L. Cappelli
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
L. Cappelli has a total of 53 co-authors. Here are the top co-authors by number of shared publications:
- Eric Serre
Aix Marseille Univ, CNRS, Centrale Marseille, M2P2
4 shared publications - Jerome Guterl
General Atomics, San Diego, CA 92121, United States of America
3 shared publications N. Fedorczak
CEA, IRFM, Saint-Paul-Lez-Durance, F-13108, France
3 shared publicationsG. Ciraolo
2 shared publicationsH. Bufferand
2 shared publicationsJ.P. Gunn
CEA, IRFM, Saint-Paul-Lez-Durance, F-13108, France
2 shared publications
Latest Publications
- 1 January 2026
- Published by IOP Publishing in Plasma Physics and Controlled Fusion
- Vol. 68 (1) , 015017
Analysis and modeling of tungsten emission and net erosion in the DIII-D divertor using updated atomic data
Tungsten (W) is one of the leading candidate materials for plasma-facing components. However, its main drawback is its high radiative efficiency; if W penetrates the plasma, it can lead to core degradation or even collapse. Since eroded tungsten tends to ionize in the sheath and redeposit promptly, the net erosion flux that escapes prompt redeposition can differ significantly from the gross erosion. This work presents a modeling framework to estimate net erosion and photon emission from W coatings exposed to the lower divertor of DIII-D using the DiMES material exposure probe. The approach couples RustBCA for sputtering yields with a Monte Carlo transport code (LPTMC) that models redeposition and W emission. Computation is carried out with new atomic data, based on R-matrix and Mons calculations, leading to lower ionization probabilities and a twofold increase in net erosion estimates compared to calculations done with OPEN-ADAS atomic data. The model results are benchmarked against experimental measurements, showing quantitative agreement for erosion, although the trends in W emission are reproduced only qualitatively. The model is also used to assess whether W II emission can serve as a direct measurement of the net erosion of W in the lower divertor of DIII-D. Simulations show that this is not valid if the electron pressure is above ∼ 120 Pa or if the toroidal length of the eroded material is smaller than the parallel-to-B distance traveled by impurity ions before steady-state conditions are reached. Finally, simulations suggest that when W is sputtered by carbon ions with high impact energies ( ≳ 300 eV) in DIII-D, W net erosion scales with W gross erosion and can be numerically approximated using W I flux alone as input.
- 1 January 2026
- Published by IOP Publishing in Plasma Physics and Controlled Fusion
- Vol. 68 (1) , 015017
Analysis and modeling of tungsten emission and net erosion in the DIII-D divertor using updated atomic data
Tungsten (W) is one of the leading candidate materials for plasma-facing components. However, its main drawback is its high radiative efficiency; if W penetrates the plasma, it can lead to core degradation or even collapse. Since eroded tungsten tends to ionize in the sheath and redeposit promptly, the net erosion flux that escapes prompt redeposition can differ significantly from the gross erosion. This work presents a modeling framework to estimate net erosion and photon emission from W coatings exposed to the lower divertor of DIII-D using the DiMES material exposure probe. The approach couples RustBCA for sputtering yields with a Monte Carlo transport code (LPTMC) that models redeposition and W emission. Computation is carried out with new atomic data, based on R-matrix and Mons calculations, leading to lower ionization probabilities and a twofold increase in net erosion estimates compared to calculations done with OPEN-ADAS atomic data. The model results are benchmarked against experimental measurements, showing quantitative agreement for erosion, although the trends in W emission are reproduced only qualitatively. The model is also used to assess whether W II emission can serve as a direct measurement of the net erosion of W in the lower divertor of DIII-D. Simulations show that this is not valid if the electron pressure is above ∼ 120 Pa or if the toroidal length of the eroded material is smaller than the parallel-to-B distance traveled by impurity ions before steady-state conditions are reached. Finally, simulations suggest that when W is sputtered by carbon ions with high impact energies ( ≳ 300 eV) in DIII-D, W net erosion scales with W gross erosion and can be numerically approximated using W I flux alone as input.
- Open Access
- 22 November 2024
- Published by Elsevier in Nuclear Materials and Energy
- Vol. 41
SOLEDGE3X integrated core-edge modelling of tungsten sources, migration, and radiation in WEST plasmas
- 22 November 2024
- Published by Elsevier in Nuclear Materials and Energy
- Vol. 41
Open AccessSOLEDGE3X integrated core-edge modelling of tungsten sources, migration, and radiation in WEST plasmas
- Open Access
- 15 October 2024
- Published by IOP Publishing in Nuclear Fusion
- Vol. 64 (12) , 126049
Global analysis of tungsten migration in WEST discharges using numerical modelling
Plasma discharges in the tungsten (W) Environment Steady-state Tokamak (WEST) are strongly impacted by W contamination. In WEST experiments, due to W contamination, the power radiated in the plasma (P Rad) is on average, around 50% of the total power injected into the plasma (P TOT). Furthermore, this radiated power fraction (f Rad) is almost insensitive to plasma conditions. The causes behind this experimental trend are not fully understood. In this contribution, a 3D numerical model is used to analyze the W migration in the WEST boundary plasma in different plasma scenarios. The WEST experimental database is sampled to obtain a scan of simulation input parameters. These parameters mimic the WEST plasma conditions over a chosen experimental campaign. The simulation results are compared to WEST diagnostics measurements (reflectometry, Langmuir probes, and visible spectroscopy) to verify that the simulated plasma conditions are representative of the WEST database. The W contamination trend is analyzed: the W density (n W) strongly decreases when the radial distance between the separatrix and WEST antennas (Radial Outer Gap, ROG) increases. On the other hand, at a given ROG, n W increases proportionally with the power entering the scrape-off layer (P SOL). P Rad is estimated with a simple 0D model. For a fixed ROG, f Rad is not sensitive to plasma conditions. These trends are qualitatively and, at times, quantitatively comparable to what is observed in WEST experiments: the simulated trends are related to the poorly screened W influx caused by the erosion of the main chamber Plasma-Facing Components. Thus, this numerical analysis suggests a possible interpretation of WEST experimental trends.
- 15 October 2024
- Published by IOP Publishing in Nuclear Fusion
- Vol. 64 (12) , 126049
Open AccessGlobal analysis of tungsten migration in WEST discharges using numerical modelling
Plasma discharges in the tungsten (W) Environment Steady-state Tokamak (WEST) are strongly impacted by W contamination. In WEST experiments, due to W contamination, the power radiated in the plasma (P Rad) is on average, around 50% of the total power injected into the plasma (P TOT). Furthermore, this radiated power fraction (f Rad) is almost insensitive to plasma conditions. The causes behind this experimental trend are not fully understood. In this contribution, a 3D numerical model is used to analyze the W migration in the WEST boundary plasma in different plasma scenarios. The WEST experimental database is sampled to obtain a scan of simulation input parameters. These parameters mimic the WEST plasma conditions over a chosen experimental campaign. The simulation results are compared to WEST diagnostics measurements (reflectometry, Langmuir probes, and visible spectroscopy) to verify that the simulated plasma conditions are representative of the WEST database. The W contamination trend is analyzed: the W density (n W) strongly decreases when the radial distance between the separatrix and WEST antennas (Radial Outer Gap, ROG) increases. On the other hand, at a given ROG, n W increases proportionally with the power entering the scrape-off layer (P SOL). P Rad is estimated with a simple 0D model. For a fixed ROG, f Rad is not sensitive to plasma conditions. These trends are qualitatively and, at times, quantitatively comparable to what is observed in WEST experiments: the simulated trends are related to the poorly screened W influx caused by the erosion of the main chamber Plasma-Facing Components. Thus, this numerical analysis suggests a possible interpretation of WEST experimental trends.
- Open Access
- 11 October 2024
- Published by Elsevier in Nuclear Materials and Energy
- Vol. 41
Survey of tungsten gross erosion from main plasma facing components in WEST during a L-mode high fluence campaign
- 11 October 2024
- Published by Elsevier in Nuclear Materials and Energy
- Vol. 41
Open AccessSurvey of tungsten gross erosion from main plasma facing components in WEST during a L-mode high fluence campaign
- Open Access
- 30 August 2024
- Published by IOP Publishing in Nuclear Fusion
- Vol. 64 (10) , 106028
Semi-analytical modeling of prompt redeposition in a steady-state plasma
A steady-state, 1D semi-analytical model for prompt redeposition based on the separation between redeposition caused by the electric field in the sheath and redeposition related to gyromotion is here described. The model allows for the estimation of not only the fraction of promptly redeposited flux but also the energy and angular distribution of the non-promptly redeposited population, along with their average charge state. Thus, the temperature and mean parallel-to-B velocity of the non-promptly redeposited flux are also available. The semi-analytical model was validated against equivalent Monte Carlo simulations across a broad range of input parameters. In this paper the eroded material under exam was tungsten (W) for which the code demonstrated consistent agreement with respect to numerical results, within its defined validity limits. The model can theoretically provide a solution for any material, temperature and electron density profile in the sheath, monotonic potential drop profile, and sputtered particles energy and angular distribution at the wall. As such, this code emerges as a potential tool for addressing the boundary redeposition phenomenon in fluid impurity transport simulations.
- 30 August 2024
- Published by IOP Publishing in Nuclear Fusion
- Vol. 64 (10) , 106028
Open AccessSemi-analytical modeling of prompt redeposition in a steady-state plasma
A steady-state, 1D semi-analytical model for prompt redeposition based on the separation between redeposition caused by the electric field in the sheath and redeposition related to gyromotion is here described. The model allows for the estimation of not only the fraction of promptly redeposited flux but also the energy and angular distribution of the non-promptly redeposited population, along with their average charge state. Thus, the temperature and mean parallel-to-B velocity of the non-promptly redeposited flux are also available. The semi-analytical model was validated against equivalent Monte Carlo simulations across a broad range of input parameters. In this paper the eroded material under exam was tungsten (W) for which the code demonstrated consistent agreement with respect to numerical results, within its defined validity limits. The model can theoretically provide a solution for any material, temperature and electron density profile in the sheath, monotonic potential drop profile, and sputtered particles energy and angular distribution at the wall. As such, this code emerges as a potential tool for addressing the boundary redeposition phenomenon in fluid impurity transport simulations.
- Open Access
- 4 November 2023
- Published by Elsevier in Nuclear Materials and Energy
- Vol. 37
Model validation of tungsten erosion and redeposition properties using biased tungsten samples on DiMES
- 4 November 2023
- Published by Elsevier in Nuclear Materials and Energy
- Vol. 37
Open AccessModel validation of tungsten erosion and redeposition properties using biased tungsten samples on DiMES
- Open Access
- 18 July 2023
- Published by IOP Publishing in Plasma Physics and Controlled Fusion
- Vol. 65 (9) , 095001
Study of the erosion and redeposition of W considering the kinetic energy distribution of incident ions through a semi-analytical model
In today’s nuclear fusion devices, erosion of high-Z metallic plasma-facing materials (PFMs) is mainly caused by physical sputtering. That is, by the exchange of energy between plasma ions and the atoms in the walls. In most of the numerical codes currently in use impinging plasma is approximated as a fluid. By averaging the incident particles’ energy distribution the high-energy population of the eroded material is underestimated. For heavy materials such as W, high-energy eroded particles tend to ionize far from the wall and they are less affected by the sheath electric field hence, not being attracted back to the wall, they have a higher chance to contaminate the core plasma. This could in turn result in an underestimation of the net erosion sources. In this work, a semi-analytical model was developed to include the energy distribution of the incident particles. Then, by Monte Carlo method, the net erosion of tungsten from a smooth PFM was calculated. The results show that the kinetic description in energy is important only for incident particles ionized once. For instance, it is particularly important for plasma ions such as Deuterium. It is seen that Deuterium contribution to the W net sources is not always negligible if compared to light impurities or to tungsten self-sputtering in the range of plasma parameters tested. Finally, results show that the difference between the fluid and kinetic models becomes more pronounced for high-screening plasma conditions.
- 18 July 2023
- Published by IOP Publishing in Plasma Physics and Controlled Fusion
- Vol. 65 (9) , 095001
Open AccessStudy of the erosion and redeposition of W considering the kinetic energy distribution of incident ions through a semi-analytical model
In today’s nuclear fusion devices, erosion of high-Z metallic plasma-facing materials (PFMs) is mainly caused by physical sputtering. That is, by the exchange of energy between plasma ions and the atoms in the walls. In most of the numerical codes currently in use impinging plasma is approximated as a fluid. By averaging the incident particles’ energy distribution the high-energy population of the eroded material is underestimated. For heavy materials such as W, high-energy eroded particles tend to ionize far from the wall and they are less affected by the sheath electric field hence, not being attracted back to the wall, they have a higher chance to contaminate the core plasma. This could in turn result in an underestimation of the net erosion sources. In this work, a semi-analytical model was developed to include the energy distribution of the incident particles. Then, by Monte Carlo method, the net erosion of tungsten from a smooth PFM was calculated. The results show that the kinetic description in energy is important only for incident particles ionized once. For instance, it is particularly important for plasma ions such as Deuterium. It is seen that Deuterium contribution to the W net sources is not always negligible if compared to light impurities or to tungsten self-sputtering in the range of plasma parameters tested. Finally, results show that the difference between the fluid and kinetic models becomes more pronounced for high-screening plasma conditions.