graphene-based terahertz absorber for stealth application
- 1 September 2024
- Published by SPIE-Intl Soc Optical Eng in Optical Engineering
- Vol. 63 (09) , 095102-16
Design of photonic crystal semiconductor optical amplifier-based all-optical multiplexer and parameter optimization using particle swarm optimization algorithm
We propose a design leveraging photonic crystal semiconductor optical amplifiers (PhC-SOA), harnessing its unique capacity to manipulate and govern light at the nanoscale. Optimization of critical parameters to enhance performance is pursued through the utilization of the particle swarm optimization (PSO) algorithm. Initially, a multiplexer was constructed using logic gates, achieving a peak output power of 1.94e−11 mW. A PSO algorithm was employed to find the optimal PhC-SOA parameters such as length of active layer, input energy, simulation steps, full width at half maximum (FWHM), carrier recovery time, linewidth enhancement factor, saturation energy, and linear gain to maximize performance. The peak output power obtained from the PSO-optimized multiplexer is 2.9e−11 mW. This paper demonstrates the performance of PhC-SOA-based all-optical multiplexers and the effectiveness of PSO in optimizing the performance of all-optical multiplexers and contributes to the advancement of optical communication systems for high-speed applications.
- 1 September 2024
- Published by SPIE-Intl Soc Optical Eng in Optical Engineering
- Vol. 63 (09) , 095102-16
Design of photonic crystal semiconductor optical amplifier-based all-optical multiplexer and parameter optimization using particle swarm optimization algorithm
We propose a design leveraging photonic crystal semiconductor optical amplifiers (PhC-SOA), harnessing its unique capacity to manipulate and govern light at the nanoscale. Optimization of critical parameters to enhance performance is pursued through the utilization of the particle swarm optimization (PSO) algorithm. Initially, a multiplexer was constructed using logic gates, achieving a peak output power of 1.94e−11 mW. A PSO algorithm was employed to find the optimal PhC-SOA parameters such as length of active layer, input energy, simulation steps, full width at half maximum (FWHM), carrier recovery time, linewidth enhancement factor, saturation energy, and linear gain to maximize performance. The peak output power obtained from the PSO-optimized multiplexer is 2.9e−11 mW. This paper demonstrates the performance of PhC-SOA-based all-optical multiplexers and the effectiveness of PSO in optimizing the performance of all-optical multiplexers and contributes to the advancement of optical communication systems for high-speed applications.
- 14 January 2024
- Published by Springer Nature in Journal of Optics
- Vol. 53 (4) , 3708-3725
Design and performance analysis of 2D photonic crystal-based all-optical parity generator and checker
- 14 January 2024
- Published by Springer Nature in Journal of Optics
- Vol. 53 (4) , 3708-3725
Design and performance analysis of 2D photonic crystal-based all-optical parity generator and checker
- 17 October 2023
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 55 (13) , 1-16
Photonic crystal fiber sensor structure with vertical and horizontal cladding for the detection of hazardous gases
- 17 October 2023
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 55 (13) , 1-16
Photonic crystal fiber sensor structure with vertical and horizontal cladding for the detection of hazardous gases
- 1 February 2023
- Published by SPIE-Intl Soc Optical Eng in Optical Engineering
- Vol. 62 (02) , 027105-19
Design and analysis of Tbps all-optical gray code converter using photonic crystal-semiconductor optical amplifier-Mach–Zehnder interferometric structure
Future communication networks require the entire communication system to be all-optical to overcome the bandwidth constraints of electronics. All-optical devices play a vital role in supporting future networks, which demand a high speed of up to Tbps. An all-optical gray code converter operation was demonstrated numerically using a photonic crystal semiconductor optical amplifier (PhC-SOA) in a Mach–Zehnder interferometric (MZI) configuration at 1 Tbps for M-ary differential phase shift keying modulated binary and BCD inputs. The design achieved a very high extinction ratio of about 123.8 dB with a good quality factor value of about 45. The results show that PhC-SOA-based XOR and OR gates in the gray code converter design exhibits improved modulation features compared with traditional SOAs in our previous works.
- 1 February 2023
- Published by SPIE-Intl Soc Optical Eng in Optical Engineering
- Vol. 62 (02) , 027105-19
Design and analysis of Tbps all-optical gray code converter using photonic crystal-semiconductor optical amplifier-Mach–Zehnder interferometric structure
Future communication networks require the entire communication system to be all-optical to overcome the bandwidth constraints of electronics. All-optical devices play a vital role in supporting future networks, which demand a high speed of up to Tbps. An all-optical gray code converter operation was demonstrated numerically using a photonic crystal semiconductor optical amplifier (PhC-SOA) in a Mach–Zehnder interferometric (MZI) configuration at 1 Tbps for M-ary differential phase shift keying modulated binary and BCD inputs. The design achieved a very high extinction ratio of about 123.8 dB with a good quality factor value of about 45. The results show that PhC-SOA-based XOR and OR gates in the gray code converter design exhibits improved modulation features compared with traditional SOAs in our previous works.
- 13 October 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 2, 861-867
Unified 32-Channel SS-DWDM-PON Transmission System for Remote Monitoring
Dense Wavelength Division Multiplexing (DWDM) is an excellent solution for increasing channel capacity and be able to meet rapidly increasing bandwidth demands in optical fiber communication. The optical signal in this technology will convey numerous streams of data, each with its own individual wavelength. This article utilizes a single mode fiber with a length of 120km and a wavelength of 1555nm to reduce signal dispersion. The DWDM system analysis is carried out using an optisystem with a flow rate of 10Gbits/s per channel and simulation, optical amplifiers are utilized to achieve signals with enhanced Q-Factor and BER. The proposed system is used for the data transmission over longer distances more than 50km and helps to reduce the signal noise of the system.
- 13 October 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 2, 861-867
Unified 32-Channel SS-DWDM-PON Transmission System for Remote Monitoring
Dense Wavelength Division Multiplexing (DWDM) is an excellent solution for increasing channel capacity and be able to meet rapidly increasing bandwidth demands in optical fiber communication. The optical signal in this technology will convey numerous streams of data, each with its own individual wavelength. This article utilizes a single mode fiber with a length of 120km and a wavelength of 1555nm to reduce signal dispersion. The DWDM system analysis is carried out using an optisystem with a flow rate of 10Gbits/s per channel and simulation, optical amplifiers are utilized to achieve signals with enhanced Q-Factor and BER. The proposed system is used for the data transmission over longer distances more than 50km and helps to reduce the signal noise of the system.
- Open Access
- 10 September 2022
- Published by Springer Nature in Microsystem Technologies
- Vol. 28 (11) , 2571
Correction to: Photonic crystal fiber sensor for the detection of hazardous gases
- 10 September 2022
- Published by Springer Nature in Microsystem Technologies
- Vol. 28 (11) , 2571
Open AccessCorrection to: Photonic crystal fiber sensor for the detection of hazardous gases
- 21 July 2022
- Published by Springer Nature in Microsystem Technologies
- Vol. 28 (9) , 2023-2035
Photonic crystal fiber sensor for the detection of hazardous gases
- 21 July 2022
- Published by Springer Nature in Microsystem Technologies
- Vol. 28 (9) , 2023-2035
Photonic crystal fiber sensor for the detection of hazardous gases
- 23 June 2022
- Published by Springer Nature in Silicon
- Vol. 14 (18) , 12665-12674
A Highly Sensitive Photonic Crystal Fiber Gas Sensor for the Detection of Sulfur Dioxide
- 23 June 2022
- Published by Springer Nature in Silicon
- Vol. 14 (18) , 12665-12674
A Highly Sensitive Photonic Crystal Fiber Gas Sensor for the Detection of Sulfur Dioxide
- 12 June 2021
- Published by Springer Nature in Plasmonics
- Vol. 16 (6) , 2155-2165
Design and Investigation of a High-Sensitivity PCF Sensor for the Detection of Sulfur Dioxide
- 12 June 2021
- Published by Springer Nature in Plasmonics
- Vol. 16 (6) , 2155-2165
Design and Investigation of a High-Sensitivity PCF Sensor for the Detection of Sulfur Dioxide