Cyril Jadaud
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Cyril Jadaud has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Erik V. Johnson
Laboratoire de Physique des Interfaces et des Couches Minces-CNRS, Ecole Polytechnique, 91128 Palaiseau, France
2 shared publications - Pere Roca i Cabarrocas
LPICM, CNRS, Ecole Polytechnique, Institut Polytechnique de Paris, route de Saclay, Palaiseau 91128, France
2 shared publications Dominique Muller
Laboratoire ICube, Université de Strasbourg et CNRS, 23 rue du Loess, 67037 Strasbourg Cedex 2, France
1 shared publicationFrançois Silva
LPICM, CNRS, École Polytechnique, Institut Polytechnique de Paris, route de Saclay, 91120 Palaiseau, France
1 shared publication- François Silva
LPICM, CNRS, Ecole polytechnique, Institut polytechnique de Paris 1 91120 Palaiseau France
1 shared publication - Jean Luc Maurice
Laboratoire de physique des interfaces et couches minces
1 shared publication
Latest Publications
- 13 May 2024
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 57 (31) , 315106
Direct growth of highly oriented GaN thin films on silicon by remote plasma CVD
We report on low-temperature (500 °C) and low-pressure (0.3 mbar) direct growth of GaN thin films on silicon (100) substrates using remote plasma chemical vapour deposition (RP-CVD). In the custom-designed reactor, an RF inductively coupled plasma is generated remotely from the substrate’s area to facilitate the decomposition of group-V precursor, N2 with added H2, while group-III precursor trimethylgallium (TMGa), is directly injected into the growth chamber mixed with H2 carrier gas. Growth parameters such as RF power, process pressure and gas flow rates have been optimized to achieve a film growth rate of about 0.6 µm h−1. Several characterization techniques were used to investigate the plasma and the properties of the grown thin films in terms of their crystallinity, morphology, topography, and composition. The films are highly textured with a preferential orientation along the c-axis of the wurtzite structure. They present a small roughness in the nanometer range and a columnar microstructure with a grain size of one hundred nanometer, and a gallium polarity (+c plane oriented). Rutherford backscattering spectrometry and nuclear reaction analysis show that the chemical composition is homogeneous through the depth of the layer, with a III/V ratio close to 1, a very low content of oxygen (below the detection limit ∼1%) and a carbon content up to 11%. It was shown that the increase of plasma power helps to reduce this carbon contamination down to 8%. This research paves the way for a growth method compatible with cost reduction of III–V thin film production achieved through reduced gas consumption facilitated by RP-CVD operation at low pressure.
- 13 May 2024
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 57 (31) , 315106
Direct growth of highly oriented GaN thin films on silicon by remote plasma CVD
We report on low-temperature (500 °C) and low-pressure (0.3 mbar) direct growth of GaN thin films on silicon (100) substrates using remote plasma chemical vapour deposition (RP-CVD). In the custom-designed reactor, an RF inductively coupled plasma is generated remotely from the substrate’s area to facilitate the decomposition of group-V precursor, N2 with added H2, while group-III precursor trimethylgallium (TMGa), is directly injected into the growth chamber mixed with H2 carrier gas. Growth parameters such as RF power, process pressure and gas flow rates have been optimized to achieve a film growth rate of about 0.6 µm h−1. Several characterization techniques were used to investigate the plasma and the properties of the grown thin films in terms of their crystallinity, morphology, topography, and composition. The films are highly textured with a preferential orientation along the c-axis of the wurtzite structure. They present a small roughness in the nanometer range and a columnar microstructure with a grain size of one hundred nanometer, and a gallium polarity (+c plane oriented). Rutherford backscattering spectrometry and nuclear reaction analysis show that the chemical composition is homogeneous through the depth of the layer, with a III/V ratio close to 1, a very low content of oxygen (below the detection limit ∼1%) and a carbon content up to 11%. It was shown that the increase of plasma power helps to reduce this carbon contamination down to 8%. This research paves the way for a growth method compatible with cost reduction of III–V thin film production achieved through reduced gas consumption facilitated by RP-CVD operation at low pressure.
- Open Access
- 14 July 2023
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 41 (5)
Reactive plasma sputtering deposition of polycrystalline GaN thin films on silicon substrates at room temperature
We report on the successful growth of polycrystalline GaN thin films on Si (100) substrates at room temperature (without intentional heating) using radiofrequency reactive magnetron sputtering. We use Ar and N2 as the main sputtering and N-atom precursor gas sources, respectively, and a gallium cathode as the Ga-atom source. We focus here on studying the effect of working pressure, as it is found to be the parameter that plays the most influential role on the crystalline quality of the thin films in the investigated range (20–95 mTorr). The morphology, microstructure, and composition profile of the GaN thin films are analyzed using a set of ex situ solid-state characterization techniques. This study reveals that for process pressures below 50 mTorr, the resulting films possess an amorphous nature, while for process pressures above that they become polycrystalline. Most of the crystalline films are found to be nanostructured with grain sizes typically ranging from 10 to 30 nm in size. The highest growth rate of ∼ 2.9 Å/s is obtained for the deposition carried out at 50 mTorr. At this pressure, the films exhibit the best crystallinity with a dominant wurtzite hexagonal structure. The elemental distribution of Ga and N throughout the growth profile is uniform with a sharp interface at the substrate, demonstrating one of the interests in working at low temperatures to avoid melt-back etching, a destructive reaction between gallium and silicon, that usually takes place at high temperatures.
- 14 July 2023
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 41 (5)
Open AccessReactive plasma sputtering deposition of polycrystalline GaN thin films on silicon substrates at room temperature
We report on the successful growth of polycrystalline GaN thin films on Si (100) substrates at room temperature (without intentional heating) using radiofrequency reactive magnetron sputtering. We use Ar and N2 as the main sputtering and N-atom precursor gas sources, respectively, and a gallium cathode as the Ga-atom source. We focus here on studying the effect of working pressure, as it is found to be the parameter that plays the most influential role on the crystalline quality of the thin films in the investigated range (20–95 mTorr). The morphology, microstructure, and composition profile of the GaN thin films are analyzed using a set of ex situ solid-state characterization techniques. This study reveals that for process pressures below 50 mTorr, the resulting films possess an amorphous nature, while for process pressures above that they become polycrystalline. Most of the crystalline films are found to be nanostructured with grain sizes typically ranging from 10 to 30 nm in size. The highest growth rate of ∼ 2.9 Å/s is obtained for the deposition carried out at 50 mTorr. At this pressure, the films exhibit the best crystallinity with a dominant wurtzite hexagonal structure. The elemental distribution of Ga and N throughout the growth profile is uniform with a sharp interface at the substrate, demonstrating one of the interests in working at low temperatures to avoid melt-back etching, a destructive reaction between gallium and silicon, that usually takes place at high temperatures.