Soad Mohsenimehr
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Soad Mohsenimehr has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
Achim von Keudell
Experimental Physics II - Reactive Plasmas, Ruhr-Universität Bochum, Bochum, Germany
2 shared publicationsA. von Keudell
Experimental Physics II-Reactive Plasmas, Ruhr University Bochum, Bochum, Germany
1 shared publicationS. Wilczek
Technische Hochschule Georg Agricola, Bochum, Germany
1 shared publicationT. Mussenbrock
Chair of Applied Electrodynamics and Plasma Technology, Ruhr University Bochum, Bochum, Germany
1 shared publication
Latest Publications
- Open Access
- 3 December 2024
- Published by Springer Nature in Plasma Chemistry and Plasma Processing
- Vol. 45 (1) , 85-112
Plasma and Flow Simulation of the Ion Wind in a Surface Barrier Discharge Used for Gas Conversion Benchmarked by Schlieren Imaging
Surface dielectric barrier discharges (sDBD) are efficient and scalable plasma sources for plasma-based gas conversion. One prominent feature of an sDBD is the generation of an ion wind, which exerts a force on the neutrals, thus leading to an efficient mixing of plasma and a passing gas stream. This becomes apparent by the creation of upstream and downstream vortices in the vicinity of the plasma. In this study, these vortices are generated by high voltage burst pulses consisting of two half cycles of an almost sinusoidal voltage shape. The vortices are monitored by Schlieren imaging diagnostic to benchmark and connect two simulations of the sDBD: a plasma model simulating a streamer for 25 ns starting from the electrode and propagating along a dielectric surface followed by a decay. The streamer is the source of electrical charges accelerated as ion wind by the applied electric field from the sDBD power supply. A second flow simulation models this ion wind as a time-averaged thrust acting on the passing gas stream. The conversion of the time-resolved forces from the nanosecond plasma simulation into the steady state thrust in the flow simulation indicates that the force from the plasma lasts much longer than the actual streamer propagation phase. This is explained by the fact that the charges in the streamer channel remain present for almost 100 ns, and the voltage from the power supply lasts for a few microseconds being applied to the electrode so that ions in the streamer channel are still accelerated even after a streamer stops to propagate after a few ns. The thrust generated during the streamer phase, including the relaxation phase, agrees well with predictions from flow simulation. Additionally, properly converting the time-resolved forces from the plasma simulation into a time-averaged thrust for the flow simulation yields exactly the synthetic Schlieren images as measured in the experiments.
- 3 December 2024
- Published by Springer Nature in Plasma Chemistry and Plasma Processing
- Vol. 45 (1) , 85-112
Open AccessPlasma and Flow Simulation of the Ion Wind in a Surface Barrier Discharge Used for Gas Conversion Benchmarked by Schlieren Imaging
Surface dielectric barrier discharges (sDBD) are efficient and scalable plasma sources for plasma-based gas conversion. One prominent feature of an sDBD is the generation of an ion wind, which exerts a force on the neutrals, thus leading to an efficient mixing of plasma and a passing gas stream. This becomes apparent by the creation of upstream and downstream vortices in the vicinity of the plasma. In this study, these vortices are generated by high voltage burst pulses consisting of two half cycles of an almost sinusoidal voltage shape. The vortices are monitored by Schlieren imaging diagnostic to benchmark and connect two simulations of the sDBD: a plasma model simulating a streamer for 25 ns starting from the electrode and propagating along a dielectric surface followed by a decay. The streamer is the source of electrical charges accelerated as ion wind by the applied electric field from the sDBD power supply. A second flow simulation models this ion wind as a time-averaged thrust acting on the passing gas stream. The conversion of the time-resolved forces from the nanosecond plasma simulation into the steady state thrust in the flow simulation indicates that the force from the plasma lasts much longer than the actual streamer propagation phase. This is explained by the fact that the charges in the streamer channel remain present for almost 100 ns, and the voltage from the power supply lasts for a few microseconds being applied to the electrode so that ions in the streamer channel are still accelerated even after a streamer stops to propagate after a few ns. The thrust generated during the streamer phase, including the relaxation phase, agrees well with predictions from flow simulation. Additionally, properly converting the time-resolved forces from the plasma simulation into a time-averaged thrust for the flow simulation yields exactly the synthetic Schlieren images as measured in the experiments.
- Open Access
- 19 October 2023
- Published by Springer Nature in Plasma Chemistry and Plasma Processing
- Vol. 43 (6) , 1633-1649
Surface Dielectric Barrier Discharge (sDBD) for Flow Control in Plasma Conversion
Dielectric barrier discharges (DBD) are often used for gas conversion, such as carbon dioxide splitting, volatile organic compound removal or ozone generation. Due to the tiny plasma filaments in DBD discharges, efficient mixing of the gas flow with the plasma is essential. This is studied by using a surface dielectric barrier discharge (sDBD) with an electrode design similar to plasma actuators to optimize plasma-flow interaction. The flow pattern has been measured by Schlieren diagnostics and compared to a fluid dynamic simulation. Gas conversion efficiency has been tested by monitoring the conversion of 0.7% CO $$_2$$ admixed to an N $$_2$$ gas stream via infrared spectroscopy in the exhaust. The actuator design of the electrodes induces a significant plasma force on the fluid, which results in the formation of vortices above the electrodes, as reproduced in the simulation. It is shown that the height of the vortices created in the velocity field can characterize the mixing process, which dominates the conversion efficiency of carbon dioxide at different gas flow rates.- 19 October 2023
- Published by Springer Nature in Plasma Chemistry and Plasma Processing
- Vol. 43 (6) , 1633-1649
Open AccessSurface Dielectric Barrier Discharge (sDBD) for Flow Control in Plasma Conversion
Dielectric barrier discharges (DBD) are often used for gas conversion, such as carbon dioxide splitting, volatile organic compound removal or ozone generation. Due to the tiny plasma filaments in DBD discharges, efficient mixing of the gas flow with the plasma is essential. This is studied by using a surface dielectric barrier discharge (sDBD) with an electrode design similar to plasma actuators to optimize plasma-flow interaction. The flow pattern has been measured by Schlieren diagnostics and compared to a fluid dynamic simulation. Gas conversion efficiency has been tested by monitoring the conversion of 0.7% CO $$_2$$ admixed to an N $$_2$$ gas stream via infrared spectroscopy in the exhaust. The actuator design of the electrodes induces a significant plasma force on the fluid, which results in the formation of vortices above the electrodes, as reproduced in the simulation. It is shown that the height of the vortices created in the velocity field can characterize the mixing process, which dominates the conversion efficiency of carbon dioxide at different gas flow rates. - Open Access
- 10 July 2023
- Published by Springer Nature in Research Square
Surface dielectric barrier discharge (sDBD) for flow control in plasma conversion
Dielectric barrier discharges (DBD) are often used for gas conversion such as splitting of carbon dioxide, volatile organic compound removal or ozone generation. Due to the small plasma filaments in DBD discharges an efficient mixing of the gas flow with the plasma is essential. This is studied by using a surface dielectric barrier discharge (sDBD) with an electrode design similar to plasma actuators to optimize plasma-flow interaction. The flow pattern has been measured by Schlieren diagnostics and compared to a fluid dynamic simulation. The efficiency of gas conversion has been tested by monitoring the conversion of 1\% CO$_2$ admixed to an N$_2$ gas stream via infrared spectroscopy in the exhaust. The actuator design of the electrodes induces a significant plasma force on the fluid, which results in the formation of vortices above the electrodes as reproduced in the simulation. It is shown that the height of the vortices created in the velocity field can characterize the mixing process, which dominates the conversion efficiency of carbon dioxide at different gas flow rates.
- 10 July 2023
- Published by Springer Nature in Research Square
Open AccessSurface dielectric barrier discharge (sDBD) for flow control in plasma conversion
Dielectric barrier discharges (DBD) are often used for gas conversion such as splitting of carbon dioxide, volatile organic compound removal or ozone generation. Due to the small plasma filaments in DBD discharges an efficient mixing of the gas flow with the plasma is essential. This is studied by using a surface dielectric barrier discharge (sDBD) with an electrode design similar to plasma actuators to optimize plasma-flow interaction. The flow pattern has been measured by Schlieren diagnostics and compared to a fluid dynamic simulation. The efficiency of gas conversion has been tested by monitoring the conversion of 1\% CO$_2$ admixed to an N$_2$ gas stream via infrared spectroscopy in the exhaust. The actuator design of the electrodes induces a significant plasma force on the fluid, which results in the formation of vortices above the electrodes as reproduced in the simulation. It is shown that the height of the vortices created in the velocity field can characterize the mixing process, which dominates the conversion efficiency of carbon dioxide at different gas flow rates.