DSDarryl Shima

Darryl Shima

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Darryl Shima has a total of 45 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Quantum Hall Effect in Stoichiometry‐Engineered β‐Ag2Te

    by Mizuki Ohno, Veronica Show, Reiley Dorrian, Darryl Shima, Ganesh Balakrishnan, Joseph Falson

    Accessing surface quantum transport in topological insulators is hampered by residual bulk conduction arising from lattice defects. Here, we demonstrate a novel synthesis pathway for realizing high‐mobility ‐ thin films in which surface transport is dominant. An in situ room‐temperature Te treatment modifies the film stoichiometry, enabling continuous tuning of the sheet carrier density over more than an order of magnitude through the charge‐neutrality point without an external gate electrode. In the lower‐carrier‐density films, a fully developed quantum Hall state is observed, and Landau‐level energies extracted across samples collapse onto the relation, providing evidence for the massless Dirac dispersion of the top and bottom surface states. These results establish stoichiometry engineering as a lithography‐ and gate‐free approach to accessing quantum Hall transport in epitaxial topological‐insulator thin films.

  • Polarity effects on the growth of Si-doped AlGaN epilayers on AlN

    by H. Alwan, T. Njuguna, D. Shima, G. Balakrishnan, J. Li, J. Y. Lin, H. X. Jiang

    We investigate the polarity dependent properties of Si-doped n-type AlGaN epilayers grown via metal organic chemical vapor deposition on Al- and N-polar AlN bulk substrates. While X-ray diffraction confirmed comparable crystalline quality for both polarities, photoluminescence spectroscopy revealed distinct optical signatures, suggesting varying levels of defect complexes involving aluminum vacancies and oxygen impurities. Electrical characterization via Hall-effect measurements showed a sharp contrast in transport properties. The N-polar epilayer exhibited a slight reduction in free electron concentration, but a significant decrease in electron mobility by over an order of magnitude compared to the Al-polar epilayer. Microstructural analysis through scanning transmission electron microscopy and energy-dispersive spectroscopy identified polarity-specific features at the AlGaN/AlN interface including increased lattice distortion and the presence of localized oxygen impurities in the N-polar samples, despite uniform Al and Ga distribution. These findings highlight substrate polarity as a key factor influencing the overall material quality and the performance of AlGaN-based devices, offering useful insights for optimizing n-type conductivity in polarity-engineered applications such as AlN and AlGaN-based vertical p-n diodes, vertical photoconductive semiconductor switch devices, and high electron mobility transistors.

  • Open Access

    Unintentional doping and native defects in the AlGaAsSb barrier of nBn photodetectors and their effect on detector dark current

    by A. T. Newell, R. A. Carrasco, J. V. Logan, C. P. Hains, D. Shima, G. Balakrishnan, D. Maestas, C. P. Morath, P. T. Webster

    The unintentional p-type doping concentration in the AlGaAsSb barrier of typical mid-wave infrared nBn detectors is predicted by TCAD simulations to generate substantial depletion volume, and consequently, depletion current magnitudes exceeding the diffusion current component. However, diffusion-limited performance of conventional, barrier-on-absorber nBn detectors is routinely achieved. In contrast, investigation into an inverted, absorber-on-barrier nBn structure reveals depletion currents in line with TCAD expectations. To further investigate this phenomenon, devices from an ostensibly fully symmetric nBn structure with equal absorber thicknesses on either side of the barrier are grown, fabricated, and characterized with dark current and capacitance measurements to probe both volumes from the same device. The symmetric nBn, when biased such that carrier collection occurs across the barrier-on-absorber interface (as is the case in the conventional device structure), exhibits diffusion-limited dark current. Similarly, when biased such that carrier collection occurs across the absorber-on-barrier interface (as is the case in the inverted device structure), the device exhibits depletion-limited dark current. Capacitance voltage profiles provide experimental validation of the equivalent doping of each absorber volume; however, a peak capacitance occurring at negative bias similarly reflects the asymmetry in the structure. Secondary ion mass spectrometry and scanning transmission electron microscopy are used to investigate the physical origins of this barrier asymmetry, in which a high O concentration is found at the upper barrier interface while a layer of AlAs-like material is seen at the bottom interface. The implementation of these interface defects into TCAD simulations enables accurate modeling of the observed electrical behavior.


  • Impact of graded doping transition layer on structural properties of Zr-doped AlN epilayers

    by H. Alwan, D. Shima, G. Balakrishnan, J. Li, J. Y. Lin, H. X. Jiang

    Zirconium doped AlN (AlN:Zr) epilayers hold significant promise for advanced electronic and quantum applications, including photoconductive semiconductor switches for high-voltage and high-power operations as well as quantum qubit and sensing technologies. Despite its potential, producing crack-free and high-quality AlN:Zr epilayers with high Zr concentrations has been challenging. The main obstacle is the significant atomic size difference between Zr and Al, which introduces a substantial lattice mismatch between the AlN:Zr epilayer and the AlN bulk substrate. This study investigates the impact of graded doping transition layer on structural and compositional properties of AlN:Zr by employing in situ doping using metal-organic chemical vapor deposition growth technique. Structural and compositional properties were analyzed in detail using x-ray diffraction (XRD), transmission electron microscopy, and energy dispersive spectroscopy. The implementation of the graded transition layer led to significant structural improvements, including reduced XRD linewidth, decreased threading dislocations, and lower concentrations of Al vacancies, and enabled the realization of a crack-free AlN:Zr epilayer with a high Zr doping concentration of 8.2 × 1020 cm−3. These results demonstrate the effectiveness of the graded transition layer in producing high-quality AlN:Zr layers.


  • Nonselective, material-independent, precision plasma delayering of metals and dielectrics

    by Joseph Iannello, Leonid Miroshnik, Darryl Shima, Angelica Benavidez, Sang M. Han, Tyler Eugene Stevens, Jessica Duree, Randy Shul, Craig Y. Nakakura

    Nonselective, high-precision, plasma-assisted delayering provides a robust means for failure analysis of heterogeneously integrated devices. While chemical mechanical planarization is often used to planarize different materials exposed on the wafer surface, deleterious defects, such as gouging and corrosion, can impact die yield and device performance. To circumvent these issues, in this work, we demonstrate a material-independent, nonselective plasma delayering technique. The etch rate is uniform over the area of interest, requiring only a single dry etching chamber. Ar, CF4, and O2, commonly used in high-volume microchip fabrication, are selected as etchants of W, Ti, and SiO2. These materials are chosen as representative examples of metals and dielectrics found in CMOS devices. We use methyl acetate as an etch retardant to reduce and eventually halt the etching process. The relative methyl acetate mass flow rate provides precise control of the etching of both metals and dielectrics, defining a process window in which all three etch rates begin to converge. Depending on the process need, such as planarizing highly corrugated surface, the uniform etching can also be modified to become more material-dependent and selective to provide precision delayering and achieve a planarized surface.

  • Tracing degradation mechanisms of epitaxially grown GaAsSb on InP by InSb formation at elevated temperatures

    by Leonid Miroshnik, Brian D. Rummel, Darryl M. Shima, Andrew Li, Ganesh Balakrishnan, Talid Sinno, Sang M. Han

    The thermal stability of GaAsSb/InP is known to be compromised by group-V volatility and intermixing at the heterojunction that adversely impact the performance of subsequently fabricated optoelectronic or high-speed devices. We interrogate the GaAsSb/InP interface and trace its degradation during extended annealing, where we observe significant intermixing and nanostructure formation. Scanning transmission electron microscopy reveals the formation of pyramidal nanostructures that extend from the epitaxial layer into the substrate. Energy-dispersive x-ray spectroscopy and geometric phase analysis show migration of Sb from the GaAsSb epilayer to the InP substrate and migration of P from the InP substrate to the epilayer. The pronounced migration of Sb and P leads to the formation of InSb-rich facets and tips of the pyramidal nanostructures. The interdiffusion also leads to InGaAsP replacing the epitaxial GaAsSb. These results are consistent with bulk characterization by high-resolution x-ray diffraction and Raman spectroscopy. The intermixing appears to be driven by simultaneous phase separation and melting of InSb that enhances atomic mobility, providing an alternative mechanism to previously proposed phase separation by spinodal decomposition.

  • Interband cascade light-emitting diodes grown on silicon substrates using GaSb buffer layer

    by Fatih F. Ince, Mega Frost, Darryl Shima, Thomas J. Rotter, Sadhvikas Addamane, Martha R. McCartney, David J. Smith, Chadwick L. Canedy, Stephanie Tomasulo, Chul Soo Kim, et al.

    Interband cascade light-emitting diodes (ICLEDs) offer attractive advantages for infrared applications, which would greatly expand if high-quality growth on silicon substrates could be achieved. This work describes the formation of threading dislocations in ICLEDs grown monolithically on GaSb-on-Silicon wafers. The epitaxial growth is done in two stages: the GaSb-on-Silicon buffer is grown first, followed by the ICLED growth. The buffer growth involves the nucleation of a 10-nm-thick AlSb buffer layer on the silicon surface, followed by the GaSb growth. The AlSb nucleation layer promotes the formation of 90° and 60° interfacial misfit dislocations, resulting in a highly planar morphology for subsequent GaSb growth that is almost 100% relaxed. The resulting GaSb buffer for growth of the ICLED has a threading dislocation density of ∼107/cm2 after ∼3 μm of growth. The fabricated LEDs showed variations in device performance, with some devices demonstrating comparable light–current–voltage curves to those for devices grown on GaSb substrates, while other devices showed somewhat reduced relative performance. Cross-sectional transmission electron microscopy observations of the inferior diodes indicated that the multiplication of threading dislocations in the active region had most likely caused the increased leakage current and lower output power. Enhanced defect filter layers on the GaSb/Si substrates should provide more consistent diode performance and a viable future growth approach for antimonide-based ICLEDs and other infrared devices.


  • Open Access

    Development of “GaSb-on-silicon” metamorphic substrates for optoelectronic device growth

    by Fatih F. Ince, Mega Frost, Darryl Shima, Thomas J. Rotter, Sadhvikas Addamane, Chadwick L. Canedy, Stephanie Tomasulo, Chul Soo Kim, William W. Bewley, Igor Vurgaftman, et al.

    The epitaxial development and characterization of metamorphic “GaSb-on-silicon” buffers as substrates for antimonide devices is presented. The approach involves the growth of a spontaneously and fully relaxed GaSb metamorphic buffer in a primary epitaxial reactor, and use of the resulting “GaSb-on-silicon” wafer to grow subsequent layers in a secondary epitaxial reactor. The buffer growth involves four steps—silicon substrate preparation for oxide removal, nucleation of AlSb on silicon, growth of the GaSb buffer, and finally capping of the buffer to prevent oxidation. This approach on miscut silicon substrates leads to a buffer with negligible antiphase domain density. The growth of this buffer is based on inducing interfacial misfit dislocations between an AlSb nucleation layer and the underlying silicon substrate, which results in a fully relaxed GaSb buffer. A 1 μm thick GaSb layer buffer grown on silicon has ∼9.2 × 107dislocations/cm2. The complete lack of strain in the epitaxial structure allows subsequent growths to be accurately lattice matched, thus making the approach ideal for use as a substrate. We characterize the GaSb-on-silicon wafer using high-resolution x-ray diffraction and transmission electron microscopy. The concept’s feasibility is demonstrated by growing interband cascade light emitting devices on the GaSb-on-silicon wafer. The performance of the resulting LEDs on silicon approaches that of counterparts grown lattice matched on GaSb.


  • Open Access

    MBE growth of In0.53Ga0.47Sb on In0.53Ga0.47As/InP substrates using the interfacial misfit dislocation arrays

    by Fatih F. Ince, Mega Frost, Subhashree Seth, Darryl Shima, Thomas J. Rotter, Ganesh Balakrishnan

    We present the growth of highly relaxed In0.53Ga0.47Sb buffers on In0.53Ga0.47As/InP by inducing a periodic array of interfacial misfit dislocation arrays at the In0.53Ga0.47Sb/ In0.53Ga0.47As interface. The periodic 90° misfit dislocation array is realized through As for Sb anion exchange while keeping the group III sublattice the same. Transmission electron microscopy (TEM) results show the presence of misfit dislocations with a periodicity of 6.16 nm, which corresponds to 14 In0.53Ga0.47Sb lattice sites or 15 In0.53Ga0.47As lattice sites. The In0.53Ga0.47Sb epilayer, however, is affected by phase segregation as evidenced by both TEM and Nomarski optical phase microscopy. The x ray based reciprocal space mapping indicates relaxation to be 99.5% for the In0.53Ga0.47Sb epilayer.