D. S. Shynybayev
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
D. S. Shynybayev has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- A. Zh. Kusainova
Kazakhstan-British Technical University
2 shared publications - Assanali T. Sultanov
Kazakh-British Technical University
2 shared publications - K. Kh. Nussupov
Kazakh-British Technical University
2 shared publications - Nurzhan B. Beisenkhanov
School of Materials Science and Green Technologies, Kazakh-British Technical University, Tole bi 59, Almaty 050000, Kazakhstan
2 shared publications - Ilya Zhirkov
Kazakh-British Technical University
1 shared publication - Sergey A. Kukushkin
Institute for Problems in Mechanical Engineering of the Russian Academy of Sciences, St. Petersburg, Russia
1 shared publication
Latest Publications
- Open Access
- 27 October 2023
- Published by al-Farabi Kazakh National University in Physical Sciences and Technology
- Vol. 10 (3-4) , 28-32
Influence of the RF magnetron sputtering power on the optical and electrical properties of AZO films
Thin AZO films were synthesized using radio frequency magnetron sputtering method on the surface of polished silicon samples and glass slides. The sputtering power was varied in the range of 150–300 W with the step of 25W; deposition time was adjusted so that the film thickness remained equal to 70 nm. The rest of the deposition parameters: working pressure, temperature, and the substrate rotation rate, remained unchanged. The thickness and deposition rate of thin films were measured using X-ray reflectometry. The electrical properties (resistivity, Hall mobility and charge concentration) of thin films were measured by the Van Der Pauw method using the Hall effect. The transmission spectra of the films were measured in the wavelength range from 300 to 1100 nm. The average crystallite size was determined using X-ray diffraction spectra and the Scherrer equation. As a result, it was shown that AZO films synthesized at a power of 300 W have the best electrical and optical properties. At this power, the lowest resistivity value of 2.83×10-3 Ω∙cm and the maximum charge mobility of 9.6 cm2V-1sec-1 were achieved for films of the same thickness 70 nm. The decrease in the electrical resistivity of the films with increasing power is explained by more intense heating of the substrate during deposition, which leads to an improvement in the crystallinity of the film, and, as a consequence, to an increase in the mobility of charge carriers.
- 27 October 2023
- Published by al-Farabi Kazakh National University in Physical Sciences and Technology
- Vol. 10 (3-4) , 28-32
Open AccessInfluence of the RF magnetron sputtering power on the optical and electrical properties of AZO films
Thin AZO films were synthesized using radio frequency magnetron sputtering method on the surface of polished silicon samples and glass slides. The sputtering power was varied in the range of 150–300 W with the step of 25W; deposition time was adjusted so that the film thickness remained equal to 70 nm. The rest of the deposition parameters: working pressure, temperature, and the substrate rotation rate, remained unchanged. The thickness and deposition rate of thin films were measured using X-ray reflectometry. The electrical properties (resistivity, Hall mobility and charge concentration) of thin films were measured by the Van Der Pauw method using the Hall effect. The transmission spectra of the films were measured in the wavelength range from 300 to 1100 nm. The average crystallite size was determined using X-ray diffraction spectra and the Scherrer equation. As a result, it was shown that AZO films synthesized at a power of 300 W have the best electrical and optical properties. At this power, the lowest resistivity value of 2.83×10-3 Ω∙cm and the maximum charge mobility of 9.6 cm2V-1sec-1 were achieved for films of the same thickness 70 nm. The decrease in the electrical resistivity of the films with increasing power is explained by more intense heating of the substrate during deposition, which leads to an improvement in the crystallinity of the film, and, as a consequence, to an increase in the mobility of charge carriers.
- Open Access
- 1 July 2023
- Published by Kazakh-British Technical University in Herald of the Kazakh-British technical university
- Vol. 20 (2) , 27-35
FORMATION OF CRYSTALLINE SiC IN NEAR-SURFACE SILICON LAYERS BY METHOD OF COORDINATED SUBSTITUTION OF ATOMS
In this work, monocrystalline films of silicon carbide were synthesized on the surface of a Si(100) silicon wafer using the method of coordinated substitution of atoms. The films were synthesized at temperatures of 1200 °C and 1300 °C for 20 minutes in a CO gas flow at a pressure of 0.8 Pa. The effect of 1200–1300 °C temperatures on the formation of single- and polycrystalline layers, as well as nanostructured SiC phases in the near-surface region of silicon by the method of atom substitution, is analyzed. The formation of a high-quality crystalline silicon carbide film and the influence of synthesis conditions on the total volume of SiC structural phases, microstructure and nanostructure of the surface are shown. It was found that an increase in temperature from 1200 °C to 1300 °C led to a more intensive formation of silicon carbide and an increase in the number of Si–C bonds by 1.9 times due to an increase in the thickness of the synthesized silicon carbide layer. There is an increase in the proportion of the crystalline phase due to a more intense transformation of the nuclei of nanocrystals into micro- and nanocrystals. Intense processes of penetration of carbon atoms deep into silicon at a temperature of 1300 °C with amorphization of its structure and the formation of Si-C, which can transform into crystalline phases at temperatures above 1300 °C, are assumed. The proportion of the SiC crystalline phase increases to 50.2% of the film volume due to the intensive transformation of nanocrystal nuclei into micro- and nanocrystals. It has been experimentally shown that the formation of various SiC structures on Si (100) occurs in full accordance with the main principles of the method of coordinated substitution of atoms.
- 1 July 2023
- Published by Kazakh-British Technical University in Herald of the Kazakh-British technical university
- Vol. 20 (2) , 27-35
Open AccessFORMATION OF CRYSTALLINE SiC IN NEAR-SURFACE SILICON LAYERS BY METHOD OF COORDINATED SUBSTITUTION OF ATOMS
In this work, monocrystalline films of silicon carbide were synthesized on the surface of a Si(100) silicon wafer using the method of coordinated substitution of atoms. The films were synthesized at temperatures of 1200 °C and 1300 °C for 20 minutes in a CO gas flow at a pressure of 0.8 Pa. The effect of 1200–1300 °C temperatures on the formation of single- and polycrystalline layers, as well as nanostructured SiC phases in the near-surface region of silicon by the method of atom substitution, is analyzed. The formation of a high-quality crystalline silicon carbide film and the influence of synthesis conditions on the total volume of SiC structural phases, microstructure and nanostructure of the surface are shown. It was found that an increase in temperature from 1200 °C to 1300 °C led to a more intensive formation of silicon carbide and an increase in the number of Si–C bonds by 1.9 times due to an increase in the thickness of the synthesized silicon carbide layer. There is an increase in the proportion of the crystalline phase due to a more intense transformation of the nuclei of nanocrystals into micro- and nanocrystals. Intense processes of penetration of carbon atoms deep into silicon at a temperature of 1300 °C with amorphization of its structure and the formation of Si-C, which can transform into crystalline phases at temperatures above 1300 °C, are assumed. The proportion of the SiC crystalline phase increases to 50.2% of the film volume due to the intensive transformation of nanocrystal nuclei into micro- and nanocrystals. It has been experimentally shown that the formation of various SiC structures on Si (100) occurs in full accordance with the main principles of the method of coordinated substitution of atoms.