H. H. Gieselman
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
H. H. Gieselman has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- David J. White
University of Southampton
2 shared publications - Pavana Kumar Reddy Vennapusa
Associate Professor, Director, Dept. of Civil Construction and Environmental Engineering, Center for Earthworks Engineering Research (CEER), Iowa State University, Ames, Iowa
2 shared publications - Jiake Zhang
Department of Civil, Construction and Environmental Engineering, Iowa State University, 2711 South Loop Drive, Suite 4600, Ames, IA 50010-8664
1 shared publication - Mark H. Wayne
Tensar International, Alpharetta, GA
1 shared publication - S. Caleb Douglas
Professor of Civil Engineering, Iowa State University, Ames, IA 50010-3232
1 shared publication
Latest Publications
- 11 March 2011
- Published by American Society of Civil Engineers (ASCE)
- p. 4663-4672
In-Ground Dynamic Stress Measurements for Geosynthetic Reinforced Subgrade/Subbase
This study documents field measurements from controlled test sections with in-ground piezoelectric earth pressure cells embedded above and below different polymer geosynthetic materials placed at the interface of soft clay subgrade and crushed limestone subbase. A control section with no geosynthetic layer was monitored for comparison. In-ground stresses were monitored during vibratory roller compaction and trafficking under a heavy loaded truck. One of the geogrids is a relatively new product for which there is less field performance data than the more traditional biaxial geogrids. Results from this study demonstrate better performance of the new geogrid test section compared to other test sections as verified using compaction and rut depth measurements. Improved performance is attributed to higher lateral restraint of the subbase layer and reduced horizontal stresses in the soft subgrade layer under loading.
- 11 March 2011
- Published by American Society of Civil Engineers (ASCE)
- p. 4663-4672
In-Ground Dynamic Stress Measurements for Geosynthetic Reinforced Subgrade/Subbase
This study documents field measurements from controlled test sections with in-ground piezoelectric earth pressure cells embedded above and below different polymer geosynthetic materials placed at the interface of soft clay subgrade and crushed limestone subbase. A control section with no geosynthetic layer was monitored for comparison. In-ground stresses were monitored during vibratory roller compaction and trafficking under a heavy loaded truck. One of the geogrids is a relatively new product for which there is less field performance data than the more traditional biaxial geogrids. Results from this study demonstrate better performance of the new geogrid test section compared to other test sections as verified using compaction and rut depth measurements. Improved performance is attributed to higher lateral restraint of the subbase layer and reduced horizontal stresses in the soft subgrade layer under loading.
- 10 March 2009
- Published by American Society of Civil Engineers (ASCE)
- p. 425-432
Influence of Support Conditions on Roller-Integrated Machine Drive Power Measurements for Granular Base
A controlled field study was conducted to evaluate the influence of underlying layer support conditions on roller-integrated machine drive power (MDP) measurements. Multiple layers of granular base material were placed over a section of wet/soft subgrade and a section of concrete base for comparison. The material was compacted in layers using a 12-ton vibratory padfoot roller. MDP and in-situ spot test measurements were obtained on each layer and the results were statistically analyzed. Results indicate that compaction layer MDP measurements are strongly dependent on stiffness and heterogeneity of the supporting layer. If relatively stable and homogenous support conditions exist, the effect is not statistically detectable. Although the compaction layer properties (as measured by in-situ test measurements) are relatively uniform, the MDP measurements tend to capture the variability of the underlying layers. Post-construction tests by carefully excavating the compaction layers showed significant improvement in stiffness of the granular base layers compared to the initial compaction layer measurements. The reason is attributed to possible densification of underlying layers during compaction of the layers above and an increase in lateral stresses during compaction.
- 10 March 2009
- Published by American Society of Civil Engineers (ASCE)
- p. 425-432
Influence of Support Conditions on Roller-Integrated Machine Drive Power Measurements for Granular Base
A controlled field study was conducted to evaluate the influence of underlying layer support conditions on roller-integrated machine drive power (MDP) measurements. Multiple layers of granular base material were placed over a section of wet/soft subgrade and a section of concrete base for comparison. The material was compacted in layers using a 12-ton vibratory padfoot roller. MDP and in-situ spot test measurements were obtained on each layer and the results were statistically analyzed. Results indicate that compaction layer MDP measurements are strongly dependent on stiffness and heterogeneity of the supporting layer. If relatively stable and homogenous support conditions exist, the effect is not statistically detectable. Although the compaction layer properties (as measured by in-situ test measurements) are relatively uniform, the MDP measurements tend to capture the variability of the underlying layers. Post-construction tests by carefully excavating the compaction layers showed significant improvement in stiffness of the granular base layers compared to the initial compaction layer measurements. The reason is attributed to possible densification of underlying layers during compaction of the layers above and an increase in lateral stresses during compaction.