Irnis Kubat
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Irnis Kubat has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Ole Bang
Technical University of Denmark
5 shared publications - Peter Morten Moselund
NKT Photonics A/S, Blokken 84, Birkerød 3460, Denmark
4 shared publications - Angela Beth Seddon
Mid-Infrared Photonics Group, George Green Institute for Electromagnetics’ Research, Faculty of Engineering, University of Nottingham, Nottingham NG7 2RD, UK
3 shared publications - Uffe Møller
DTU Fotonik, Department of Photonics Engineering, Technical University of Denmark, 2800 Kgs. Lyngby, Denmark
3 shared publications Christian Rosenberg Petersen
DTU Fotonik, Department of Photonics Engineering, Technical University of Denmark, 2800 Kgs. Lyngby, Denmark
2 shared publicationsChristian S. Agger
DTU Fotonik, Department of Photonics Engineering, Technical University of Denmark, 2800 Kgs. Lyngby, Denmark
2 shared publications
Latest Publications
- Open Access
- 1 February 2016
- Published by Optica Publishing Group in Optics Express
- Vol. 24 (3) , 2513-2526
Multimode supercontinuum generation in chalcogenide glass fibres
Mid-infrared supercontinuum generation is considered in chalcogenide fibres when taking into account both polarisations and the necessary higher order modes. In particular we focus on high pulse energy supercontinuum generation with long pump pulses. The modeling indicates that when only a single polarisation in the fundamental mode is considered the obtainable supercontinuum bandwidth is substantially exaggerated compared to when both polarisations are taken into account. Our modeling shows that if the pump pulse is short enough (≤ 10ps) then higher order modes are not important because of temporal walk-off. In contrast long pump pulses (≥ 40ps) will efficiently excite higher order modes through Raman scattering, which will deplete the fundamental mode of energy and limit the possibility of obtaining a broadband supercontinuum.
- 1 February 2016
- Published by Optica Publishing Group in Optics Express
- Vol. 24 (3) , 2513-2526
Open AccessMultimode supercontinuum generation in chalcogenide glass fibres
Mid-infrared supercontinuum generation is considered in chalcogenide fibres when taking into account both polarisations and the necessary higher order modes. In particular we focus on high pulse energy supercontinuum generation with long pump pulses. The modeling indicates that when only a single polarisation in the fundamental mode is considered the obtainable supercontinuum bandwidth is substantially exaggerated compared to when both polarisations are taken into account. Our modeling shows that if the pump pulse is short enough (≤ 10ps) then higher order modes are not important because of temporal walk-off. In contrast long pump pulses (≥ 40ps) will efficiently excite higher order modes through Raman scattering, which will deplete the fundamental mode of energy and limit the possibility of obtaining a broadband supercontinuum.
- Open Access
- 31 July 2014
- Published by Optica Publishing Group in Optics Express
- Vol. 22 (16) , 19169-19182
Mid-infrared supercontinuum generation to 125μm in large NA chalcogenide step-index fibres pumped at 45μm
We present numerical modeling of mid-infrared (MIR) supercontinuum generation (SCG) in dispersion-optimized chalcogenide (CHALC) step-index fibres (SIFs) with exceptionally high numerical aperture (NA) around one, pumped with mode-locked praseodymium-doped (Pr3+) chalcogenide fibre lasers. The 4.5um laser is assumed to have a repetition rate of 4MHz with 50ps long pulses having a peak power of 4.7kW. A thorough fibre design optimisation was conducted using measured material dispersion (As-Se/Ge-As-Se) and measured fibre loss obtained in fabricated fibre of the same materials. The loss was below 2.5dB/m in the 3.3–9.4μm region. Fibres with 8 and 10μm core diameters generated an SC out to 12.5 and 10.7μm in less than 2m of fibre when pumped with 0.75 and 1kW, respectively. Larger core fibres with 20μm core diameters for potential higher power handling generated an SC out to 10.6μm for the highest NA considered but required pumping at 4.7kW as well as up to 3m of fibre to compensate for the lower nonlinearities. The amount of power converted into the 8–10μm band was 7.5 and 8.8mW for the 8 and 10μm fibres, respectively. For the 20μm core fibres up to 46mW was converted.
- 31 July 2014
- Published by Optica Publishing Group in Optics Express
- Vol. 22 (16) , 19169-19182
Open AccessMid-infrared supercontinuum generation to 125μm in large NA chalcogenide step-index fibres pumped at 45μm
We present numerical modeling of mid-infrared (MIR) supercontinuum generation (SCG) in dispersion-optimized chalcogenide (CHALC) step-index fibres (SIFs) with exceptionally high numerical aperture (NA) around one, pumped with mode-locked praseodymium-doped (Pr3+) chalcogenide fibre lasers. The 4.5um laser is assumed to have a repetition rate of 4MHz with 50ps long pulses having a peak power of 4.7kW. A thorough fibre design optimisation was conducted using measured material dispersion (As-Se/Ge-As-Se) and measured fibre loss obtained in fabricated fibre of the same materials. The loss was below 2.5dB/m in the 3.3–9.4μm region. Fibres with 8 and 10μm core diameters generated an SC out to 12.5 and 10.7μm in less than 2m of fibre when pumped with 0.75 and 1kW, respectively. Larger core fibres with 20μm core diameters for potential higher power handling generated an SC out to 10.6μm for the highest NA considered but required pumping at 4.7kW as well as up to 3m of fibre to compensate for the lower nonlinearities. The amount of power converted into the 8–10μm band was 7.5 and 8.8mW for the 8 and 10μm fibres, respectively. For the 20μm core fibres up to 46mW was converted.
- Open Access
- 12 February 2014
- Published by Optica Publishing Group in Optics Express
- Vol. 22 (4) , 3959-3967
Thulium pumped mid-infrared 09–9μm supercontinuum generation in concatenated fluoride and chalcogenide glass fibers
We theoretically demonstrate a novel approach for generating Mid-InfraRed SuperContinuum (MIR SC) by using concatenated fluoride and chalcogenide glass fibers pumped with a standard pulsed Thulium (Tm) laser (TFWHM=3.5ps, P0=20kW, νR=30MHz, and Pavg=2W). The fluoride fiber SC is generated in 10m of ZBLAN spanning the 0.9–4.1μm SC at the −30dB level. The ZBLAN fiber SC is then coupled into 10cm of As2Se3 chalcogenide Microstructured Optical Fiber (MOF) designed to have a zero-dispersion wavelength (λZDW) significantly below the 4.1μm InfraRed (IR) edge of the ZBLAN fiber SC, here 3.55μm. This allows the MIR solitons in the ZBLAN fiber SC to couple into anomalous dispersion in the chalcogenide fiber and further redshift out to the fiber loss edge at around 9μm. The final 0.9–9μm SC covers over 3 octaves in the MIR with around 15mW of power converted into the 6–9μm range.
- 12 February 2014
- Published by Optica Publishing Group in Optics Express
- Vol. 22 (4) , 3959-3967
Open AccessThulium pumped mid-infrared 09–9μm supercontinuum generation in concatenated fluoride and chalcogenide glass fibers
We theoretically demonstrate a novel approach for generating Mid-InfraRed SuperContinuum (MIR SC) by using concatenated fluoride and chalcogenide glass fibers pumped with a standard pulsed Thulium (Tm) laser (TFWHM=3.5ps, P0=20kW, νR=30MHz, and Pavg=2W). The fluoride fiber SC is generated in 10m of ZBLAN spanning the 0.9–4.1μm SC at the −30dB level. The ZBLAN fiber SC is then coupled into 10cm of As2Se3 chalcogenide Microstructured Optical Fiber (MOF) designed to have a zero-dispersion wavelength (λZDW) significantly below the 4.1μm InfraRed (IR) edge of the ZBLAN fiber SC, here 3.55μm. This allows the MIR solitons in the ZBLAN fiber SC to couple into anomalous dispersion in the chalcogenide fiber and further redshift out to the fiber loss edge at around 9μm. The final 0.9–9μm SC covers over 3 octaves in the MIR with around 15mW of power converted into the 6–9μm range.
- 1 January 2014
- Published by Optica Publishing Group
- p. STh3N.1
Mid-infrared supercontinuum generation in concatenated fluoride and chalcogenide glass fibers covering more than three octaves
Supercontinuum is generated in concatenated ZBLAN and As2Se3 fibers. Initially, a 0.9–4.1mm supercontinuum is obtained by pumping the ZBLAN fiber with a Tm laser, which then continues to broaden to 0.9–9um in As2Se3 fiber.
- 1 January 2014
- Published by Optica Publishing Group
- p. STh3N.1
Mid-infrared supercontinuum generation in concatenated fluoride and chalcogenide glass fibers covering more than three octaves
Supercontinuum is generated in concatenated ZBLAN and As2Se3 fibers. Initially, a 0.9–4.1mm supercontinuum is obtained by pumping the ZBLAN fiber with a Tm laser, which then continues to broaden to 0.9–9um in As2Se3 fiber.
- 30 September 2013
- Published by Optica Publishing Group in Journal of the Optical Society of America B
- Vol. 30 (10) , 2743-2757
Mid-infrared supercontinuum generation to 45 μm in uniform and tapered ZBLAN step-index fibers by direct pumping at 1064 or 1550 nm
Optics InfoBase is the Optical Society's online library for flagship journals, partnered and copublished journals, and recent proceedings from OSA conferences.
- 30 September 2013
- Published by Optica Publishing Group in Journal of the Optical Society of America B
- Vol. 30 (10) , 2743-2757
Mid-infrared supercontinuum generation to 45 μm in uniform and tapered ZBLAN step-index fibers by direct pumping at 1064 or 1550 nm
Optics InfoBase is the Optical Society's online library for flagship journals, partnered and copublished journals, and recent proceedings from OSA conferences.