Nesrin M. N. El Hadidi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Nesrin M. N. El Hadidi has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
Abdelrazek Elnaggar
Archeological Science and Excavation Department, Faculty of Archaeology, Ain Shams University, Cairo, Egypt. / Heritage Science Laboratory Ljubljana (HSLL), Faculty of Chemistry and Chemical Technology, University of Ljubljana, Ljubljana, Slovenia
1 shared publication- Abubakr Moussa
Conservation Department, Faculty of Archaeology, Cairo University, 12613 Orman - Giza - Egypt, Egypt
1 shared publication - Fatma Abdel Naby Ali
Food Hygiene and Control department, Faculty of Veterinary Medicine, Beni-Suef University, 62511 Beni-Suef, Egypt
1 shared publication Hassan Ebeid
Archeological Science and Excavation Department, Faculty of Archaeology, Ain Shams University, Cairo, Egypt. / Heritage Science Laboratory Ljubljana (HSLL), Faculty of Chemistry and Chemical Technology, University of Ljubljana, Ljubljana, Slovenia
1 shared publication- Mona Gawish
Conservation Center (organic lab), National Museum of Egyptian Civilization (NMEC), Cairo, Egypt
1 shared publication - Wadeea Botros Abdel-Malik
Ministry of Tourism and Antiquities,cairo
1 shared publication
Latest Publications
- Open Access
- 23 June 2023
- Published by Egyptian Knowledge Bank in Advanced Research in Conservation Science
- Vol. 4 (1) , 54-70
A Mamluk Copy of Fawaed El Mawaad: Investigation and Analytical Approach
A Mamluk paper manuscript copy entitled Fawaed El Mawaad in the Library of Ain-Shams University was examined, and several analytical techniques were employed to identify the materials used in its making, and to examine the manuscript's anatomy and sewing technique. Portable digital optical microscope, polarizing microscope, scanning electron microscope with EDX (SEM/EDX), Fourier transform infrared spectroscopy (FTIR), and Raman spectroscopy were among the investigation and analytical techniques employed. Microscopic investigation revealed that hemp fiber, which is shorter than flax fiber, yet looks similar to it, was used to produce paper hemp.It is distinguished by transverse knots, a thick, fibrous cell wall, and a smooth surface. This was supported by EDX results that revealed the presence of calcium, which is a main element in calcium oxalate commonly found in hemp and ramie but not flax. SEM images and FTIR-ATR indicated the use of starch as a sizing material and calcium carbonate as a filler. Raman spectroscopy and X-ray Fluorescence were used to determine the types of black and red ink; mixed ink (carbon and iron-gall), and vermilion (HgS) were identified, respectively. The ink type was further confirmed with technical photography using Infrared Fluorescence (IRF) and Ultraviolet Fluorescence (UVF).
- 23 June 2023
- Published by Egyptian Knowledge Bank in Advanced Research in Conservation Science
- Vol. 4 (1) , 54-70
Open AccessA Mamluk Copy of Fawaed El Mawaad: Investigation and Analytical Approach
A Mamluk paper manuscript copy entitled Fawaed El Mawaad in the Library of Ain-Shams University was examined, and several analytical techniques were employed to identify the materials used in its making, and to examine the manuscript's anatomy and sewing technique. Portable digital optical microscope, polarizing microscope, scanning electron microscope with EDX (SEM/EDX), Fourier transform infrared spectroscopy (FTIR), and Raman spectroscopy were among the investigation and analytical techniques employed. Microscopic investigation revealed that hemp fiber, which is shorter than flax fiber, yet looks similar to it, was used to produce paper hemp.It is distinguished by transverse knots, a thick, fibrous cell wall, and a smooth surface. This was supported by EDX results that revealed the presence of calcium, which is a main element in calcium oxalate commonly found in hemp and ramie but not flax. SEM images and FTIR-ATR indicated the use of starch as a sizing material and calcium carbonate as a filler. Raman spectroscopy and X-ray Fluorescence were used to determine the types of black and red ink; mixed ink (carbon and iron-gall), and vermilion (HgS) were identified, respectively. The ink type was further confirmed with technical photography using Infrared Fluorescence (IRF) and Ultraviolet Fluorescence (UVF).
- Open Access
- 1 January 2023
- Published by Egyptian Knowledge Bank in Shedet
- Vol. 10 (10) , 261-278
EXPERIMENTAL STUDY TO ASSESS ALTERNATIVE SUPPORTS FOR EXTENSIVELY DETERIORATED WOODEN ICONS
Experimental and analytical studies were carried out on five different types of alternative supports from processed wood; plywood, pine block board, oak block board, medium density fibre (MDF) and chipboard. Color changes and emitted gases were measured by Kitagawa gas test tubes, Oddy test and Raman spectroscopy. Results proved that slight amounts of formaldehyde, ammonia and acetic acid were emitted from block board samples. Oak block board emitted higher amounts of formaldehyde compared to pine block board, but the emission of ammonia and acetic acid was relatively similar in both types of block board. A higher quantity of acetic acid and ammonia, and a small amount of formaldehyde were emitted from plywood. There was an increase in formaldehyde, ammonia and acetic acid gas emission in MDF and chipboard. FTIR analysis of wood components and color change measurements were conducted for further evaluation. In plywood a high decrease of lignin was noted, causing the wood to lighten in color. The rise of formaldehyde in oak block board, MDF and chipboard led to decrease in carbohydrates, causing darkening of wood color. Chemical composition and color change measurements were stable in the pine block board, proving it to be the most suitable alternative support.
- 1 January 2023
- Published by Egyptian Knowledge Bank in Shedet
- Vol. 10 (10) , 261-278
Open AccessEXPERIMENTAL STUDY TO ASSESS ALTERNATIVE SUPPORTS FOR EXTENSIVELY DETERIORATED WOODEN ICONS
Experimental and analytical studies were carried out on five different types of alternative supports from processed wood; plywood, pine block board, oak block board, medium density fibre (MDF) and chipboard. Color changes and emitted gases were measured by Kitagawa gas test tubes, Oddy test and Raman spectroscopy. Results proved that slight amounts of formaldehyde, ammonia and acetic acid were emitted from block board samples. Oak block board emitted higher amounts of formaldehyde compared to pine block board, but the emission of ammonia and acetic acid was relatively similar in both types of block board. A higher quantity of acetic acid and ammonia, and a small amount of formaldehyde were emitted from plywood. There was an increase in formaldehyde, ammonia and acetic acid gas emission in MDF and chipboard. FTIR analysis of wood components and color change measurements were conducted for further evaluation. In plywood a high decrease of lignin was noted, causing the wood to lighten in color. The rise of formaldehyde in oak block board, MDF and chipboard led to decrease in carbohydrates, causing darkening of wood color. Chemical composition and color change measurements were stable in the pine block board, proving it to be the most suitable alternative support.
- 21 March 2016
- Published by Maney Publishing in Studies in Conservation
- Vol. 62 (2) , 83-95
Decay of softwood in archaeological wooden artifacts
Hardwoods and softwoods were used side by side throughout Egyptian history, and importing softwoods that had an attractive color and texture was common. Over the decades, artifacts based on hardwoods and softwoods underwent deterioration phenomena, sometimes reaching either a level of brittleness or turning into a wood powder that may easily crumble. These levels of decay/degradation are often difficult to handle in terms of conservation treatments. To study or identify the reasons for decay has always been a point of interest for conservation purposes, but to assess decay and choose an appropriate treatment according to the state of preservation for the sake of keeping an artifact intact has become a subject of major importance. It is difficult at times to understand the deterioration process, because hardwoods and softwoods are different in structure, properties, and chemical composition. For this preliminary study, decayed samples from three commonly used softwood types, cypress (Cupressus sp.), cedar (Cedrus sp.), and pine (Pinus sp.), were identified and chosen. Scanning electron microscopy (SEM) of the samples indicated the degree of decay. Decayed and non-aged samples of the same wood type were analyzed using Fourier transform infrared spectroscopy (FTIR), and all the major carbohydrate and lignin bands were recorded. The strong hydrogen bonded (O–H) stretching absorption associated with water linked by hydrogen bonds to the –OH groups of cellulose and hemicelluloses in all decayed samples increased with decay. The brown powdery, fragile samples that had been evidently affected by microbial decay had a higher amount of lignin. The lignin/carbohydrate ratio was calculated and results compared. The increase of either lignin percentage or extractives in some of the samples had caused a darkening of color in both cypress and cedar samples, but the pine sample did not have the same texture and appearance. In cases where the lignin percentage decreased the samples had changed to a slightly lighter color. FTIR results explained the decay phenomena observed in SEM micrographs and helped assess wood decay and also confirmed results that had been previously obtained while applying traditional chemical analysis on wood.
- 21 March 2016
- Published by Maney Publishing in Studies in Conservation
- Vol. 62 (2) , 83-95
Decay of softwood in archaeological wooden artifacts
Hardwoods and softwoods were used side by side throughout Egyptian history, and importing softwoods that had an attractive color and texture was common. Over the decades, artifacts based on hardwoods and softwoods underwent deterioration phenomena, sometimes reaching either a level of brittleness or turning into a wood powder that may easily crumble. These levels of decay/degradation are often difficult to handle in terms of conservation treatments. To study or identify the reasons for decay has always been a point of interest for conservation purposes, but to assess decay and choose an appropriate treatment according to the state of preservation for the sake of keeping an artifact intact has become a subject of major importance. It is difficult at times to understand the deterioration process, because hardwoods and softwoods are different in structure, properties, and chemical composition. For this preliminary study, decayed samples from three commonly used softwood types, cypress (Cupressus sp.), cedar (Cedrus sp.), and pine (Pinus sp.), were identified and chosen. Scanning electron microscopy (SEM) of the samples indicated the degree of decay. Decayed and non-aged samples of the same wood type were analyzed using Fourier transform infrared spectroscopy (FTIR), and all the major carbohydrate and lignin bands were recorded. The strong hydrogen bonded (O–H) stretching absorption associated with water linked by hydrogen bonds to the –OH groups of cellulose and hemicelluloses in all decayed samples increased with decay. The brown powdery, fragile samples that had been evidently affected by microbial decay had a higher amount of lignin. The lignin/carbohydrate ratio was calculated and results compared. The increase of either lignin percentage or extractives in some of the samples had caused a darkening of color in both cypress and cedar samples, but the pine sample did not have the same texture and appearance. In cases where the lignin percentage decreased the samples had changed to a slightly lighter color. FTIR results explained the decay phenomena observed in SEM micrographs and helped assess wood decay and also confirmed results that had been previously obtained while applying traditional chemical analysis on wood.