AIAlexander Ilyinsky

Alexander Ilyinsky

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Alexander Ilyinsky has a total of 10 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Load-Dependent Instrumented Indentation Test and Local Micromechanical Response near a Pore in Additively Manufactured IN718

    by Kirill Doronin, Alexander Ilyinsky, Aleksandr Umanskii, Artem Kondratev

    In this work, the load-dependent indentation response of as-built Inconel 718 produced by direct laser deposition was studied, followed by local mapping around a single surface-intersecting pore. A working load of 100 mN was selected because the indentation modulus approached a depth-independent plateau and the penetration depth was substantially larger than the measured surface roughness. At this load, the reference matrix response was HIT = 2.69 ± 0.26 GPa and EIT = 160 ± 11 GPa. An equivalent contact radius ac was calculated from the projected contact area, and pore-edge distance was normalized as ξ = s/ac. For the reference response, ac ≈ 3.44 µm and the first numerically defined position at s = 20 µm corresponded to ξ ≈ 5.8. Robust regression of 56 individual measurements showed no statistically resolved dependence of EIT on ξ, whereas a small negative HIT slope was observed and interpreted cautiously because of directional variability. The analysis is restricted to this single pore and to ξ ≥ 5.8; the immediate pore-edge regime was not experimentally resolved. The contact-scale normalization provides a reproducible framework for interpreting local indentation data near a geometrical defect without treating the two-dimensional pore-area fraction as bulk porosity.

  • Composite Material Mechanical Properties Evaluation Using a Dynamic Indentation Method

    by Кашапова, Irina Kashapova, Ильинский, Aleksandr Ilinskiy, Степанова, Kseniya Stepanova, Протасеня, Tatyana Pratasenia

    Introduction. Dynamic indentation method is considered promising in testing mechanical properties of composite materials. Today, composite materials are widely used in the aviation and aerospace industries. That’s why, testing of mechanical properties of composite materials is so vital. Method. To register the current velocity of the indenter penetration into the tested composite material, use is made of a device that enables a contactless measurement of the indenter penetration velocity after the indenter strikes the tested product. The data obtained is digitized and sent to a PC for further processing. Results. The experiment produced "contact force – penetration depth" diagrams for three test zones in the prepared samples. The analysis showed that the non-uniformity of mechanical properties in the rod’s butt end and side surface is stipulated by pores and microcracks, and this is confirmed by computer tomography. It is shown that dilaminations, microcracks and local non-uniformity zones in the structure tell on the elasticity modulus measurements. Conclusions. The dynamic indentation method allows one to test composites at the micro- and macrostructural level, as well as compute their integral mechanical properties.